IPM

Baculovimses, especially nuclear polyhedrosis viruses (NPV) and granulosis viruses (GV), appear to be exceptionally well suited for IPM because of their extreme insect specificity. They are stomach poisons and are slow-acting. In vitro production is difficult and the products are more expensive than the bacterial insecticides. Their high host specificity is viewed as a commercial disadvantage, and improvements in formulations and appHcation techniques are needed. 

Fig. 4. Typical design elements foi wet deagglomeiation in low viscosity systems (a) a high, ipm lotoi (shown below its normal position within stator) produces turbulence and cavitation as blades pass each other (b) a rotating disk creates a deep vortex to rapidly refresh the surface, and up- and downtumed teeth at the edge cause impact, turbulence, and sometimes cavitation and (c) the clearance of a high rpm rotor can be reduced as the batch...

HIC Berendsen, IPM Postma, WE van Gunsteren, A DiNola, IR Haak. I Chem Phys 81 3684-3690, 1984. 

The manifold of functions ipm agrees with the manifold of product functions fam a he expansion (7-35) is safe. 

Top width Ipm] Bottom width Ipm] Depth [mm] Hydraulic diameter dh [pm] Length L [mm] L/A Gases tested... 

Solution For this scaleup, 5 = 1. Substitute this, the desired value for S, Pout)i = (Pout)2 = and the experimental observation for iPm) into Equation (3.38). Solve for (Pi )2 and substitute into Equation (3.39) to calculate Sl- Some results are shown in Table 3.1. 

Solution The approach is similar to that in Example 3.7. The unknowns are Sl and (Em)2. Set (Poudi = (Pout) - Equation (3.40) is used to calculate iPm)2 nd Equation (3.41) is used to calculate Sl- Results are given in Table 3.2. The results are qualitatively similar to those for the turbulent flow of a gas, but the scaled reactors are longer and the pressure drops are lower. In both cases, the reader should recall that the ideal gas law was assumed. This may become unrealistic for higher pressures. In Table 3.2 we make the additional assumption of laminar flow in both the large and small reactors. This assumption will be violated if the scaleup factor is large. 

A large variety of drug delivery systems are described in the literature, such as liposomes (Torchilin, 2006), micro and nanoparticles (Kumar, 2000), polymeric micelles (Torchilin, 2006), nanocrystals (Muller et al., 2011), among others. Microparticles are usually classified as microcapsules or microspheres (Figure 8). Microspheres are matrix spherical microparticles where the drug may be located on the surface or dissolved into the matrix. Microcapsules are characterized as spherical particles more than Ipm containing a core substance (aqueous or lipid), normally lipid, and are used to deliver poor soluble molecules... 

However, these techniques may not detect important phenomena taking place on the surface of or within the interior of individual Inm-to Ipm-diameter inorganic particles that are s3rnthesized specifically for their catalytic activity. AEM is an extremely useful technique for analysis of the individual heterogeneous catalyst particle and its relationship to various supporting materials. Structural and chemical analyses can be obtained from specimen regions nearly 1000 times smaller than those studied by conventional bulk analysis techniques. This high lateral spatial... 

---