Ionization potential first, second

Covalent radius (tetrahedral) Ionic radii Resistivity Electronegativity Ionization potentials First Second Third Fourth... 

Elemental boron has a diverse and complex chemistry, primarily influenced by three circumstances. Eirst, boron has a high ionization energy, 8.296 eV, 23.98 eV, and 37.75 eV for first, second, and third ionization potentials, respectively. Second, boron has a small size. Third, the electronegativities of boron (2.0), carbon (2.5), and hydrogen (2.1) are all very similar resulting in extensive and unusual covalent chemistry. 

We can compare this result with the experimental first and second ionization potentials (IPs) for helium... 

If we compare the calculated total ionization potential, IP = 4.00 hartiees, with the experimental value, IP = 2.904 hartiees, the result is quite poor. The magnitude of the disaster is even more obvious if we subtract the known second ionization potential, IP2 = 2.00, from the total IP to find t c first ionization potential, IPi. The calculated value of IP2, the second step in reaction (8-21) is IP2 = Z /2 = 2.00, which is an exact result because the second ionization is a one-election problem. For the first step in reaction (8-21), IPi (calculated) = 2.00 and IPi(experimental) = 2.904 — 2.000 =. 904 hartiees, so the calculation is more than 100% in error. Clearly, we cannot ignore interelectronic repulsion. 

Ultraviolet photoelectron spectroscopy allows the determination of ionization potentials. For thiazole the first experimental measurement using this technique was preformed by Salmona et al. (189) who later studied various alkyl and functional derivatives in the 2-position (190,191). Substitution of an hydrogen atom by an alkyl group destabilizes the first ionization potential, the perturbation being constant for tso-propyl and heavier substituents. Introduction in the 2-position of an amino group strongly destabilizes the first band and only slightly the second. 

Mass spectrometry can be used to determine ionization potentials by the method of Lossing (283). The values obtained can be compared with those found by photoelectron spectroscopy and those calculated by CNDO/S (134) or ab initio (131) methods using the Koopman theorem approximation. The first and second, ionization potentials concern a ir... 

The original paper defining the Gaussian-2 method by Curtiss, Raghavachari, Trucks and Pople tested the method s effectiveness by comparing its results to experimental thermochemical data for a set of 125 calculations 55 atomization energies, 38 ionization potentials, 25 electron affinities and 7 proton affinities. All compounds included only first and second-row heavy atoms. The specific calculations chosen were selected because of the availability of high accuracy experimental values for these thermochemical quantities. 

Although alkyl groups in general increase the rates of electrophilic addition, we have already mentioned (p. 974) that there is a different pattern depending on whether the intermediate is a bridged ion or an open carbocation. For brominations and other electrophilic additions in which the first step of the mechanism is rate determining, the rates for substituted alkenes correlate well with the ionization potentials of the alkenes, which means that steric effects are not important. Where the second step is rate determining [e.g., oxymercuration (15-3), hydroboration (15-17)], steric effects are important. ... 

The spectra and calculations all led to the conclusion that there is an usually large interaction between both the 7T and lone-pair orbitals in the carbonyl portion of the molecule with the n and a orbitals of the olefin portion. The first ionization potential (9.57 eV) involves ionization of an electron from the oxygen lone pair, whereas the second (11.19 eV) involves ionization of an electron from the olefin rr-bond. The most vertical ionization is from the 7 ax MO (16.11 eV), the second lone-pair orbital on oxygen. 

Nucleophilic Trapping of Radical Cations. To investigate some of the properties of Mh radical cations these intermediates have been generated in two one-electron oxidant systems. The first contains iodine as oxidant and pyridine as nucleophile and solvent (8-10), while the second contains Mn(0Ac) in acetic acid (10,11). Studies with a number of PAH indicate that the formation of pyridinium-PAH or acetoxy-PAH by one-electron oxidation with Mn(0Ac)3 or iodine, respectively, is related to the ionization potential (IP) of the PAH. For PAH with relatively high IP, such as phenanthrene, chrysene, 5-methyl chrysene and dibenz[a,h]anthracene, no reaction occurs with these two oxidant systems. Another important factor influencing the specific reactivity of PAH radical cations with nucleophiles is localization of the positive charge at one or a few carbon atoms in the radical cation. 

When a graph is made of log fCj versus the sum of the first and second ionization potentials for the metals, the result is shown in Figure 19.5. Clearly, the relationship is linear for the metal ions except Zn2+, for which the complex is considerably less stable than that with Cu2+. These results are in accord with the Irving-Williams series described earlier. The graph obtained when log K2 is plotted against the total ionization potential has exactly the same characteristics, as is shown in Figure 19.6. 

Element First ionization potential (kJ mol Second ionization potential (kJ mol Third ionization potential (kJ mol ... 

Ionization Potential (IP), Electron Affinity (EA), Maximal Charge Acceptance ANmax, and Electrophilicity Index Ground State for the First and Second Row Atoms (Units in eV)... 

Energy Levels for Hole Injection. For the hole conductor TPD (6), measurements are available from different groups that allow a direct comparison of different experimental setups. The ionization potential that corresponds to the HOMO level under the assumptions mentioned above was measured by photoelectron spectroscopy to be 5.34 eV [230]. Anderson et al. [231] identified the onset of the photoelectron spectrum with the ionization potential and the first peak with the HOMO energy, and reported separate values of 5.38 and 5.73 eV, respectively. The cyclovoltammetric data reveal a first oxidation wave at 0.34 V vs. Fc/Fc+ in acetonitrile [232], and 0.48 V vs. Ag/0.01 Ag+ in dichloro-methane [102], respectively. The oxidation proceeds by two successive one-electron oxidations, the second one being located at 0.47 V vs. Fc/Fc+. 

---