Ion-Exchanger Powder

Nation 117 solution (Nation perfluorinated ion-exchange powder 5% mixture of lower aliphatic alcohols and 10% water d 0.874) Aldrich Chemical Co., Catalog No. 27,470-4 800-558-9160... 

The cobalt supported zeolite catalyst was prepared by ion exchange. Powdered zeolite A was slurried in distilled water, and an aqueous solution of Co(N0j)2.6H20 was added dropwise over a period of five hours with stirring and gentle heating. The saiple was then filtered and air dried at room temperature. 

Cellulose ion-exchanger powders have been used for column-chromatographic separation of proteins, enzymes and numerous other biochemically interesting materials, since the fundamental work of Peterson and Sober [516] in 1956. Ion exchangers in a form suitable for TLC have been available for some years also. The types commercially available at present are listed in Table 9. 

Suspension Polymerization. Suspension polymerisation yields polymer in the form of tiny beads, which ate primarily used as mol ding powders and ion-exchange resins. Most suspension polymers prepared as mol ding powders are poly(methyl methacrylate) copolymers containing up to 20% acrylate for reduced btittieness and improved processibiUty are also common. 

Bromelain (anti-inflammatory Ananase from pineapple) [37189-34-7] Mr 33 000, [EC 3.4.33.4]. This protease has been purified via the acetone powder, G-75 Sephadex gel filtration and Bio-Rex 70 ion-exchange chromatography and has Aj 20.1 at 280nm. The protease from pineapple hydrolyses benzoyl glycine ethyl ester with a Km (app) of 210mM and kcat of 0.36 sec. [Murachi Methods Enzymol 19 273 1970 Balls et al. nd Eng Chem 33 950 1941.]... 

Phospholipids. For the removal of ionic contaminants from raw zwitterionic phospholipids, most lipids were purified twice by mixed-bed ionic exchange (Amberlite AB-2) of methanolic solutions. (About Ig of lipid in lOmL of MeOH). With both runs the first ImL of the eluate was discarded. The main fraction of the solution was evaporated at 40°C under dry N2 and recryst three times from n-pentane. The resulting white powder was dried for about 4h at 50° under reduced pressure and stored at 3°. Some samples were purified by mixed-bed ion exchange of aqueous suspensions of the crystal/liquid crystal phase. [Kaatze et al. J Phys Chem 89 2565 7955.]... 

Several authors have discussed the ion exchange potentials and membrane properties of grafted cellulose [135,136]. Radiation grafting of anionic and cationic monomers to impart ion exchange properties to polymer films and other structures is rather promising. Thus, grafting of acrylamide and acrylic acid onto polyethylene, polyethylene/ethylene vinyl acetate copolymer as a blend [98], and waste rubber powder [137,138], allows... 

The ion-exchange capacity of a powdered resin precoat filter is perhaps only 6% that of a deep-bed polisher. 

The dichlorodibenzo-p-dioxin component was isolated by passing a dioxane solution of the mixture through acetate ion exchange resin to remove phenolics. The eluted product was recrystallized from benzene. The x-ray powder diffraction pattern of the precipitate was identical with that of 2,7-dichlorodibenzo-p-dioxin. Analysis of the mother liquor by GLC showed a singular peak consistent with 2,7-dichlorodibenzo-p-dioxin. The mother liquor was cooled to 5°C and yielded transparent crystals. This material had an x-ray diffraction pattern congruent to a sample of 2,8-dichlorodibenzo-p-dioxin obtained from A. E. Pohland (FDA). The two patterns were quite distinct from each other 14, 15). 

Ion exchange zeolites are builders in washing powder, where they have gradually replaced phosphates to bind calcium. Calcium and, to a lesser extent, magnesium in water are exchanged for sodium in zeolite A. This is the largest application of zeolites today. Zeolites are essentially nontoxic, and pose no... 

Platinum catalysts were prepared by ion-exchange of activated charcoal. A powdered support was used for batch experiments (CECA SOS) and a granular form (Norit Rox 0.8) was employed in the continuous reactor. Oxidised sites on the surface of the support were created by treatment with aqueous sodium hypochlorite (3%) and ion-exchange of the associated protons with Pt(NH3)42+ ions was performed as described previously [13,14]. The palladium catalyst mentioned in section 3.1 was prepared by impregnation, as described in [8]. Bimetallic PtBi/C catalysts were prepared by two methods (1) bismuth was deposited onto a platinum catalyst, previously prepared by the exchange method outlined above, using the surface redox reaction ... 

Fine chemicals These are produced in small volumes and purchased on the basis of chemical composition, purity and price. Examples are chloropropylene oxide (used for the manufacture of epoxy resins, ion-exchange resins and other products), dimethyl formamide (used, for example, as a solvent, reaction medium and intermediate in the manufacture of pharmaceuticals), n-butyric acid (used in beverages, flavorings, fragrances and other products) and barium titanate powder (used for the manufacture of electronic capacitors). 

---