Institution of Electrical Engineers

M. Tahan, Weathering of Plastics and Rubber, International Symposium of the Institute of Electrical Engineers, Eondon, June 1976, Chamelon Press, Ltd., London, 1976, p. A2.1. 

J. Brice and P. Capper, eds.. Properties oJhAercury Cadmium Te//uride Institution of Electrical Engineers (INSPEC), London, 1987. 

INSPEC, E/ectronic Materia/s Information Series Institution of Electrical Engineers, London. 

A Greenwood, Vacuum Switchgear, Institution of Electrical Engineers, 1994. 

Haldane, T. G. N. (1930). The Heat Pump An Economical Method of Producing Low-Grade Heat from Electricity. Journal of the Institution of Electrical Engineers 68 666—675. 

Institution of Electrical Engineers. (1950). The Heaviside Centenary Volume. Loudon Author. 

Booklets and leaflets published by most oil suppliers Libraries of Institute of Plant Engineers Institution of Production Engineers Institute of Petroleum Institution of Electrical Engineers Institution of Mechanical Engineers Literature published by additive companies Literature published by the American Society of Lubrication Engineers Libraries of universities... 

Tony Hardwick of the Institution of Electrical Engineers -A Professional Development Scheme... 

Parker, N. (1965) Chem. Eng., NY12 (Sept. 13th) 179. Agitated evaporators, Part 2, equipment and economics. Parker, K. (2002) Electrostatic Precipitators (Institution of Electrical Engineers). 

The seventh Steinmetz lecture, delivered before the Schenectady section of the American Institute of electrical engineers, Nov. 18, 1932. 

L. Y. Astanin and A. A. Kostylev, Ultrawideband Radar Measurements, Analysis and Processing , The Institution of Electrical Engineers, London, 1997. 

B.H. van den SCHOOT and P. BERGVELD, in Proc. Transducers 87, The fourth International Conference on Solid-State Sensors and Actuators, Tokyo, June 2-5 (1988), Institute of Electrical Engineering of Japan, p. 719. 

Marcuvitz, N. 1986. Waveguide Handbook, (reissued on behalf of Institute of Electrical Engineers available through IEEE Service Center, Piscataway, New Jersey). Peter Peregrinus, Ltd- London, UK. 

The Japanese Institute of Electrical Engineers has been sponsoring an annual conference on sensors since 1982. 

I -A characteristics of amperometric oxygen sensor, air ratio. Reproduced with permission from Ref. 7. 1985 Institute of Electrical Engineering of Japan. 

FIGURE 8.15 Cross section of the fight-addressable potentiometer sensor (LAPS) chip integrated with a flow channel for study of adherent cells [848]. Reprinted with permission from the Institute of Electrical Engineers of lapan. 

James, Frank A. J. L. (1991). The Correspondence of Michael Faraday. 4 vols. and others in preparation. London Institution of Electrical Engineers. 

K. Shimoda, I. Takazu, T. Nagakura, Y. Miyahara, T. Moriizumi, and K. Ichimura, in Proc. Symposium of the Institute of Electrical Engineers ofJapan, EIM-85-56, 1985, p. 75. 

Fig. 6.4 The variation of the electriG strength of polyethylene with temperature. The inset diagram shows the type of recessed specimen used. Reproduced from Lawson (1966) with permission of the Institution of Electrical Engineers.

Fig. 6.5 Calculated heating curves for increasing voltages applied across an infinite slab, showing the onset of thermal runaway. Reproduced from Copple et ctl. (1939) with permission of the Institution of Electrical Engineers.

Fig. 6.8 Photograph of electrical discharge channels in low-density polyethylene after application of 20 kV (rms) at 50 Hz for 200 min. Reproduced from Billing and Groves (1974) with permission of the Institution of Electrical Engineers.

---