Insertion of carbon monoxide

Carbon Monoxide Process. This process involves the insertion of carbon monoxide [630-08-0] into a chloroacetate. According to the hterature (34) in the first step ethyl chloroacetate [105-39-5] reacts with carbon monoxide in ethanol [64-17-5] in the presence of dicobalt octacarbonyl [15226-74-1], Co2(CO)g, at typical temperature of 100°C under a pressure of 1800 kPa (18 bars) and at pH 5.7. Upon completion of the reaction the sodium chloride formed is separated along with the catalyst. The ethanol, as well as the low boiling point components, is distilled and the nonconverted ethyl chloroacetate recovered through distillation in a further column. The cmde diethyl malonate obtained is further purified by redistillation. This process also apphes for dimethyl malonate and diisopropyl malonate. 

Initial step is the formation of a dicobalthexacarbonyl-alkyne complex 5 by reaction of alkyne 1 with dicobaltoctacarbonyl 4 with concomitant loss of two molecules of CO. Complex 5 has been shown to be an intermediate by independent synthesis. It is likely that complex 5 coordinates to the alkene 2. Insertion of carbon monoxide then leads to formation of a cyclopentenone complex 6, which decomposes into dicobalthexacarbonyl and cyclopentenone 3 ... 

Although analogous to the direct coupling reaction, the catalytic cycle for the carbonylative coupling reaction is distinguished by an insertion of carbon monoxide into the C-Pd bond of complex A (see A—>B, Scheme 31). The transmetalation step-then gives trans complex C which isomerizes to the cis complex D. The ketone product E is revealed after reductive elimination. 

Alkylation of the anion 2 with iodomethane or other haloalkanes provides alkyldicarbonyl(t/5-cyclopentadienyl)iron complexes such as 53,0 (see also Houben-Weyl, Vol. 13/9a, p 209). Migratory insertion of carbon monoxide occurs on treatment with phosphanes or phosphites9 -11 (see also Houben-Weyl, Vol. d3/9a, p257) to provide chiral iron-acyl complexes such as 6. This is the most commonly used preparation of racemic chiral iron-acyl complexes. 

Another route to enantiomcrically pure iron-acyl complexes depends on a resolution of diastereomeric substituted iron-alkyl complexes16,17. Reaction of enantiomerically pure chloromethyl menthyl ether (6) with the anion of 5 provides the menthyloxymethyl complex 7. Photolysis of 7 in the presence of triphenylphosphane induces migratory insertion of carbon monoxide to provide a racemic mixture of the diastereomeric phosphane-substituted menthyloxymethyl complexes (-)-(/ )-8 and ( + )-( )-8 which are resolved by fractional crystallization. Treatment of either diastereomer (—)-(/J)-8 or ( I )-(.V)-8 with gaseous hydrogen chloride (see also Houben-Weyl, Vol 13/9a, p437) affords the enantiomeric chloromethyl complexes (-)-(R)-9 or (+ )-(S)-9 without epimerization of the iron center. 

It should be noted that, similarly to olefin, the insertion of carbon monoxide in the active bond in the propagation centers of polymerization catalysts also follows the coordination mechanism 175). The insertion of carbon monoxide into the active bond was not feasible when a vacant coordination site of the metal ion had been occupied by phosphine. 

Synthetic and mechanistic aspects of inorganic insertion reactions. Insertion of carbon monoxide. F. Calderazzo, Angew. Chem., Int. Ed. Engl., 1977,16, 299-311 (121). 

Treatment of the 1,2-oxazines 52 with carbon monoxide at 1000 psi in the presence of cobalt carbonyl brings about insertion of carbon monoxide to form the 1,3-oxazepines S3 <96TL2713>. A convenient route to P-lactams fused to oxepines is made available by alkene metathesis. Thus reaction of 4-acetoxyazetidin-2-one with ally alcohol in the presence of zinc acetate, followed by iV-allylation of the nitrogen affords the derivative 54 which cyclises by RCM to form the oxazepinone 55 <96CC2231>. The same communication describes a similar synthesis of 1,3-dioxepines. 

This chapter is concerned entirely with the insertion of carbon monoxide into transition metal-carbon cr-bonds. Sulfur dioxide insertion 154, 239), also common among transition metal-carbon complexes, will be treated in a complementary review, which is to appear later. Subject to the restrictions given at the beginning of Section VI, an attempt has been made at a complete literature coverage of the insertion of CO. Particular emphasis focuses on recent results, especially those of a kinetic and stereochemical nature. 

A catalyst used for the u-regioselective hydroformylation of internal olefins has to combine a set of properties, which include high olefin isomerization activity, see reaction b in Scheme 1 outlined for 4-octene. Thus the olefin migratory insertion step into the rhodium hydride bond must be highly reversible, a feature which is undesired in the hydroformylation of 1-alkenes. Additionally, p-hydride elimination should be favoured over migratory insertion of carbon monoxide of the secondary alkyl rhodium, otherwise Ao-aldehydes are formed (reactions a, c). Then, the fast regioselective terminal hydroformylation of the 1-olefin present in a low equilibrium concentration only, will lead to enhanced formation of n-aldehyde (reaction d) as result of a dynamic kinetic control. 

Treatment of the olefin 49 with Zeise s dimer leads to the chloroplatination complex 50 [26], The addition adduct 50 is hydrogenated stereospecifically to the trans-disubstituted chlorocyclohexane 51. The insertion of carbon monoxide into 50, in the presence of methanol, yields the ester 52 stereoselectively. 

The insertion of carbon monoxide into readily available 2-bromo-3-aminopropene derivatives can be effected by catalytic quantities of palladium acetate and triphenylphosphine high CO pressures are not required (Scheme 16).38 The /Mactam products presumably arise by palladation,carbonylation, and cyclization as depicted in Scheme 17.38 An extension of this approach to the synthesis of biologically interesting condensed /(-lactams can be expected. 

Formation of the reduced 1,3-oxazepine derivative 160 from the reaction of diiron nonacarbonyl with the tetrahydrooxazine derivative (159) involves a novel formal insertion of carbon monoxide into an N—O bond (Scheme 183).248 The synthetic applicability of this unusual reaction has not been evaluated. 

Scheme 7 comprises the following patterns First, a metallacycle gives rise to ketones by CO insertion and reductive elimination. Next, a nickel hydride inserts an unsaturated substrate L, followed by CO. The acyl intermediate can give rise to reductive elimination with formation of acyl halides or acids and esters by hydrolysis, or it can insert a new ligand with subsequent reductive elimination as before. Alternatively, there may be a new insertion of carbon monoxide with final hydrolysis. Third, an intermediate R—Ni—X is formed by oxidative addition. It can react in several ways It can insert a new ligand L, followed by CO to give an... 

Cyclopentanones form from CO and double bonds in 1,5-positions (example 43, Table VII). This is a very selective and stereoselective process, the 1,4- or 1,6-positions being not significantly reactive under the same conditions. o-Hydroxyphenylacetylenes also form 5-membered lactones (example 45, Table VII). In some cases ring closure leads to a new nickel-carbon bond into which a new molecule of carbon monoxide can be inserted. This process of alternative insertion of carbon monoxide and other unsaturated ligands can be repeated several times so that complex alicyclic structures can be formed (example 49, Table VII). This... 

This article reviews recent results on the chemical, spectral and structural properties of bis(pentamethylcyclopentadienyl) thorium and uranium dihaptoacyl complexes produced by migratory insertion of carbon monoxide into actinide-carbon sigma bonds. 

Merlic demonstrated the direct, non-photochemical insertion of carbon monoxide from acylamino chromium carbene complexes 14 to afford a presumed chromium-complexed ketene 15 <00JA7398>. This presumed metal-complexed ketene leads to a munchnone 16 or munchnone complex which undergo dipolar cycloaddition with alkynes to yield the pyrroles 17 upon loss of carbon dioxide. 

A three-component coumarin synthesis involves the Pd-catalysed coupling of o-iodophenols with alkynes and subsequent insertion of carbon monoxide. With internal alkynes, pyridine is the crucial base for successful annulation the regioselectivity with unsymmetrically substituted alkynes is only moderate (Scheme 43) . 

In this chapter, we provide the necessary background concerning the formation of zir-conacycles, then briefly review the insertion of carbon monoxide and isoelectronic isonitriles into organozirconocenes. We then describe in more detail the insertion of a-halo-a-lithium species (R1R2CLiX, carbenoids [7]), which may be viewed as taking place according to a conceptually similar mechanism. 

Carbon monoxide rapidly inserts into the carbon—zirconium bond of alkyl- and alkenyl-zirconocene chlorides at low temperature with retention of configuration at carbon to give acylzirconocene chlorides 17 (Scheme 3.5). Acylzirconocene chlorides have found utility in synthesis, as described elsewhere in this volume [17]. Lewis acid catalyzed additions to enones, aldehydes, and imines, yielding a-keto allylic alcohols, a-hydroxy ketones, and a-amino ketones, respectively [18], and palladium-catalyzed addition to alkyl/aryl halides and a,[5-ynones [19] are examples. The acyl complex 18 formed by the insertion of carbon monoxide into dialkyl, alkylaryl, or diaryl zirconocenes may rearrange to a r 2-ketone complex 19 either thermally (particularly when R1 = R2 = Ph) or on addition of a Lewis acid [5,20,21]. The rearrangement proceeds through the less stable... 

Insertion of carbon monoxide into Csp2—Zr bonds occurs readily at ambient temperatures or below to produce a,(5-unsaturated, reactive acyl zirconocene derivatives [27—29]. Early work by Schwartz demonstrated the potential of such intermediates in synthesis [5d], as they are highly susceptible to further conversions to a variety of carbonyl compounds depending upon manipulation. More recently, Huang has shown that HC1 converts 16 to an enal, that addition of a diaryl diselenide leads to selenoesters, and that exposure to a sulfenyl chloride gives thioesters (Scheme 4.11) [27,28]. All are obtained with (F)-stereochemistry, indicative of CO insertion with the expected retention of alkene geometry. 

Acylzirconocene chloride derivatives are easily accessible in a one-pot procedure through the hydrozirconation of alkene or alkyne derivatives with zirconocene chloride hydride (Schwartz reagent) [Cp2Zr(H)Cl, Cp = cyclopentadienyl] and subsequent insertion of carbon monoxide (CO) into the alkyl— or alkenyl—zirconium bond under atmospheric pressure (Scheme 5.1) [2],... 

The insertion of carbon monoxide into o-alkylpalladium(II) complexes followed by attack by either alcohols or amines is a powerful acylation method. This carbonylation reaction has been applied in several different ways to the reactions and syntheses of indoles. Hegedus and coworkers converted o-allylanilines to indoline esters 315 in yields up to 75% [293], In most of the examples in this section, CO at atmospheric pressure was employed. 

Complex condensation products are obtained by reaction of the alkyne complex with excess of 3,3-dimethyl-l-butyne, which yields two isomeric products of formulas Ru3(CO)6[HC2C(Me)3-COCH2CMe3][HC2CMe3]2 (125). The X-ray structure of one of those adducts (Fig. 19) shows that both dimerization of two alkyne molecules and the insertion of carbon monoxide into the alkyne metal bonds have occurred. The Ru-Ru distances of 2.820,2.828, and 2.686 A in the ring are of interest. The value of 2.686 A is one of the shortest found in a... 

It is also called dissociative because one of the rate-determining steps is the dissociation of carbon monoxide. The cycle is started by the dissociation of a ligand, which results in the release of the planar 16 electron species (I). In analogy to the cobalt mechanism (see Wiese KD and Obst D, 2006, in this volume), the next step is the addition of an olefin molecule to form the r-complex (II). This complex undergoes a rearrangement reaction to the corresponding reaction steps decide whether a branched or a linear aldehyde is the product of the hydroformylation experiment. The next step is the addition of a carbon monoxide molecule to the 18 electron species (IV). Now, the insertion of carbon monoxide takes place and... 

The carbonylation reaction (Eq. 1) involves formal insertion of carbon monoxide into the C - 0 bond of methanol ... 

The metal hydride bond is stronger than a metal carbon bond and the insertion of carbon monoxide into a metal hydride is thermodynamically most often uphill. Alkene insertion into a metal hydride is thermodynamically allowed and often reversible. 

Insertion of carbon monoxide and alkenes into metal-carbon bonds is one of the most important reaction steps in homogeneous catalysis. It has been found for insertion processes of platinum [16] that the relative positions of the hydrocarbyl group and the unsaturated fragment must be cis in the reacting complex [17], The second issue concerns the stereochemical course of the reaction, insertion versus migration as discussed in Chapter 2.2. 

Fig. 2.5. Preparation of hydroxy- and alkoxycarbene complexes from alkyl complexes by 1,1-insertion of carbon monoxide [106-108].

---