Indanes

A fundamental set is also called a smallest set. Usually such a smallest set is selected that it also contains the smallest rings the smallest set of smallest rings (SSSR). This makes chemical sense in indane (Figure 2-38a), for example, where only the six- and the five-membered rings are of chemical significance whereas the enveloping nine-membered ring is not. 

Ninhydrin (also named 1 2 3-triketoindane or 1 2 3-triketohydrindene hydrate) is prepared most simply from the inexpensive phthahc anhydride (I). The latter is condensed with acetic anhydride In the presence of potassium acetate to give phthalylacetlc acid (II) reaction of the latter with sodium methoxide in methanol yields 1 3-indanedionecarboxyhc acid, which is decomposed upon warming with dilute hydrochloric or sulphuric acid to indane-1 3-dione (or 1 3-diketohydrindene) (HI). Selenium dioxide oxidation of (III) afibrds indane-1 2 3-trione hydrate (ninhydrin) (IV). 

Indane-1 3-dione (1 3-diketohydrindene). Method A. To a solution of sodium methoxide, prepared from 6 1 g. of sodium and 200 ml. of anhydrous methanol, add 15 g. of phthalylacetic acid and allow to stand for 1 hour at room temperature collect the yellow precipitate by suction filtration. Mix the yellow solid with 150 ml. of 10 per cent, sulphuric acid, heat on a steam bath until no more carbon dioxide is evolved (15-20 minutes), filter the hot solution and allow to cool. Collect the yellow crystals by filtration at the pump, wash with a httle water and dry at 100°. The yield of crude 1 3-indanedione, m.p. 125-126°, is 7 g. RecrystaUise from hght petroleum, b.p. 80-100°, and thus obtain the pure product, m.p. 129-130°. 

Tetralin shows evidence in n.m.r. spectroscopy, similar to that mentioned above, for the formation of one or more addition complexes. Tetralin (like indan) is known to undergo acetoxylation. ... 

High purity mesitylene, hemimellitene, and durene are often produced synthetically, whereas pseudocumene is obtained from extracted reformate by superfractionation. The composition of a typical extracted Cg reformate and the hoiling points of the nine Cg isomers present are shown in Table 5. Pseudocumene is separated in high purity (>98%) by superfractionation alone, whereas mesitylene, hemimellitene, and durene cannot be cleanly separated because of the presence of close hoiling compounds, eg, 2-ethyltoluene, indane, and isodurene, respectively. 

AlClj Alkylation Process. The first step in the AIQ. process is the chlorination of / -paraffins to form primary monochloroparaffin. Then in the second step, the monochloroparaffin is alkylated with benzene in the presence of AIQ. catalyst (75,76). Considerable amounts of indane (2,3-dihydro-lH-indene [496-11-7]) and tetralin (1,2,3,4-tetrahydronaphthalene [119-64-2]) derivatives are formed as by-products because of the dichlorination of paraffins in the first step (77). Only a few industrial plants built during the early 1960s use this technology to produce LAB from linear paraffins. The C q—CC olefins also can be alkylated with benzene using this catalyst system. 

Gumylphenol. -Cumylphenol (PGP) or 4-(1-methyl-l-phenylethyl)phenol is produced by the alkylation of phenol with a-methylstyrene under acid catalysis. a-Methylstyrene is a by-product from the production of phenol via the cumene oxidation process. The principal by-products from the production of 4-cumylphenol result from the dimerization and intramolecular alkylation of a-methylstyrene to yield substituted indanes. 4-Cumylphenol [599-64-4] is purified by either fractional distillation or crystallization from a suitable solvent. Purification by crystallization results in the easy separation of the substituted indanes from the product and yields a soHd material which is packaged in plastic or paper bags (20 kg net weight). Purification of 4-cumylphenol by fractional distillation yields a product which is almost totally free of any dicumylphenol. The molten product resulting from purification by distillation can be flaked to yield a soHd form however, the soHd form of 4-cumylphenol sinters severely over time. PGP is best stored and transported as a molten material. 

Ethyltoluene is manufactured by aluminum chloride-cataly2ed alkylation similar to that used for ethylbenzene production. All three isomers are formed. A typical analysis of the reactor effluent is shown in Table 9. After the unconverted toluene and light by-products are removed, the mixture of ethyltoluene isomers and polyethyltoluenes is fractionated to recover the meta and para isomers (bp 161.3 and 162.0°C, respectively) as the overhead product, which typically contains 0.2% or less ortho isomer (bp 165.1°C). This isomer separation is difficult but essential because (9-ethyltoluene undergoes ring closure to form indan and indene in the subsequent dehydrogenation process. These compounds are even more difficult to remove from vinyltoluene, and their presence in the monomer results in inferior polymers. The o-ethyltoluene and polyethyltoluenes are recovered and recycled to the reactor for isomerization and transalkylation to produce more ethyltoluenes. Fina uses a zeoHte-catalyzed vapor-phase alkylation process to produce ethyltoluenes. 

Indane [496-11-7] M 118.1, b 177 , d 0.960, n 1.538. Shaken with cone H2SO4, then water, dried and fractionally distd. 

During the high-temperature operations, intermolecular hydrogen transfer reactions occur, transforming some indene to indane. The high indane concentration in the resin feedstock causes low yield and poor quality in the polymerization process. The indene loss can be reduced by decreasing the temperature and the residence time during distillation. 

Fluonnation and skeletal transformation of fluorinated cycloalkanes occurs in the reaction with antimony pentafluoride at high temperature [777] In the case of perfluorinated benzocyclobutanes, an unexpected alicyclic ring cleavage has been observed Perfluorinated alkyl benzocyclobutanes, when treated with antimony pentafluoride, ean be converted to perfluorinated styrenes and then transformed to perfluorinated indans [77S, 779]... 

Discovery and development of A-benzyl-4-(5,6-dimethoxy-l-oxo-indan-2-ylmethyOpiperidine hydrochloride (donepezil hydrochloride) for treatment of Alzheimer s disease 98YGK320, 99YZ101. 

---