In sulfate pulps

Kleinert TN, Joyce CS (1957a) Short wavelength absorption of various lignins and related substances IV Lignin determination in sulfate pulping liquors Pulp Pap Mag Can 58(11) 147-152... 

Terpenes, specifically monoterpenes, are naturally occurring monomers that are usually obtained as by-products of the paper and citms industries. Monoterpenes that are typically employed in hydrocarbon resins are shown in Figure 2. Optically active tf-limonene is obtained from various natural oils, particularly citms oils (81). a and P-pinenes are obtained from sulfate turpentine produced in the kraft (sulfate) pulping process. Southeastern U.S. sulfate turpentine contains approximately 60—70 wt % a-pinene and 20—25 wt % P-pinene (see Terpenoids). Dipentene, which is a complex mixture of if,/-Hmonene, a- and P-pheUandrene, a- and y-terpinene, and terpinolene, is also obtained from the processing of sulfate Hquor (82). 

Uses. The principal use of magnesium hydroxide is in the pulp (qv) and paper (qv) industries (52). The main captive use is in the production of magnesium oxide, chloride, and sulfate. Other uses include ceramics, chemicals, pharmaceuticals, plastics, flame retardants/smoke suppressants, and the expanding environmental markets for wastewater treatment and SO removal from waste gases (87). 

ChemicalRecope . There are advantages and disadvantages to each of the base systems employed in sulfite pulping (see Table 4). Each has its own potential recovery systems except the calcium system, which is obsolete. Calcium-based Hquors can be burned, but scaling problems are severe, and conversion of the calcium sulfate to CaO is not economical. 

When chlorine dioxide is used for pulp bleaching in conjunction with the Kraft (sulfide) process for chemical pulping, by-product sodium sulfate can be used as a source of makeup sulfur and sodium consumed in the chemical cycle. The demand for sodium and sulfur in pulp bleaching is related to the loss of these chemicals through carryover in unbleached pulp. As process improvements have sought to reduce pollution from pulp mills, less sodium sulfate makeup is required. The trends in pulp bleaching to increase substitution of chlorine with chlorine dioxide have caused an oversupply of sodium sulfate, so that this by-product is often regarded as waste (81). 

Trees, especially conifers, contain tall oils. Tall oil is not isolated dkecfly tall oil fatty acids are isolated from the soaps generated as a by-product of the sulfate pulping process for making paper. Refined tall oil fatty acids are obtained by acidification of the soaps, followed by fractional distillation to separate the fatty acids from the rosin acids and terpene hydrocarbons that also are present in the cmde tall oil fatty acids (see Carboxylic acids Fatty ACIDS FROMTALL OIL). 

Typical applications in the chemical field (Beaver, op. cit.) include detarring of manufactured gas, removal of acid mist and impurities in contact sulfuric acid plants, recovery of phosphoric acid mists, removal of dusts in gases from roasters, sintering machines, calciners, cement and lime Idlns, blast furnaces, carbon-black furnaces, regenerators on fluid-catalyst units, chemical-recoveiy furnaces in soda and sulfate pulp mills, and gypsum kettles. Figure 17-74 shows a vertical-flow steel-plate-type precipitator similar to a type used for catalyst-dust collection in certain fluid-catalyst plants. 

The paper and pulp industries consume taif/e quantities of Ca(OH)2 and precipitated (as distinct from naturally occurring) CaCOs. The largest application of lime in pulp manufacture is as a causlicizing agent in sulfate (kraft) plants (p. 89). Here the waste NajC solution is reacted with lime to regenerate the caustic soda used in the process ... 

The dissolved oxygen in the pulp oxidizes the sulfide surface to sulfate according to the following reaction ... 

After the chemical treatment, the pulped wood is removed, washed, and screened. Unbleached, brown-colored paper is made directly for this material. Most whitened or bleached paper is made by the treatment of the pulp with chlorine, chlorine dioxide, hypochlorite, and/or alkaline extraction. In general, sulfate-pulped paper is darker and requires more bleaching and alkaline extraction to give a white pulp. 

Ray cells in unbleached sulfite and sulfate pulps (weight %) Distributed on 8 6... 

---