Impeller fabrication materials

Wear is the removal of surface material by one of three mechanisms erosion, abrasion, or cavitation. Erosion is the removal of a polymer s surface by abrasive materials carried in a fluid medium. We see this type of wear in plastic pipes used to transport waterborne slurries of minerals in mining operations and in vacuum transfer pipes used to convey powders in a stream of air. Abrasion is the result of two surfaces sliding against each other. We commonly observe abrasion of polymers in the fabrics of our clothes and upholstery. Cavitative wear is caused by voids in a liquid medium collapsing against a surface. It is essentially an impact process. Cavitation is a relatively uncommon cause of wear in polymers. Pump impellers are one of the few applications where polymers must resist this type of wear. 

Materials of Construction. The principal materials of construction are ferrous throughout, but different grades are used for the different components. Casings usually are in cast iron or cast steel, and impellers may be in the same materials or in fabricated steel. Early designs of centrifugal compressors used riveted assembly for impellers castings or welded construetions are preferred today. Shafts usually are of carbon steel with hardened or stainless steel sleeves at points where erosion is likely. The selection of materials for smaller components that may be subject to friction is particularly important because of the danger of comlnistion. 

---