Immobilization zeolite

Turro and coworkers reported the photolysis of racemic benzoin methyl ether 12 within chiral inductor-immobilized zeolite supercages [55],... 

Ramamurthy and coworkers reported the photochemical electron-transfer-initiated intermolecular hydrogen transfer reaction [80,81] of phenyl cyclohexyl ketone 25 in chiral amine-immobilized zeolite cavities. 

Although these examples show the possible immobilization on clays and mesoporous zeolites, the most widely used support for salen complexes has... 

The mesoporous character of MCM-41 overcomes the size limitations imposed by the use of zeolites and it is possible to prepare the complex by refluxing the chiral ligand in the presence of Mn +-exchanged Al-MCM-41 [34-36]. However, this method only gives 10% of Mn in the form of the complex, as shown by elemental analysis, and good results are only possible due to the very low catalytic activity of the uncomplexed Mn sites. The immobihzed catalyst was used in the epoxidation of (Z)-stilbene with iodosylbenzene and this led to a mixture of cis (meso) and trans (chiral) epoxides. Enantioselectivity in the trans epoxides was up to 70%, which is close to the value obtained in solution (78% ee). However, this value was much lower when (E)-stilbene was used (25% ee). As occurred with other immobilized catalysts, reuse of the catalyst led to a significant loss in activity and, to a greater extent, in enantioselectivity. 

Fig. 22 Chiral bis(oxazoline) ligands used for immobilization in zeolites...

Table 12 Results of reactions of ethyl glyoxylate with different alkenes, catalyzed by several bis(oxazoline)-copper complexes immobilized on Y zeolite...

Another way of immobilizing catalyst complexes might be to trap them in the pores of solid particles, for instance by synthesizing the complex inside the pores of a zeolite ( ship in a bottle ). Another method could be to trap catalyst complexes in porous materials and deposit a membrane at the outer. surface. These methods of immobilizing a homogeneous catalyst do not involve chemical linkage between the catalyst and the carrier. The fixation is the result of steric hindrance. 

Encapsulation of [Co(bpy)3]2+ within zeolite frameworks has also been shown to have a remarkable influence on the electronic spin state of the complex.240 Distortions imparted on the tris-chelate complex by the confines of the zeolite supercage are found to be responsible for stabilizing the unusual low-spin electronic ground state.241,242 The [Co(bpy)3]3+/2+ couple has been measured for the encapsulated complex and it has been found that the complexes remain within the zeolite and do not exchange with the bulk solution.243 Electrochemistry of [Co(bpy)3]3+/2+ immobilized within a sol-gel has also been studied.244... 

Immobilization of chiral complexes in PDMS membranes offers a method for the generation of new chiral catalytic membranes. The heterogenization of the Jacobsen catalyst is difficult because the catalyst loses its enantioselectivity during immobilization on silica or carbon surfaces whereas the encapsulation in zeolites needs large cages. However, the occlusion of this complex in a PDMS matrix was successful.212 The complex is held sterically within the PDMS chains. The Jacobsen catalyst occluded in the membrane has activity and selectivity for the epoxidation of alkenes similar to that of the homogeneous one, but the immobilized catalyst is recyclable and stable. 

Pure Ti02 was recently reported to be active in the disinfection of water contaminated by spores of the type Fusarium solani [142], Bacillus anthracis [143], or Cryptosporidium parvum oocysts [144], or when supported as nanocomposites on zeolite H(i for E. coli deactivation [145], and it found applications in water treatment as a replacement for chlorine. Ag-Ti02 immobilized systems were used for inactivation of bacteria, coupling the visible light response of the system and the strong bactericidal effect of Ag [146]. Silver was deposited on hydroxyapatite to form nanocomposites with a high capacity for bacterial adsorption and inactivation [147], or used for airborne bacterial remediation in indoor air [148],... 

Common to all encapsulation methods is the provision for the passage of reagents and products through or past the walls of the compartment. In zeolites and mesoporous materials, this is enabled by their open porous structure. It is not surprising, then, that porous silica has been used as a material for encapsulation processes, which has already been seen in LbL methods [43], Moreover, ship-in-a-bottle approaches have been well documented, whereby the encapsulation of individual molecules, molecular clusters, and small metal particles is achieved within zeolites [67]. There is a wealth of literature on the immobilization of catalysts on silica or other inorganic materials [68-72], but this is beyond the scope of this chapter. However, these methods potentially provide another method to avoid a situation where one catalyst interferes with another, or to allow the use of a catalyst in a system limited by the reaction conditions. For example, the increased stability of a catalyst may allow a reaction to run at a desired higher temperature, or allow for the use of an otherwise insoluble catalyst [73]. 

Fig. 7.n SEM images of the 3D macroporous functionalized macroporous zeolitic membrane zeolitic membrane used as a support for enzyme bioreactor was prepared via the LbL electrostatic immobilization by the LbL procedure. Images assembly of PEs and enzyme (catalase) on the 3D (A-D) are cross-sections of the membrane at macroporous membrane. (Reprinted from [59] different magnifications. A biomacromolecule- with permission of Wiley-VCH). 

The concept of zeolite action was tested in a particular reaction where the enzyme is exposed from the beginning to an acidic environment the esterification of geraniol with acetic acid catalyzed by Candida antarctica lipase B immobilized on zeolite NaA [219]. Lipases have been used for the hydrolysis of triglycerides and due to their ambivalent hydrophobic/hydrophilic properties they are effective biocatalysts for the hydrolysis of hydrophobic substrates [220]. When water-soluble lipases are used in organic media they have to be immobilized on solid supports in order to exhibit significant catalytic activity. 

Hydrolysis oftricaprylin in trimethylpentane by Fusarium solani pisi recombinant cutinase immobilized on various zeolites (NaA, NaX, NaY, LZY-82, dealuminated Y) was investigated in order to assess the effect of chemical composition (Si/Al ratio), hydrophilic character and acidity on the catalytic activity [221]. The adsorption of... 

Fontes tt al. [224,225 addressed the acid—base effects of the zeolites on enzymes in nonaqueous media by looking at how these materials affected the catalytic activity of cross-linked subtilisin microcrystals in supercritical fluids (C02, ethane) and in polar and nonpolar organic solvents (acetonitrile, hexane) at controlled water activity (aw). They were interested in how immobilization of subtilisin on zeolite could affected its ionization state and hence their catalytic performances. Transesterification activity of substilisin supported on NaA zeolite is improved up to 10-fold and 100-fold when performed under low aw values in supercritical-C02 and supercritical-ethane respectively. The increase is also observed when increasing the amount of zeolite due not only to a dehydrating effect but also to a cation exchange process between the surface proton of the enzyme and the sodium ions of the zeolite. The resulting basic form of the enzyme enhances the catalytic activity. In organic solvent the activity was even more enhanced than in sc-hexane, 10-fold and 20-fold for acetonitrile and hexane, respectively, probably due to a difference in the solubility of the acid byproduct. 

Biodiesel production by immobilized lipase on zeolites and related materials... 

In this communication a study of the catalytic behavior of the immobilized Rhizomucor miehei lipase in the transesterification reaction to biodiesel production has been reported. The main drawbacks associated to the current biodiesel production by basic homogeneous catalysis could be overcome by using immobilized lipases. Immobilization by adsorption and entrapment have been used as methods to prepare the heterogeneous biocatalyst. Zeolites and related materials have been used as inorganic lipase supports. To promote the enzyme adsorption, the surface of the supports have been functionalized by synthesis procedures or by post-treatments. While, the enzyme entrapping procedure has been carried out by sol-gel method in order to obtain the biocatalyst protected by a mesoporous matrix and to reduce its leaching after several catalytic uses. 

---