Imines, preparation from amines

The imine, prepared from an amine and (C5H4N)(Me3C JH2)CO (TiC, toluene, reflux, 12 h NaOH, 80% yield), can be cleaved with coned. HCl (reflux). The protective group was used to direct a-alkylation of amines. 

Therefore, in principal, condensation of a primary amine with an enantiomerically pure ketone should allow asymmetric synthesis of a-substituted primary amines. This approach has been applied to the synthesis of a-amino acids, for example, using the imine prepared from a-amino esters and (l.S, 2,S ,5,S )-2-hydroxy-3-pinanone, via an amino-substituted ester enolate anion with some success39 40. Application of this approach to simple primary amines has seldom been reported. 

Few additions have been attempted using imines prepared from heterocyclic aldehydes and heterocyclic amines. In the one example reported l-(3-pyridyl)-5-(2-quinolyl)-l,2,3-triazoline is obtained in 70% yield after 21 hr.329... 

For the synthesis of the trans-mmulsitQd 4a- p/-pumiliotoxin C 195 (Scheme 10.66), the imine prepared from galactosyl amine 150 and 5-hexenal was reacted with Danishefsky s diene to give the 2-substituted dehydropiperidinone derivative 196 with high diastereoselectivity. The subsequent addition of propyl cuprate promoted by borontrifluoride etherate furnished the 2,6-c/5 -disubstituted... 

Aliphatic aldehydes reacted with amines and silyl enolates to give the corresponding b-amino esters in high yields. In some reactions of imines, it is known that aliphatic enolizable imines prepared from aliphatic aldehydes gave poor results. 

S-a-phenylethylamine, followed by debenzylation, gives as the unique product the 20a-amine (2a, funtaphyllamine). Similar reduction of the imine prepared from (+)-R-a-phenylethylamine gives essentially the epimeric 20j3-amine (2b). 

The addition of diphenylphosphine oxide to imines prepared from imidazole-2-carboxaldehyde and primary amines led to the corresponding a-aminophosphine oxides (Scheme 47). ... 

Originally, a C-20 amine (prepared from a bisnorcholanic acid) was converted into its 7V-chloro derivative, dehydrohalogenated to the imine, converted into the A-acetylenanime, reacted with perbenzoic acid, then hydrolyzed to the 17a-hydroxy-20-ketone ... 

A number of imine derivatives have been prepared as amine protective groups, but most of these have not seen extensive use. The most widely used are the ben-zylidene and diphenylmethylene derivatives. The less used derivatives are listed, for completeness, with their references at the end of this section. For the most part, they are prepared from the aldehyde and the amine by water removal cleavage is effected by acid hydrolysis. 

A trifluoromethylsulfonamide can be prepared from a primary amine to allow monoalkylation of that amine. The triflamide is not stable to strong base, which causes elimination to an imine, but when used to protect an indole, it is cleaved with K2CO3 in refluxing methanol. ... 

The Jackson modification involves cyclisation of iV-tosylated amine 12 and provides a complementary method to the classical Pomeranz-Fritsch reaction for entry into the fully unsaturated ring system 13. Amine 12 can be prepared from either the Pomeranz-Fritsch-Bobbitt imine 10 or reaction of benzylhalide 14 and the corresponding sodium anion 15. ... 

One of the most popular orally active penicillins in present clinical use is amoxicillin (12). Its oral effectiveness and broad spectrum of activity against common pathogens as well as its better absorption than its closest precedent competitor, ampicillin (14), largely accounts for this. Higher blood and tissue levels of antibiotics is another means of dealing with resistance. In an attempt to achieve yet further improvements in oral bioavailability and hence blood and ti.ssue levels of amoxicillin, the prodmg fumoxicillin (13) is prepared from amoxicillin (12) by treatment with furfural [3]. The imine moiety is less basic than the primary amine so that the isoelectric point of fumoxicillin is more on the acid side than is that of amoxicillin. 

Reduction of iV-(3-bromopropyl) imines gives a bromo-amine in situ, which cyclizes to the aziridine. Five-membered ring amines (pyrrolidines) can be prepared from alkenyl amines via treatment with N-chlorosuccinimide (NCS) and then BusSnH. " Internal addition of amine to allylic acetates, catalyzed by Pd(PPh3)4, leads to cyclic products via a Sn2 reaction. Acyclic amines can be prepared by a closely related reaction using palladium catalysts. Three-membered cyclic amines (aziridines)... 

For the addition of an organometailic compound to an imine to give a primary amine, R in RCH=NR would have to be H, and such compounds are seldom stable. However, the conversion has been done, for R = aryl, by the use of the masked reagents (ArCH=N)2S02 [prepared from an aldehyde RCHO and sulfamide (NH2)2S02]. Addition of R"MgX or R"Li to these compounds gives ArCHR"NH2 after hydrolysis. ... 

Double asymmetric induction operates when the azomethine compound is derived from a chiral a-amino aldehyde and a chiral amine, e.g., the sulfin-imine 144 [70]. In this case, the R configuration at the sulfur of the chiral auxihary, N-tert-butanesulfinamide, matched with the S configuration of the starting a-amino aldehyde, allowing complete stereocontrol to be achieved in the preparation of the diamine derivatives 145 by the addition of trifluo-romethyl anion, which was formed from trifluoromethyltrimethylsilane in the presence of tetramethylammonium fluoride (Scheme 23). The substituents at both nitrogen atoms were easily removed by routine procedures see, for example, the preparation of the free diamine 146. On the other hand, a lower diastereoselectivity (dr 80 20) was observed in one reaction carried out on the imine derived from (it)-aldehyde and (it)-sulfinamide. 

One of the potentially most useful aspects of the imine anions is that they can be prepared from enantiomerically pure amines. When imines derived from chiral amines are alkylated, the new carbon-carbon bond is formed with a bias for one of the two possible stereochemical configurations. Hydrolysis of the imine then leads to enantiomerically enriched ketone. Table 1.4 lists some examples that have been reported.118... 

The addition of Grignard reagents to aldehydes, ketones, and esters is the basis for the synthesis of a wide variety of alcohols, and several examples are given in Scheme 7.3. Primary alcohols can be made from formaldehyde (Entry 1) or, with addition of two carbons, from ethylene oxide (Entry 2). Secondary alcohols are obtained from aldehydes (Entries 3 to 6) or formate esters (Entry 7). Tertiary alcohols can be made from esters (Entries 8 and 9) or ketones (Entry 10). Lactones give diols (Entry 11). Aldehydes can be prepared from trialkyl orthoformate esters (Entries 12 and 13). Ketones can be made from nitriles (Entries 14 and 15), pyridine-2-thiol esters (Entry 16), N-methoxy-A-methyl carboxamides (Entries 17 and 18), or anhydrides (Entry 19). Carboxylic acids are available by reaction with C02 (Entries 20 to 22). Amines can be prepared from imines (Entry 23). Two-step procedures that involve formation and dehydration of alcohols provide routes to certain alkenes (Entries 24 and 25). 

Amines can react with various carbonyl compounds and their derivatives in aqueous media to give the corresponding imine derivatives. These reactions have been discussed in related chapters. The synthetically most useful reaction of this type is the formation of imines and imine derivatives from the condensation of amines with aldehydes and ketones. Water is an excellent solvent for such condensation reactions. For example, water was found to be an ideal solvent for a high-yield, fast preparation of easily hydrolyzable 2-pyrrolecarbaldimines.23 In the presence of Cu2+, the reaction afforded the corresponding Cu(II) chelates (Eq. 11.19). 

Benzyloxybenzylamine (BOBA) 48 is a new class of an amine support and was prepared from Merrifield resin in two steps [56]. BOBA resin was treated with an aldehyde in the presence of an acid to give an imine that subsequently reacted with Yb(OTf)3-catalyzed silyl enolates (Scheme 18). Cleavage with trimethylsilyl triflate (TMSOTf) or 2,3-dichloro-5,6-dicyano-l,4-benzoquinone (DDQ) gave either phenols or amines, respectively. 

Asymmetric hydrogenation of nitrones in an iridium catalyst system, prepared from [IrCl(cod)]2, (S)-BINAP, NBu 4 BH4, gives with high enantioselectivity the corresponding A-hydroxylamines which are important biologically active compounds and precursors of amines (480). Further reduction of hydroxylamines to secondary amines or imines can be realized upon treatment with Fe/AcOH (479), or anhydrous titanium trichloride in tetrahydrofuran (THF) at room temperature (481). 

These authors also found that the addition of excess MgO during the in situ preparation of allyltantalum species improved reaction outcomes, even allowing for the first example of allylation of imines derived from aliphatic amines and aliphatic aldehydes (prepared in situ at room temperature in the presence of molecular sieves) (Equation (18)). The selective addition to imines permitted three-component reactions. 

Generally, the imine substrates are prepared from the corresponding ketone and amine and are hydrogenated as isolated (and purified) compounds. However, reductive animation where the C = N function is prepared in situ is attractive from an industrial point of view, and indeed there are some successful examples reported below [18, 19]. It is reasonably certain that most catalysts described in this chapter catalyze the addition of H2 directly to the C=N bond and not to the tautomeric enamine C = C bond, even though enamines can also be hydrogenated enantioselectively. 

---