Hydroxamic acids, substituted

Fig. 10 Benzamides as hydroxamic acid substitutes—discovery of MS-275. (Mitsui Pharmaceuticals)...

Salts of thiols (170) or of sulfinic acids (171) react like the alkoxides, giving 4-alkylthio- or 4-alkylsulfono-substituted butyrates. Alkali cyanides give 4-cyanobutyrates (172), hydroxylamine gives a hydroxamic acid (173), and hydra2ine a hydra2ide (174). 

If primary or secondary amines are used, A/-substituted amides are formed. This reaction is called aminolysis. Hydra2ines yield the corresponding hydra2ides, which can then be treated with nitrous acid to form the a2ides used in the Curtius rearrangement. Hydroxylamines give hydroxamic acids. 

Ring substituents show enhanced reactivity towards nucleophilic substitution, relative to the unoxidized systems, with substituents a to the fV-oxide showing greater reactivity than those in the /3-position. In the case of quinoxalines and phenazines the degree of labilization of a given substituent is dependent on whether the intermediate addition complex is stabilized by mesomeric interactions and this is easily predicted from valence bond considerations. 2-Chloropyrazine 1-oxide is readily converted into 2-hydroxypyrazine 1-oxide (l-hydroxy-2(l//)-pyrazinone) (55) on treatment with dilute aqueous sodium hydroxide (63G339), whereas both 2,3-dichloropyrazine and 3-chloropyrazine 1-oxide are stable under these conditions. This reaction is of particular importance in the preparation of pyrazine-based hydroxamic acids which have antibiotic properties. 

In 2000, an efficient three-step procedure for the synthesis of 5-substituted 3-isoxazolols (without formation of undesired 5-isoxazolone byproduct) was published. The method uses an activated carboxylic acid derivative to acylate Meldrum s acid, which is treated with A,0-bis(ten-butoxycarbonyl)hydroxylamine to provide the N,0-di-Boc-protected P-keto hydroxamic acids 14. Cyclization to the corresponding 5-substituted 3-isoxazolols 15 occurs upon treatment with hydrochloric acid in 76-99% yield. 

The reaction with hydroxamic acid chlorides has been extensively used recently by Italian chemists to synthesize di- and poly-isoxa-zolyls, as exemplified by 5-substituted 3,3 -diisoxazolyIs (29). °... 

More recently, screening efforts at Novartis have identified a hydroxamic acid containing a benzothiazinone ring system (32) [108]. This inhibitor is very potent versus S. aureus Ni -PDF (<5nM) and displays good selectivity versus matrix metalloprotease-2 (MMP-2) and MMP-13. Unfortunately (32), and all other analogues prepared, such as carbon isosteres (33), sulfones (34), N-substituted analogues (35) and N-formyl-N-hydroxylamines (36), lacked appreciable antibacterial activity in spite of their potent enzyme inhibitory activity. Further studies performed by Novartis suggest that these molecules are unable to penetrate the outer cell membrane of E. coli, and may bind to the cell membrane of S. aureus [108]. 

Hydroxamic acids are an important class of compounds targeted as potential therapeutic agents. A-Fmoc-aminooxy-2-chlorotrityl polystyrene resin 61 allowed the synthesis and subsequent cleavage under mild conditions of both peptidyl and small molecule hydroxamic acids (Fig. 14) [70]. An alternative hydroxylamine linkage 62 was prepared from trityl chloride resin and tV-hydroxyphthalimide followed by treatment with hydrazine at room temperature (Scheme 30) [71]. A series of hydroxamic acids were prepared by the addition of substituted succinic anhydrides to the resin followed by coupling with a variety of amines, and cleavage with HCOOH-THF(l 3). 

Although the synthesis of 3-isoxazolols from P-keto esters and hydroxylamine suffers from the formation of 5-isoxazolones as major products, treatment of acyl chlorides with Meldrum s acid 4 followed by aminolysis gave rise to p-keto hydroxamic acids 6 that cyclised to the corresponding 5-substituted 3-isoxazolols 7 without formation of any byproduct <00JOC1003>. Cyclisation of N-substituted salicylhydroxamic acids 9 under... 

Abstract. The direct scale-up of a solid-phase synthesis has been demonstrated with 4-(2-amino-6-phenylpyrimidin-4-yl)benzamide and an arylsulfonamido-substituted hydroxamic acid derivative as examples. These compounds were obtained through combinatorial chemistry and solution-phase synthesis was used in parallel to provide a comparison. By applying highly loaded polystyrene-derived resins as the solid support, a good ratio between the product and the starting resin is achieved. We have demonstrated that the synthesis can be scaled up directly on the solid support, successfully providing the desired compounds easily and quickly in sufficient quantities for early development demands. 

As second example for the scale-up of solid-phase reactions directly on solid support, we chose an arylsulfonamido-substituted hydroxamic acid derivative stemming from the matrix metalloproteinase inhibitor library (MMP) of our research colleagues (Breitenstein et al. 2001). In this case, there was already a solution-phase synthesis available for comparison (see Scheme 4). The synthesis starts with the inline formation of a benzaldehyde 18 with the glycine methyl ester, which is then reduced to the benzylamine 20 using sodium borohydride in methanol/ THF (2 1). The sulfonamide formation is carried out in dioxane/H20 (2 1) with triethylamine as the base and after neutralisation and evaporation the product 21 can be crystallised from tert. butylmethyl ether. After deprotection with LiOH, the acid is activated by treatment with oxalyl chloride and finally converted into the hyroxamic acid 23 in 33.7% yield overall. 

Scheme 8. New route for the SPSS of hydroxamic acid derivative by nucleophilic substitution...

Breitenstein W, Hayakawa K, Iwasaki G, Kanazawa T, Kasaoka T, Koizumi S, Matsunaga S, Nakajima M, Sakaki J (2001) Preparation of arylsulfonamido-substituted hydroxamic acid derivatives as MMP2 inhibitors. Int Pat Appl... 

Thus the impact of hydroxamic ester substitution through nitrogen at the ester oxygen is to raise the acyloxyl carbonyls into the range for acid chlorides and acid anhydrides.128... 

Aldehyde 54 and the hydroxamic acids 55 were generated together in an acid-catalysed elimination reaction (Scheme 7 pathway (ii)). A crossover experiment indicated that esters are formed in a concerted rearrangement concomitant with the likely formation of the hydroxynitrene 57 (Scheme 7 pathway (iii)) while there is no evidence to date for the formation of hydroxynitrene, joint solvolysis of equimolar quantities of /V-acetoxy-/V-butoxy-/>-chlorobenzamide 26e and N- acetoxy-/V-benzyloxybenzamide 27a afforded significant quantities of butyl p-chlorobenzo-ate (36%) and benzyl benzoate (54%) as the only esters. This is an example of a HERON reaction, which has been identified in these laboratories as a characteristic rearrangement of bisheteroatom-substituted amides.32,33,42 43 155 158 Since ester formation was shown to prevail in neutral or low acid concentrations, it could involve the conjugate anion of the hydroxamic acid (vide infra).158... 

The development of transition metal mediated asymmetric epoxidation started from the dioxomolybdcnum-/V-cthylcphcdrinc complex,4 progressed to a peroxomolybdenum complex,5 then vanadium complexes substituted with various hydroxamic acid ligands,6 and the most successful procedure may now prove to be the tetroisopropoxyltitanium-tartrate-mediated asymmetric epoxidation of allylic alcohols. 

Benzamides e.g. MS-275 8 are one of the more common hydroxamic acid alternatives but are often less potent. Recent exceptions to this pattern include substituted pyridyl [29] and thiazolyl [30] benzamides, such as 9 and 10 with HDAC1 enzyme IC50s of 19nM and 29 nM, respectively and series of benzamides substituted with other heterocycles, such as indazoles [31] and benzo [l,2,4]thiadiazines [32], many with HDAC2 IC50s of <50 nM. The addition of... 

FIGURE 2.11 Structures and nomenclature of compounds that serve as auxiliary nucleophiles. Generation of activated esters. Substituted hydroxamic acids are sometimes added to carbodi-imides or other reactions to improve the efficiency of couplings. The additive suppresses side reactions by converting activated species into activated esters (see Section 2.10) before they have time to undergo secondary reactions, p(Me2SO) HOBt 9.30, HOAt 8.70. 

Nitrosobenzenes react with the carbonyl group of aldehydes to yield hydroxamic acids 73, according to reaction 20. Recently, the reactions between some X-substituted nitrosobenzenes (X = H, p-Me, p-C 1, m-Cl, p-Br) and formaldehyde were reported194 in order to investigate the mechanism of the hydroxamic acid formation. The mechanism reported in Scheme 9 involves a first equilibrium yielding the zwitterionic intermediate 74 which rearranges (by acid catalysis) into hydroxamic acid 75. The presence of a general acid catalysis, the substituent effect (p values of the Hammett equation equal —1.74),... 

A group at Lilly reported that phenoxazine (89) is a potent inhibitor of cRBL (0.02 iM) [237]. Substitution at the 1-position by carboxylic acid, ester, or hydroxamic acid groups decreased potency 10- to 30-fold. Substitution at the 2-position was less destructive of inhibition as long as the substituent was lipophilic (ester, acrylate ester) carboxylate caused a 200-fold loss of potency. Activity in rat neutrophils has been disclosed for related structures in patents from Bayer [238]. The second aromatic ring is not required, as shown by the activity of series exemplified by (90)-(92) [239-242]. Antiasthmatic activity was indicated for these compounds, but few details were given. 

---