Precautions hydrogen

Hydrogen chloride. Method 1 from concentrated sulphuric acid and fused ammonium chloride). The most convenient procedure is to allow concentrated sulphuric acid to react with lumps of fused ammonium chloride in a Kipp s apparatus. The gas may be dried by passage through a wash bottle containing concentrated sulphuric acid the latter should be followed by an empty wash bottle or flask as a precaution against sucking back of the contents of the reaction vessel. 

Place 50 g. (57 ml.) of dry A.R. benzene and 0 5 ml. of dry p rridine (1) (dried over potassium hydroxide pellets) in a 500 ml. round-bottomed flask. Attach a reflux condenser to the flask and an inverted funnel (just dipping into some water in a beaker) to the top of the condenser (Fig. II, 13, 8, b). Partially immerse the flask in a bath of cold water, supported upon a tripod and gauze. Carefully pour 125 g, (40 ml.) of bromine (for precautions to be taken with bromine, see Section 111,35, Note 1) through a condenser and immediately insert the absorption device into the upper end of the condenser. A vigorous reaction soon occurs and hydrogen bromide is evolved which is absorbed by the water in the beaker when the reaction slackens, warm the bath to 25-30° for... 

Most hafnium compounds requite no special safety precautions because hafnium is nontoxic under normal exposure. Acidic compounds such as hafnium tetrachloride hydroly2e easily to form strongly acidic solutions and to release hydrogen chloride fumes, and these compounds must be handled properly. Whereas laboratory tests in which soluble hafnium compounds were injected into animals did show toxicity, feeding test results indicated essentially no toxicity when hafnium compounds were taken orally (33,34). 

Criticality Precautions. The presence of a critical mass of Pu ia a container can result ia a fission chain reaction. Lethal amounts of gamma and neutron radiation are emitted, and a large amount of heat is produced. The assembly can simmer near critical or can make repeated critical excursions. The generation of heat results eventually ia an explosion which destroys the assembly. The quantity of Pu required for a critical mass depends on several factors the form and concentration of the Pu, the geometry of the system, the presence of moderators (water, hydrogen-rich compounds such as polyethylene, cadmium, etc), the proximity of neutron reflectors, the presence of nuclear poisons, and the potential iateraction with neighboring fissile systems (188). As Httle as 509 g of Pu(N02)4 solution at a concentration Pu of 33 g/L ia a spherical container, reflected by an infinite amount of water, is a critical mass (189,190). Evaluation of criticaUty controls is available (32,190). 

Isobutyronitrile (2-methylpropionitrile, isopropyl cyanide) [78-82-0] M 69.1, b 103.6 , d 0.7650, n 1.378. Shaken with cone HCl (to remove isonitriles), then with water and aq NaHC03. After a preliminary drying with silica gel or Linde type 4A molecular sieves, it is shaken or stirred with CaH2 until hydrogen evolution ceases, then decanted and distd from P2O5 (not more than 5g/L, to minimize gel formation). Finally it is refluxed with, and slowly distd from CaH2 (5g/L), taking precautions to exclude moisture. 

Fig. 20-4 Safety precautions for water tanks (a) and filter tanks (b) to prevent danger of explosion from hydrogen.

Trace impurities in the feed streams can lead to combination of an oxidant with a flammable material (e.g. acetylene in liquid oxygen, solid oxygen in liquid hydrogen) and precautions must be taken to eliminate them. 

Some special precautions for use of compressed hydrogen chloride gas include ... 

Chlorine is a highly toxic gas, and strict precautions are necessary to minimize risk to workers and possible releases during its handling. Major sources of fugitive air emissions of chlorine and hydrogen are vents, seals, and transfer operations. 

Because of the hazardous nature of anhydrous hydrogen fluoride, adequate precautions should he taken to protect the head, eyes, and skin. Rubber gloves, an apron, and a plastic face mask are strongly recommended. All operations should be carried out in a hood. If hydrogen fluoride comes in contact with the skin, the contacted area should be thoroughly washed with water and then immersed in ice water while the patient is taken to a physi-... 

---