Hydrocracker feedstocks

Also, water removal from hydrocracker feedstock is essential to help ensure that the catalyst does not dissolve and collapse. Filtration through molecular sieve or silica gel will help to remove water. Some hydrocracking processes, however, can tolerate up to 500 ppm of water in the feedstock. 

During the last decade, there has been a definite trend towards heavier hydrocracker feedstocks (2). Recognition of the interactions between feed molecular weight and catalyst chemical and physical properties has been necessary to support this trend. 

Hydrocracker feedstocks Avoid metals deposition Avoid coke buildup Avoid catalyst destruction... 

The volatile products from the soaking drum enter the fractionator where the distillates are fractionated into desired product oil streams, including a heavy gas oil fraction. The cracked gas product is compressed and used as refinery fuel gas after sweetening. The cracked oil product after hydrotreating is used as fluid catalytic cracking or hydrocracker feedstock. The residuum is suitable for use as boiler fuel, road asphalt, binder for the coking industry, and as a feedstock for partial oxidation. 

Comparing the overall concentrations of these different carbons designated generally as structural patterns , measured before and after a process such as FCC or hydrocracking (see Chapter 10), enables the conversion to be monitored the simple knowledge of the percentage of condensed aromatic carbon of a feedstock gives an indication of its tendency to form coke. 

Feedstocks for this very flexible process are usually vacuum distillates, deasphalted oils, residues (hydrotreated or not), as well as by-products from other processes such as extracts, paraffinic slack waxes, distillates from visbreaking and coking, residues from hydrocracking, converted in mixtures with the main feedstock. 

In two stages with recycle to the second stage, the conversion per pass is approximately 50 wt. % and the selectivity to middle distillates is maximal 75 to 80 wt. %. However, the investment is clearly higher and is justified only when feedstocks are difficult to convert and that their content in nitrogen is high. Figure 10.11 represents two variants of the hydrocracking process. 

Typical feedstock composition, yields and product properties for a hydrocracking unit (to be continued). 

Mild hydrocracking prepares the feedstock for catalytic cracking or for the conventional lubricant production scheme. 

Typical Feedstocks composition, performance and product properties from mild hydrocracking. I... 

The question then lies in the selection of more appropriate feedstocks for these two processes. The cost of hydrocracking leads to selecting feedstocks that are the easiest to convert as for catalytic cracking, its flexibility and extensive capabilities lead to selection of heavier feedstocks. 

Of the main reactions, aromatization takes place most readily and proceeds ca 7 times as fast as the dehydroisomerization reaction and ca 20 times as fast as the dehydrocyclization. Hence, feeds richest in cycloparaftins are most easily reformed. Hydrocracking to yield paraffins having a lower boiling point than feedstock proceeds at about the same rate as dehydrocyclization. 

Hydrocracking. Hydrogenolysis of a carbon—carbon bond in an organic molecule produces smaller, hydrogen-saturated molecules and is termed hydrocracking when 50% or more of the feedstock is converted into smaller molecules. 

Shell Gas B.V. has constructed a 1987 mVd (12,500 bbhd) Fischer-Tropsch plant in Malaysia, start-up occurring in 1994. The Shell Middle Distillate Synthesis (SMDS) process, as it is called, uses natural gas as the feedstock to fixed-bed reactors containing cobalt-based cat- yst. The heavy hydrocarbons from the Fischer-Tropsch reactors are converted to distillate fuels by hydrocracking and hydroisomerization. The quality of the products is very high, the diesel fuel having a cetane number in excess of 75. 

---