Hydrazones from ketones and aldehydes

Enamines derived from ketones are allylated[79]. The intramolecular asymmetric allylation (chirality transfer) of cyclohexanone via its 5-proline ally ester enamine 120 proceeds to give o-allylcyclohexanone (121) with 98% ee[80,8l]. Low ee was observed in intermolecular allylation. Similarly, the asymmetric allylation of imines and hydrazones of aldehydes and ketones has been carried out[82]. 

Enolates derived from various imino compounds have been sulfinylated in reactions analogous to those shown by equations (14) and (15). Some representative examples are shown in equations 16-18. Here again, these compounds have been utilized in asymmetric syntheses. Addition of sulfinate ester 19 to a THF suspension of a-lithio-N,N-dimethylhydrazones, derived from readily available hydrazones of aldehydes and ketones, leads to a-sulfinylhydrazones in good yield, e.g. 53 and 54 (equations 16 and 17)85,86. Compounds 53 and 54 were obtained in a 95/5 and 75/25 E/Z ratio, respectively. The epimer ratio of compound 53 was 55/45. Five other examples were reported with various E/Z and epimeric ratios. 

Hydrazine is hypergolic with cone, nitric acid [1]. Of a series of hydrazones and azines derived from aldehydes and ketones, only those which decomposed when heated alone were hypergolic with the acid when heated at 12.5°C/min [2], Solid hydrazones formed from various aldehydes with dimethylhydrazine or phenylhydrazine are hypergolic with the acid [3],... 

Alkyl- and aryl-hydrazones of aldehydes and ketones readily peroxidise in solution and rearrange to azo hydroperoxides [1], some of which are explosively unstable [2], Dry samples of the p-bromo- and p-fluoro-hydroperoxybenzylazobenzenes, prepared by oxygenation of benzene solutions of the phenylhydrazones, exploded while on filter paper in the dark, initiated by vibration of the table or tapping the paper. Samples were later stored moist with benzene at —60°C to prevent explosion [3], A series of a-phenylazo hydroperoxides derived from the phenyl-or p-bromophcnyl-hydrazones of acetone, acetophenone or cyclohexanone, and useful for epoxidation of alkenes, are all explosive [4], The stability of several substituted phenylazo hydroperoxides was found to be strongly controlled by novel substituent effects [5],... 

Homochiral strained allylsilacycles 24 are valuable for uncatalyzed enantioselective allylation of (V-acy I hydrazones derived from aldehydes and ketones (Equation (32)).133,133a The crotylation using 24b and 24c occurs in the same stereospecific manner as observed in the DMF-promoted crotylation using crotyltrichlorosilanes. A cyclic transition state similar to 22 is reasonable also in the allylation using 24. 

Functional groups containing the C = N bond, such as hydrazones, oximes and diazo compounds, can also be used in the synthesis of fluorinated derivatives and these reactions are the subject of this section. The reaction products in these procedures are usually the corresponding g cw-difluoromethylene compounds. Since oximes and hydrazones arc obtained from aldehydes and ketones, these reactions can be considered as an alternative to the direct transformation of a carbonyl group into the difluoromethylene group. As indicated in Section... 

Alkylations of hydrazone anions derived from aldehydes and ketones are closely related to imine anion alkylations. Lithiated hydrazones are particularly powerful nucleophiles for alkylation reactions. The alkylated hydrazones may be cleaved with periodate, as shown below.The choice of solvent and base is critical to the success of hydrazone alkylations hexane-free medium is essential for complete metalation. °... 

Regiospecific alkylation of dimethylhydrazone anions with the masked acrolein equivalent, 3-bromo-propionaldehyde dimethyl acetal, has brcn used as an alternative to a conventional Michael reaction in Corey s total synthesis of picrotoxinin (c/. equation 13). Azaallyllithium reagents derived from aldehyde and ketone hydrazones, unlike enolates, yield monoalkylation products with control of both regio-chemistry and stereochemistry. In appropriate cases, alkylation followed by deprotection to form a dicarbonyl product can be a very effective synthetic strategy. 

Hydrazones are aldehyde and ketone equivalents as well as imines. Their stability is much higher than imines and actually hydrazones derived from aliphatic aldehydes are often crystalline and can be isolated and stored at room temperature. However, their reactivity as electrophiles is known to be low, and there have been many fewer reports on the reactions of hydrazones with nucleophiles than those of imines [45,46]. 

Dinitrophenylhydra2ones usually separate in well-formed crystals. These can be filtered at the pump, washed with a diluted sample of the acid in the reagent used, then with water, and then (when the solubility allows) with a small quantity of ethanol the dried specimen is then usually pure. It should, however, be recrystallised from a suitable solvent, a process which can usually be carried out with the dinitrophenylhydrazones of the simpler aldehydes and ketones. Many other hydrazones have a very low solubility in most solvents, and a recrystallisation which involves prolonged boiling with a large volume of solvent may be accompanied by partial decomposition, and with the ultimate deposition of a sample less pure than the above washed, dried and unrecrystal-lised sample. 

Hydrazinopyridazines are easily formylated with formic acid or ethyl formate and acety-lated with acetic anhydride. A-Pyridazinylthiosemicarbazides are obtained from thiocyanates or alkyl- and aryl-isothiocyanates. Hydrazinopyridazines condense with aliphatic and aromatic aldehydes and ketones to give hydrazones. 

When present in macro quantities, aldehydes and ketones can be determined by conversion to the 2,4-dinitrophenylhydrazone which can be collected and weighed. When present in smaller quantities (10 3M or less), although hydrazone formation takes place, it does not separate from methanol solution, but if alkali is added an intense red coloration develops the reagent itself only produces a slight yellow colour. Measurement of the absorbance of the red solution thus provides a method for quantitative determination. 

An excellent synthetic method for asymmetric C—C-bond formation which gives consistently high enantioselectivity has been developed using azaenolates based on chiral hydrazones. (S)-or (/ )-2-(methoxymethyl)-1 -pyrrolidinamine (SAMP or RAMP) are chiral hydrazines, easily prepared from proline, which on reaction with various aldehydes and ketones yield optically active hydrazones. After the asymmetric 1,4-addition to a Michael acceptor, the chiral auxiliary is removed by ozonolysis to restore the ketone or aldehyde functionality. The enolates are normally prepared by deprotonation with lithium diisopropylamide. 

This silyl hydrazone formation-oxidation sequence was originally developed as a practical alternative to the synthesis and oxidation of unsubstituted hydrazones by Myers and Furrow [31]. The formation of hydrazones directly from hydrazine and ketones is invariably complicated by azine formation. In contrast, silyl hydrazones can be formed cleanly from /V,/V -bis(7< rt-butyldimethylsilyl)hydrazine and aldehydes and ketones with nearly complete exclusion of azine formation. The resulting silylhydrazones undergo many of the reactions of conventional hydrazones (Wolff-Kishner reduction, oxidation to diazo intermediate, formation of geminal and vinyl iodides) with equal or greater efficiency. It is also noteworthy that application of hydrazine in this setting may also have led to cleavage of the acetate substituents. 

---