Hexane-1-thiol

The highest interfacial electron transfer rate constant yet reported (about 14,000 s ) is for a c-type cytochrome from Aquifex aolicus This protein has a 62-amino acid linker domain by which it is usually anchored to the periplasmic side of the inner membrane this linker has a cysteine as the terminal residue before the signal region, and the sulfur atom provides an anchor point. The cytochrome adsorbs strongly onto a Au electrode that is already modified with a hexane-thiol SAM (note this requires that the molecules in the SAM move or vacate to allow this). The results are striking. 

Finally,Captopril is produced. Thethioester (0.85g) isdissolved in5.5N methanolicammonia and the solution is kept at room temperature for 2 hours. The solvent is removed in vacuo and the residue Is dissolved in water, applied to an ion exchange column on the H cycle (Dowex 50, analytical grade) and eluted with water. The fractions that give positive thiol reaction are pooled and freeze dried. The residue Is crystallized from ethyl acetate-hexane, yield 0.3 g. The 1 -(3-mercapto-2-D-methylpropanoyl)-L-proline has a melting point of 103°C to 104°C. 

Other excellent results have been reported by Kang et al. for the addition of ZnEt2 to aldehydes by using chiral cyclic amino thiol ligands depicted in Scheme 3.7. A total enantioselectivity was obtained when (lR,25)-l-phenyl-2-piperidinopropane-1-thiol was used as the ligand in the reactions of substituted benzaldehydes. However, -hexanal and traw -cinnamaldehyde could only be... 

A variety of solvents was investigated for this reaction, as shown in Table 15.1. As inferred from Table 15.1, the hydrogenolysis performance is best in more polar solvents snch as acetonitrile, acetone, ethyl acetate, and acetic acid. Only in o-dichlorobenzene is the rate of reaction ranch lower than predicted by the dielectric constant. The presence of nonpolar solvents snch as hexane and the thiol product resulted in large amonnts of the disnlfide intermediate. It has been shown that the disnlfide is the intermediate in stoichiometric rednctions such as samarium diiodide reduction of alkyl thiocyanates to thiols (11) so it is reasonable to expect it as the... 

Sulfur insertion into thiols RSH to give symmetrical trisulfides in high purity is easily accomplished by diimidazolylsulfide (reaction conditions hexane, 0-25 °C, 0.5-2 h).[34]... 

The isolation of product is usually possible after evaporation of the solvent and extraction with hexane, ether, or toluene. Supported versions, for example on polystyrene grafted with PPh2 groups, have proved unsatisfactory because the rate of deactivation is greatly enhanced under these conditions [37]. Asymmetric versions exist, but the ee-values tend to be lower than in the Rh series [38]. With acid to neutralize the basic N lone pair, imine reduction is fast. Should it be necessary to remove the catalyst from solutions in order to isolate a strictly metal-free product, a resin containing a thiol group should prove satisfactory. A thiol group in the substrate deactivates the catalyst, however. 

The reduction of 2-methylthiophene, however, yielded only small amounts of dihydro-2-methylthiophene and a high yield of pcntcnethiol. It was apparent that substitution in the 2-position inhibited the production of the dihydrothiophene and favored more complete reduction. It was interesting to note that the reduction of 2,5-dimethylthiophene furnished small amounts of hexan-2-one. It was believed that the crude hexenethiol probably contained some hexene-2-thiol-2 which is capable of isomerization to hexane 2-thione from which the ketone can be formed by the action of alkali as follows ... 

To the sodium cycloalkane- or -arenethiolate (20 mmol), preferably freshly prepared from the respective thiol with NaH in THF, in 1.3-dimethylimidazolidin-2-one (DMEU) (15 mL) flushed with N2 or argon was added perfluorinated Decalin (0.5 mmol). The mixture was stirred at ca. 65 C for the indicated time, then poured into toluene (50 mL) and washed with H20 (10x 300mL). The organic phase was dried (Na2S04) and the solvent evaporated. The crude residue was dissolved in CHC12 and purified by preparative TLC (silica gel, CHCl3/hexane 3 1). 

Tomioka et al. reported the asymmetric Michael addition of lithium thiolates catalyzed by chiral aminoether 31 (Scheme 8D. 18) [39]. Thus, in the presence of catalytic amounts of 31 (10 mol %) and lithium 2-(trimethylsilyl)thiophenolate 32-Li (8 mol %), thiol 32 (3 equiv.) reacted with a,p-unsaturated esters at -78°C in toluene-hexane solvent to give the Michael adduct with up to 97% ee. In the ahsence of 31, the reaction of thiophenol proceeded in only 0.5% yield at room temperature. A monomeric complex consisting of 31 and lithium is proposed as the key reactive species in this asymmetric reaction. The trimethylsilyl group at the ortho-po-sition of the thiol moiety in 32 contributes to the formation of the stereochemically defined monomeric chelated structure, wherein the lithium cation is coordinated with the three heteroatoms of the tridentate ligand 31. The reactions of acyclic /nmv-a,P-unsaturated esters (R1 = Me, Et, Pr, Bu, Bu, PhCH9 R2 = H) proceeds with high enantioselectivity in... 

---