Heat exchangers water

Wastage is pronounced in equipment contacting high-pH fluids. Chemical process equipment, heat exchangers, water-cooled process reactors, valving, transfer pipes, and heating and cooling systems are often affected. 

Chemicals, acid or alkaline solution in process tanks Heat-exchanger water boxes with non-ferrous tube plates and 53-8-269-0... 

Heat exchanger - water side 5-10 psi Water side pressure drop. 

Galvanic anode systems are generally used in well-coated electrically isolated structures, offshore structures, ship hulls, hot-spot pipeline protection, heat exchanger water boxes and other environments of resistivity below 10000 Q cm. 

Water-to-water heat exchanger Finned-tube heat exchanger, water in 150-300 850-1700... 

Figure 3. Changes in light intensity(A) and temperatures of ambient,culture broth and heat exchanger water in the water bath(B) in the cone-shaped helical tubular photobioreactor outdoor culture experiment (Data of 1996.7.19.)...

Nylasan. [Akzo] Acrylic emulsion reduces and prevents s e and sludge in digesters, evaporamrs, heat exchanges, water, lines, and cooling towers. 

Figure 10. Poorhj maintained heat exchanger water passages clogged by silt, corrosion products, and other insoluble impurities...

The temperature of the water in the seal assembly is maintained within acceptable limits by a water-cooled heat exchanger. Water is also injected into the seal area from an external seal injection system. The performance of the shaft seal system is monitored by pressure and temperature sensing devices in the seal system. The seal assembly can be replaced without draining the pump casing or removing the shaft. 

Energy Balance on a Flow System with a Pump and Heat Exchanger. Water... 

A better method of replicating the hydrodynamics and thermal conditions of critical operating equipment is a test heat exchanger, using a small side stream of water from the coohng tower water circuit. This technique is more complex and expensive as a result, it has been used less extensively than the techniques described previously. In a test heat exchanger, water flow and heat flux can be controlled. If... 

Example 6-1 In a heat exchanger, water flows through a long copper tube (inside diameter 2.2 cm) with an average velocity of 2.13 m/sec. The water is heated by steam condensing at 150°C on the outside of the tube. Water enters at 15°C and leaves at 60°C. What is the heat transfer coefficient, h, for the water ... 

The steam generators are divided into two sections, the evaporator below and the steam drum above. The evaporator consists of a U-tube heat exchanger. Water of the primary coolant, at a temperature of 321 C, flows through the tubes, which are made from Inconel. The flow in the secondary circuit is upward through the tube bundle, the steam-water mixture passing... 

BETZ Slimicide C-58P aids in the control of bacterial, fungal and algal slimes in evaporative condensers, heat exchange water systems, commercial and industrial cooling towers, influent systems such as flow through, infilco units, filters, lagoons, etc., industrial water scrubbing systems and brewery pasteurizers. 

---