Hard technology

This in itself draws attention to one of the artistic aspects of the industrial catalyst designer s job. Money values are neither absolute, invariant, nor always logically desirable entities. For example, resource producing nations can increase feedstock prices and they may do so for political rather than for hard, technological reasons. One very important consequence is the fact that a catalytic process that is economic in one year but not in the next is not as attractive as one that can adapt. 

The technologies required for the first path are called hard technologies, and those of the second soft technologies. The characteristics of the soft technologies are these ... 

Restored parameters for the evaluation of PDSM, may be different PMF of material tensor of stresses or its invariants, spatial gradients of elastic features (in particular. Young s modulus E and shear modulus G), strong, technological ( hardness HRC, plasticity ), physical (density) and others. 

Thin-film media can be made by various technologies, eg, sputtered deposited Co—Cr—X films for longitudinal appHcations, laminated media for hard disk apphcation, metal evaporated tape, and multilayers for possible appHcations in magnetooptic recording. 

Lead Telluride. Lead teUuride [1314-91 -6] PbTe, forms white cubic crystals, mol wt 334.79, sp gr 8.16, and has a hardness of 3 on the Mohs scale. It is very slightly soluble in water, melts at 917°C, and is prepared by melting lead and tellurium together. Lead teUuride has semiconductive and photoconductive properties. It is used in pyrometry, in heat-sensing instmments such as bolometers and infrared spectroscopes (see Infrared technology AND RAMAN SPECTROSCOPY), and in thermoelectric elements to convert heat directly to electricity (33,34,83). Lead teUuride is also used in catalysts for oxygen reduction in fuel ceUs (qv) (84), as cathodes in primary batteries with lithium anodes (85), in electrical contacts for vacuum switches (86), in lead-ion selective electrodes (87), in tunable lasers (qv) (88), and in thermistors (89). 

The polymers exist in saline solution as tightly coiled chains and are readily adsorbed owing to relatively low solubiUty in hard water. Subsequent injection of soft, low salinity water uncoils the adsorbed polymer chains increasing water viscosity and reducing rock permeabiUty. This technology could also be used to reduce the permeabiUty of thief 2ones adjacent to injection wells. However, mechanical isolation of these 2ones may be necessary for cost-effective treatments. 

---