Fundamental constants tabulated

The entropy at all temperatures (0-6000 K) agrees within 0.001 J K" mol" with the values of Gurvlch et al. (8 ) except for one minor difference. The entropy differs by 0.1094 J K" mol because this table uses a standard-state pressure of 1 bar, whereas the tabulation of Gurvich et al. (8 ) is based on 1 atm. The estimated uncertainty is due to uncertainties in the relative ionic mass and the fundamental constants which are based on the 1981 scale (9) and the 1973 values (7), respectively. 

Fundamental constants are discussed in the text and are tabulated in Appendix A. 11. 

These ko values are fundamental constants and may be found in tabulations by using two or three carefully selected comparators rather than one it is possible to account for the influence of differences in neutron flux spectra on the calibration factors. The ko values are independent of the half-life of the indicators, and there is no reason why this method could not be applied to PGNAA as well [12]. 

In some cases conversion factors had to be used to give the tabulated parameters in the quoted units. These factors have been calculated with the fundamental constants given in 1. But the accuracy of the measured magnetic constants is not sufficient to differentiate between earlier used fundamental constants. 

IVTANTHERMO consists of several databases and a set of algorithms and programs. The databases contain auxiliary data, for example, fundamental physical constants, atomic masses of elements etc. -, constants necessary for the calculations of thermodynamic functions primary experimental data on equilibrium constants of chemical reactions and on saturated vapor pressure of substances thermochemical constants tabulated values of thermodynamic properties for wide temperature intervals. 

Tabulate the transition frequencies and fit them to Eq. (11) using a least-squares method. Since this is a parallel transition between two 2 states, / and / are zero in this equation. (If a perpendicular fundamental such as is to be analyzed, a value of r = = should be substituted.) Compare your rotational constants for the ground state... 

The present third edition has been substantially revised and extended with new sections (e.g. on uncertainty) compared to the second edition. The most accurate recent fundamental physical constants and atomic masses are tabulated. The symbol as well as the subject index has been extended considerably to facilitate the usage of the Green Book. A table of numerical energy conversion factors is given and the most recent lUPAC periodic table of the elements is given on the inside back cover. 

Maryott, A. A., and Buckley, E, U. S. National Bureau of Standards Circular No. 537, 1953. A tabulation of dipole moments, dielectric constants, and molar refractions measured between 1910 and 1952, and used here to determine polarizabilities if no more recent result exists. The polarizability is 3/(4ttA/ ) times the molar polarization or molar refraction, where is Avogadros number. The value 3/(4tiA/ ) = 0.3964308 x 10 cm was used for this conversion. A dagger (t) following the reference number in the tables indicates that the polarizability was derived from the molar refraction and hence may not include some low-frequency contributions to the static polarizability these static polarizabilities are therefore low by 1 to 30%. Hirschfelder, J. O., Curtis, C. E, and Bird, R. B., Molecular Theory of Gases and Liquids, Wiley, New York, 1954, p. 950. Fundamental information on molecular polarizabilities. 

For multicomponent mixtures, graphical representations of properties, as presented in Chapter 3, cannot be used to determine equilibrium-stage requirements. Analytical computational procedures must be applied with thermodynamic properties represented preferably by algebraic equations. Because mixture properties depend on temperature, pressure, and phase composition(s), these equations tend to be complex. Nevertheless the equations presented in this chapter are widely used for computing phase equilibrium ratios (K-values and distribution coefficients), enthalpies, and densities of mixtures over wide ranges of conditions. These equations require various pure species constants. These are tabulated for 176 compounds in Appendix I. By necessity, the thermodynamic treatment presented here is condensed. The reader can refer to Perry and Chilton as well as to other indicated sources for fundamental classical thermodynamic background not included here. 

The Michaehs constant is a fundamental characteristic of an enzyme that incorporates important information about the enzyme. First, it gives the concentration of substrate necessary to bind to half of the available sites on the enzyme. Second, it gives an index of the relative binding affinity of the substrate to the active sites on the enzyme. Michaehs constants have been determined and tabulated for a large number of enzymes. Since is actually a concentration, the values are usually expressed in mM units. 

A tabulation of the 1986 CODATA Recommended Values of the Fundamental Physical Constants. 

---