Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Freeze-pump-thaw cycle

Isobutene [115-11-7] M 56.1, b -6.6 /760mm. Dried by passage through anhydrous CaS04 at 0°. Purified by freeze-pump-thaw cycles and trap-to-trap distn. [Pg.271]

Methyl nitrate [598-58-3] M 77,0, b 65 /760mm, d 1.2322, d 1,2167, d 5 1,2032. Distd at -80°. The middle fraction was subjected to several freeze-pump-thaw cycles. VAPOUR EXPLODES ON HEATING. [Pg.295]

Can be purified by zone melting or by distn under vacuum at 0 , subjecting the middle fraction to several freeze-pump-thaw cycles. An impure sample containing higher nitroalkanes and traces of cyanoalkanes was purified (on the basis of its NMR spectrum) by crystn from diethyl ether at -60° (cooling in Dry-ice)(Parrett and Sun J Chem Educ 54 448 7977]. [Pg.311]

Alternatively the gas is passed over CuO pellets at 300° to remove hydrogen and hydrocarbons, over Ca chips at 600° to remove oxygen and, finally, over titanium chips at 700° to remove nitrogen. Also purified by freeze-pump-thaw cycles and by passage over sputtered sodium [Arnold and Smith J Chem Soc, Faraday Trans 2 77 861 1981]. [Pg.396]

Methanol (certified A.C.S., purchased from Fisher Scientific) was distilled from Mg(OMe)2 and was degassed by three freeze-pump-thaw cycles prior to use. [Pg.33]

Poly(styrene) and PMMA were synthesized from their respective monomers using azobisisobutyronitrile-initiated radical polymerization in benzene. Four freeze-pump-thaw cycles were used to degas the monomer solutions and polymerization was carried out for 48 hours at 60°C. The polymers were purified by multiple reprecipitations from dichloromethane into methanol. Films of these polymers were prepared and found to be free of any fluorescent impurity. [Pg.61]

Methoxy-2 -methylbiphenyl. o-Tolylboronic acid, 10.0 g (73.6 mmol) (Note 1), 16.8 g (71.8 mmol) of 4-iodoanisole (Note 2), and 200 mL of acetone (Note 3) are combined in a 1-L, three-necked flask equipped with an efficient stirbar, two stoppers, and a reflux condenser attached to a gas-flow adapter with a stopcock. Potassium carbonate, 25.0 g (0.180 mol), is dissolved in 200 mL of water (Note 4) in a separate 250-mL Schlenk flask. In a third flask (25-mL Schlenk flask) 3.30 mg (0.02 mmol, 0.2%) of palladium acetate (Note 5) is dissolved in 10 mL of acetone. All three flasks are then thoroughly degassed by four freeze-pump-thaw cycles. Under an argon back flow, one of the stoppers on the three-necked flask is replaced with a rubber septum, and the carbonate and catalyst solutions are added via cannula to form a biphasic mixture. The top layer turns brown upon addition of the catalyst. The septum is... [Pg.178]

Under an inert atmosphere, a solution of the substrate in benzene was added to a slurry of freshly purified CuCl (5 mol%), Me2PPh (6 equiv./Cu), and t-butanol (10 equiv./Cu) in benzene (final concentration 0.4-0.8 M in substrate). After degassing with one freeze-pump-thaw cycle, the suspension was placed under a slight positive pressure of hydrogen and allowed to stir until completion, as monitored by TLC. The product was isolated and purified as described above. [Pg.181]

OEP deuterated at the meso positions was obtained by keeping OEP in concentrated D2SO for 24 h (31). All samples were thoroughly degassed by freeze-pump-thaw cycles on a high vacuum line. [Pg.220]

A further advantage of this catalytic system is that the organic cycloadducts can be easily separated from the aqueous phase, allowing the catalyst solution to be isolated and directly reused. The catalyst retains its activity for the cycloaddition through several separate uses. As illustrated for the conversion of 108 to 109, the yield of the cycloaddition remained approximately constant for five reuses of the catalyst and decreased only with the sixth use (Tab. 13.9). With alkynoate substrate 94, the experiment was repeated with rigorous deoxygenation (by freeze-pump-thaw cycles) of the catalyst solution between uses, and it was found to function cleanly after eight uses (Tab. 13.8, entry 4). [Pg.277]

Toluene is first distilled from sodium benzophenone ketyl under argon. Prior to the reaction, the toluene is degassed by performing two freeze-pump-thaw cycles, then the flask is backfilled with argon. [Pg.71]

Materials. An H-ZSM-5 type zeolite (overall Si/Al = 33.5) was provided by DEGUSSA, Wolfgang, F.R.G. The well-shaped crystallites had an average size of 8.8 p x 5.2 p x 3.2 y. Pyridine, benzene and ethylbenzene were from MERCK, Darmstadt, F.R.G., spectroscopic grade, purified by distillation as well as repeated freeze-pump-thaw cycles and finally stored over highly activated 3A molecular sieve pellets. [Pg.214]

All test solutions, except otherwise mentioned, were degassed by hree freeze-pump-thaw cycles with a vacuum line operated under 10 torr pressure. Problems of background fluorescence originating from sulfonates themselves could be adequately minimized by proper choice of probe/sulfonate ratios. The excitation wavelength was set at 340 nm. Emission spectra were obtained in constant energy mode. The spectral resolution was 3 nm. [Pg.91]

Mixing equal concentrations of two separately prepared solutions of colloidal lead and silver particles (each degassed by repeated freeze-pump-thaw cycles on a high-vacuum line and mixed under vacuum) resulted in a slow blue shift of the silver plasmon band from 390 nm to 337 nm and a concomitant broadening... [Pg.109]

After bake-out, the glassware is allowed to cool to room temperature. Breakseal 2 is broken, and monomer in A is degassed by successive freeze-pump-thaw cycles. The thoroughly degassed monomer is then distilled onto the silica gel in B by surrounding that vessel with an ice-water bath. When sufficient monomer has been transferred, the contents of A and B are frozen, and A is removed from the manifold by flame sealing. [Pg.183]

The middle fraction was subjected to several freeze-pump-thaw cycles. VAPOUR EXPLODES ON HEATING. [Pg.271]


See other pages where Freeze-pump-thaw cycle is mentioned: [Pg.29]    [Pg.294]    [Pg.339]    [Pg.10]    [Pg.440]    [Pg.2]    [Pg.146]    [Pg.424]    [Pg.108]    [Pg.66]    [Pg.26]    [Pg.88]    [Pg.48]    [Pg.190]    [Pg.32]    [Pg.372]    [Pg.157]    [Pg.647]    [Pg.150]    [Pg.15]    [Pg.122]    [Pg.10]    [Pg.14]    [Pg.15]    [Pg.16]    [Pg.270]    [Pg.17]    [Pg.270]   
See also in sourсe #XX -- [ Pg.113 ]

See also in sourсe #XX -- [ Pg.477 ]




SEARCH



Freeze-pump-thaw

Freeze-thaw cycles

Freeze-thawing

Freezing freeze-thaw cycles

Pump cycle

Thawing

© 2024 chempedia.info