Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Franck transition

Franck-Condon principle According to this principle the time required for an electronic transition in a molecule is very much less than the period of vibration of the constituent nuclei of the molecule. Consequently, it may be assumed that during the electronic transition the nuclei do not change their positions or momenta. This principle is of great importance in discussing the energy changes and spectra of molecules. [Pg.181]

An alternative perspective is as follows. A 5-frmction pulse in time has an infinitely broad frequency range. Thus, the pulse promotes transitions to all the excited-state vibrational eigenstates having good overlap (Franck-Condon factors) with the initial vibrational state. The pulse, by virtue of its coherence, in fact prepares a coherent superposition of all these excited-state vibrational eigenstates. From the earlier sections, we know that each of these eigenstates evolves with a different time-dependent phase factor, leading to coherent spatial translation of the wavepacket. [Pg.238]

The observation of a bend progression is particularly significant. In photoelectron spectroscopy, just as in electronic absorption or emission spectroscopy, the extent of vibrational progressions is governed by Franck-Condon factors between the initial and final states, i.e. the transition between the anion vibrational level u" and neutral level u is given by... [Pg.879]

Section BT1.2 provides a brief summary of experimental methods and instmmentation, including definitions of some of the standard measured spectroscopic quantities. Section BT1.3 reviews some of the theory of spectroscopic transitions, especially the relationships between transition moments calculated from wavefiinctions and integrated absorption intensities or radiative rate constants. Because units can be so confusing, numerical factors with their units are included in some of the equations to make them easier to use. Vibrational effects, die Franck-Condon principle and selection mles are also discussed briefly. In the final section, BT1.4. a few applications are mentioned to particular aspects of electronic spectroscopy. [Pg.1119]

The last factor, the square of the overlap integral between the initial and final vibrational wavefunctions, is called the Franck-Condon factor for this transition. [Pg.1128]

The Franck-Condon principle says that the intensities of die various vibrational bands of an electronic transition are proportional to these Franck-Condon factors. (Of course, the frequency factor must be included for accurate treatments.) The idea was first derived qualitatively by Franck through the picture that the rearrangement of the light electrons in die electronic transition would occur quickly relative to the period of motion of the heavy nuclei, so die position and iiioiiientiim of the nuclei would not change much during the transition [9]. The quaiitum mechanical picture was given shortly afterwards by Condon, more or less as outlined above [10]. [Pg.1128]

If we can use only the zero-order tenn in equation (B 1.1.7) we can remove the transition moment from the integral and recover an equation hrvolving a Franck-Condon factor ... [Pg.1131]

The synnnetry selection rules discussed above tell us whether a particular vibronic transition is allowed or forbidden, but they give no mfonnation about the intensity of allowed bands. That is detennined by equation (Bl.1.9) for absorption or (Bl.1.13) for emission. That usually means by the Franck-Condon principle if only the zero-order tenn in equation (B 1.1.7) is needed. So we take note of some general principles for Franck-Condon factors (FCFs). [Pg.1138]

Franck-Condon factors". Their relative magnitudes play strong roles in determining the relative intensities of various vibrational "bands" (i.e., peaks) within a partieular eleetronie transition s speetrum. [Pg.412]

Here, I(co) is the Fourier transform of the above C(t) and AEq f is the adiabatic electronic energy difference (i.e., the energy difference between the v = 0 level in the final electronic state and the v = 0 level in the initial electronic state) for the electronic transition of interest. The above C(t) clearly contains Franck-Condon factors as well as time dependence exp(icOfvjvt + iAEi ft/h) that produces 5-function spikes at each electronic-vibrational transition frequency and rotational time dependence contained in the time correlation function quantity <5ir Eg ii,f(Re) Eg ii,f(Re,t)... [Pg.426]

In electronic spectra there is no restriction on the values that Au can take but, as we shall see in Section 1.2.53, the Franck-Condon principle imposes limitations on the intensities of the transitions. [Pg.242]

Quite apart from the necessity for Franck-Condon intensities of vibronic transitions to be appreciable, it is essential for the initial state of a transition to be sufficiently highly populated for a transition to be observed. Under equilibrium conditions the population 1, of any v" level is related to that of the u" = 0 level by... [Pg.243]

In 1925, before the development of the Schrodinger equation, Franck put forward qualitative arguments to explain the various types of intensity distributions found in vibronic transitions. His conclusions were based on an appreciation of the fact that an electronic transition in a molecule takes place much more rapidly than a vibrational transition so that, in a vibronic transition, the nuclei have very nearly the same position and velocity before and after the transition. [Pg.246]

The quantity J dr is called the vibrational overlap integral, as it is a measure of the degree to which the two vibrational wave functions overlap. Its square is known as the Franck-Condon factor to which the intensity of the vibronic transition is proportional. In carrying out the integration the requirement that r remain constant during the transition is necessarily taken into account. [Pg.248]

Figure 7.21 Franck-Condon principle applied to a case in which > r" and the 4-0 transition is the most probable... Figure 7.21 Franck-Condon principle applied to a case in which > r" and the 4-0 transition is the most probable...
Section 6.13.2 and illustrated in Figure 6.5. The possible inaccuracies of the method were made clear and it was stressed that these are reduced by obtaining term values near to the dissociation limit. Whether this can be done depends very much on the relative dispositions of the various potential curves in a particular molecule and whether electronic transitions between them are allowed. How many ground state vibrational term values can be obtained from an emission spectrum is determined by the Franck-Condon principle. If r c r" then progressions in emission are very short and few term values result but if r is very different from r", as in the A U — system of carbon monoxide discussed in Section 7.2.5.4, long progressions are observed in emission and a more accurate value of Dq can be obtained. [Pg.252]

The Franck-Condon approximation (see Section 7.2.5.3) assumes that an electronic transition is very rapid compared with the motion of the nuclei. One important result is that the transition moment for a vibronic transition is given by... [Pg.281]

Resonance Raman Spectroscopy. If the excitation wavelength is chosen to correspond to an absorption maximum of the species being studied, a 10 —10 enhancement of the Raman scatter of the chromophore is observed. This effect is called resonance enhancement or resonance Raman (RR) spectroscopy. There are several mechanisms to explain this phenomenon, the most common of which is Franck-Condon enhancement. In this case, a band intensity is enhanced if some component of the vibrational motion is along one of the directions in which the molecule expands in the electronic excited state. The intensity is roughly proportional to the distortion of the molecule along this axis. RR spectroscopy has been an important biochemical tool, and it may have industrial uses in some areas of pigment chemistry. Two biological appHcations include the deterrnination of helix transitions of deoxyribonucleic acid (DNA) (18), and the elucidation of several peptide stmctures (19). A review of topics in this area has been pubHshed (20). [Pg.210]

Another conventional simplification is replacing the whole vibration spectrum by a single harmonic vibration with an effective frequency co. In doing so one has to leave the reversibility problem out of consideration. It is again the model of an active oscillator mentioned in section 2.2 and, in fact, it is friction in the active mode that renders the transition irreversible. Such an approach leads to the well known Kubo-Toyozawa problem [Kubo and Toyozava 1955], in which the Franck-Condon factor FC depends on two parameters, the order of multiphonon process N and the coupling parameter S... [Pg.29]

Suppose now that both types of vibrations are involved in the transition. The symmetric modes decrease the effective tunneling distance to 2Q, while the antisymmetric ones create the Franck-Condon factor in which the displacement 2Qq now is to be replaced by the shorter tunneling distance 2Q, [Benderskii et al. 1991a]... [Pg.91]

Solvatochromic shifts are rationalized with the aid of the Franck-Condon principle, which states that during the electronic transition the nuclei are essentially immobile because of their relatively great masses. The solvation shell about the solute molecule minimizes the total energy of the ground state by means of dipole-dipole, dipole-induced dipole, and dispersion forces. Upon transition to the excited state, the solute has a different electronic configuration, yet it is still surrounded by a solvation shell optimized for the ground state. There are two possibilities to consider ... [Pg.435]

The justification was also given for the assumption made originally by Franck (12) that during an electron transition the nuclei retain the configuration characteristic of the initial state. [Pg.35]

The degree of vibrational excitation in a newly formed bond (or vibrational mode) of the products may also increase with increasing difference in bond length (or normal coordinate displacement) between the transition state and the separated products. For example, in the photodissociation of vinyl chloride [9] (reaction 7), the H—Cl bond length at the transition state for four-center elimination is 1.80 A, whereas in the three-center elimination, it is 1.40 A. A Franck-Condon projection of these bond lengths onto that of an HCl molecule at equilibrium (1.275 A) will result in greater product vibrational excitation from the four-center transition state pathway, and provides a metric to distinguish between the two pathways. [Pg.222]


See other pages where Franck transition is mentioned: [Pg.245]    [Pg.1128]    [Pg.1132]    [Pg.1148]    [Pg.1161]    [Pg.2073]    [Pg.2985]    [Pg.246]    [Pg.281]    [Pg.282]    [Pg.299]    [Pg.389]    [Pg.392]    [Pg.400]    [Pg.26]    [Pg.87]    [Pg.90]    [Pg.90]    [Pg.408]    [Pg.199]    [Pg.40]    [Pg.273]    [Pg.275]    [Pg.276]    [Pg.303]    [Pg.170]    [Pg.184]   
See also in sourсe #XX -- [ Pg.47 , Pg.96 , Pg.181 ]




SEARCH



Electronic Transitions The Franck-Condon Principle

Electronic transitions Franck-Condon principle

Franck

Franck-Condon effects radiationless transitions

Franck-Condon transition

Franck-Condon transition probability

Franck-Condon transition probability dynamics

Franck-Condon transition probability intersection

Franck-Condon transition spectroscopy

Francke

Radiationless transitions Franck-Condon factor

Strongly allowed transitions Franck-Condon

Vertical transitions Franck-Condon maxima

© 2024 chempedia.info