Fluoride evolution rate

The degradation rate was then measured using the fluoride evolution rate (FER). The first of these modes was carried out in order to test the theory that Fenton-type contaminants were responsible for helping to initiate chemical... 

Acetylcyclohexanone. Method A. Place a mixture of 24-6 g. of cyclohexanone (regenerated from the bisulphite compound) and 61 g. (47 5 ml.) of A.R. acetic anhydride in a 500 ml. three-necked flask, fitted with an efficient sealed stirrer, a gas inlet tube reaching to within 1-2 cm. of the surface of the liquid combined with a thermometer immersed in the liquid (compare Fig. II, 7, 12, 6), and (in the third neck) a gas outlet tube leading to an alkali or water trap (Fig. II, 8, 1). Immerse the flask in a bath of Dry Ice - acetone, stir the mixture vigorously and pass commercial boron trifluoride (via an empty wash bottle and then through 95 per cent, sulphuric acid) as fast as possible (10-20 minutes) until the mixture, kept at 0-10°, is saturated (copious evolution of white fumes when the outlet tube is disconnected from the trap). Replace the Dry Ice-acetone bath by an ice bath and pass the gas in at a slower rate to ensure maximum absorption. Stir for 3 6 hours whilst allowing the ice bath to attain room temperature slowly. Pour the reaction mixture into a solution of 136 g. of hydrated sodium acetate in 250 ml. of water, reflux for 60 minutes (or until the boron fluoride complexes are hydrolysed), cool in ice and extract with three 50 ml. portions of petroleum ether, b.p. 40-60° (1), wash the combined extracts free of acid with sodium bicarbonate solution, dry over anhydrous calcium sulphate, remove the solvent by... 

Preparation of Antimony Trifluorodichloride (SbF3Cl2). This is made in the steel reaction vessel, described on p. 59. A known quantity of antimony fluoride is placed in the vessel the vessel is evacuated, the needle valve is closed, and the whole is weighed. Connection is established to a chlorine cylinder, and the needle valve is opened to permit qhlorine to fill the vessel. Part of it is absorbed rapidly by the salt, with evolution of heat. Soon the reaction slows down as indicated by the rate of pressure fall when the needle valve is dosed. Weighing indicates the amount of chlorine present in the vessel. When the absorption practically ceases, the valve is closed, and the connection with the chlorine tank is removed. The reaction vessel is alternately heated gently, then allowed to cool in order to permit SbFsCl2, which is a viscous liquid, to flow and expose fresh surfaces of crystalline antimony trifluoride. The operation is ended after the absorption of the desired quantity of chlorine. 

Figure 5 [116] shows the variation of the amount of fluoride ions at 200 °C with MgO content. The presence of MgO does not prevent HF elimination it merely reduces its rate of evolution from the elastomer, a 15% addition giving a result comparable with that of the raw polymer alone. 

---