First-effect concentrations

The NOEC and the LOEC are the usual calculations reported from chronic toxicity tests. The NOEC is the highest concentration in which the measured effect is not statistically different from that of the control. The LOEC is the lowest concentration at which a statistically significant effect occurred. These concentrations are based on the most sensitive effect parameters, that is, hatchability, growth, and reproduction. The statistical procedure for these calculations combines the use of analysis of variance techniques and multiple comparison tests. In some cases, the maximum acceptable toxic concentration (MATC) is reported from chronic toxicity results. The MATC is a concentration [x) that is within the range of the NOEC and LOEC NOEC a < LOEC. The first-effect concentration can be expressed as the geometric mean of the two terms. 

Surfactant First-effect concentration (mg/l) Test species Test duration EffecC... 

To prevent weak product from going to storage during startup, this arrangement requires recycle until the first-effect concentration builds up. Steam flow control would... 

We may now understand the nature of the change which occurs when an anhydrous salt, say copper sulphate, is shaken with a wet organic solvent, such as benzene, at about 25°. The water will first combine to form the monohydrate in accordance with equation (i), and, provided suflScient anhydrous copper sulphate is employed, the effective concentration of water in the solvent is reduced to a value equivalent to about 1 mm. of ordinary water vapour. The complete removal of water is impossible indeed, the equilibrium vapour pressures of the least hydrated tem may be taken as a rough measure of the relative efficiencies of such drying agents. If the water present is more than sufficient to convert the anhydrous copper sulphate into the monohydrate, then reaction (i) will be followed by reaction (ii), i.e., the trihydrate will be formed the water vapour then remaining will be equivalent to about 6 mm. of ordinary water vapour. Thus the monohydrate is far less effective than the anhydrous compound for the removal of water. 

The experimental procedure to be followed depends upon the products of hydrolysis. If the alcohol and aldehyde are both soluble in water, the reaction product is divided into two parts. One portion is used for the characterisation of the aldehyde by the preparation of a suitable derivative e.g., the 2 4-dinitrophenylhydrazone, semicarbazone or di-medone compound—see Sections 111,70 and 111,74). The other portion is employed for the preparation of a 3 5-dinitrobenzoate, etc. (see Section 111,27) it is advisable first to concentrate the alcohol by dis tillation or to attempt to salt out the alcohol by the addition of solid potassium carbonate. If one of the hydrolysis products is insoluble in the reaction mixture, it is separated and characterised. If both the aldehyde and the alcohol are insoluble, they are removed from the aqueous layer separation is generally most simply effected with sodium bisulphite solution (compare Section Ill,74),but fractional distillation may sometimes be employed. 

In a detersive system containing a dilute surfactant solution and a substrate bearing a soHd polar sod, the first effect is adsorption of surfactant at the sod—bath interface. This adsorption is equivalent to the formation of a thin layer of relatively concentrated surfactant solution at the interface, which is continuously renewable and can penetrate the sod phase. Osmotic flow of water and the extmsion of myelin forms foHows the penetration, with ultimate formation of an equdibrium phase. This equdibrium phase may be microemulsion rather than Hquid crystalline, but in any event it is fluid and flushable... 

Probably the most satisfactory model with which to explain the chelate effect is that proposed by G. Schwarzenbach If L and L-L are present in similar concentrations and are competing for two coordination sites on the metal, the probability of either of them coordinating to the first site may be taken as equal. However, once one end of L-L has become attached it is much more likely that the second site will be won by its other end than by L, simply because its other end must be held close to the second site and its effective concentration where it matters is therefore much... 

In contrast, iproniazid, introduced in 1951 for treatment of tuberculosis, induced euphoria and was described as a psychic energiser . In fact, these patients, when given iproniazid, could become quite disruptive and this action was regarded as an undesirable side-effect However, its beneficial effects in depression were soon recognised and it was regarded as the first effective antidepressant drug. Studies of peripheral sympathetic neurons, later extended to noradrenergic neurons in the brain, showed that iproniazid irreversibly inhibits the catalytic enzyme, monoamine oxidase (MAO). Because only cytoplasmic monoamines are accessible to MAO, inhibition of this enzyme first increases the concentration of the pool of soluble transmitter but this leads to a secondary increase in the stores of vesicle-bound transmitter i.e. the pool available for impulse-evoked release (Fillenz and Stanford 1981). 

It follows that convection of the hqnid has a twofold influence It levels the concentrations in the bnlk liquid, and it influences the diffusional transport by governing the diffusion-layer thickness. Shght convection is sufficient for the first effect, but the second effect is related in a qnantitative way to the convective flow velocity The higher this velocity is, the thinner will be the diffusion layer and the larger the concentration gradients and diffusional fluxes. 

The first effect is that of a concentration change of the charged reactant particles in the reaction zone this change is determined by Boltzmann s distribution law ... 

This is an inverted parabolic relation in terms of ttx (calculated hydrophobic parameter of the substituents), which suggests that activity of these compounds first decreases as the hydrophobicity of substituents increases and after a certain point (inversion point ttx = 0.67), activity begins to increase. This may correspond to an allosteric reaction [54]. The indicator variable I is assigned the value of 1 and 0 for the presence and absence of N(CH3)2 substituent at the X position. Its positive coefficient suggests that the presence of a N(CH3)2 substituent at X position, increases the activity. REC is the relative effective concentration i.e., concentration relative to topotecan, whose value is arbitrarily assumed as 1, that is able to produce the same cleavage on the plasmid DNA in the presence of human topo I. 

Rudnick, S.N., W.C. Hinds, E.F. Maher, and M.W. First, Effect of Plateout, Air Motion and Dust Removal on Radon Decay Product Concentration in a Simulated Residence, Health Phvs. 45 463-470... 

Using the concentrations and pressures provided we can calculate the Gibbs energy for the combustion of glucose under biological conditions. First, we need to replace the activities by the appropriate effective concentrations. That is,... 

---