Filling modification technique

Some research on the pre-treatment of CNTs and interfacial modification techniques have been reported, which is helpful to the preparation of CNT-filled rubber composites. " But the dispersion of CNTs into rubber materials is still problematic due to possible entanglement of the high aspect ratio CNTs and the high viscosity of rubbers. 

The use of the random fill material technique in refineries must therefore be contemplated only with a number of modifications ... 

The surface modification technique of inorganic fillers directly affects the filling modification. The common surface modification methods can be classified into three types inorganic filler pretreatment, blending, and masterbatch methods. 

We offer these two examples of data storage scheme in order to illustrate the interrelationship between data structure, storage requirement, and the types of operations to be performed. The specific data structure and data manipulation techniques to be used should always be tailored to the structure of the matrix and the requirement of the application. In point of fact both schemes I and II can be modified to overcome some of the stated deficiencies. Gustavson (G9) discussed modifications of scheme I to permit both row- and column-oriented operations and to accommodate fill-ins ... 

The partial-filling technique is a modification of ACE that has been shown to be very suitable for measuring binding constants. The methodology and interesting examples of application of this technique are summarized in... 

Encapsulation of other material into carbon nanotubes would also open up a possibility for the applications to electrodevices. By applying the template method, perfect encapsulation of other material into carbon nanotubes became possible. No foreign material was observed on the outer surface of carbon nanotubes. The metal-filled uniform carbon nanotubes thus prepared can be regarded as a novel onedimensional composite, which could have a variety of potential applications (e.g novel catalyst for Pt metal-filled nanotubes, and magnetic nanodevice for Fe304-filled nanotubes). Furthermore, the template method enables selective chemical modification of the inner surface of carbon nanotubes. With this technique, carbon... 

Cole has also developed a modification of the Burnett technique, involving three measuring cells with matched volumes and shown schematically in Figure 1(b). Initially all three cells are filled with gas, the valves closed, and is measured. Cell A is then evacuated, the gas from B and C allowed to expand into A, and another measurement of e, made. The procedure is repeated cyclically, evacuating cells B, C, A, B, C in turn. The values of/before and after a complete cycle of expansions are related by... 

---