Failure Analysis of

V. D. Frnchette, Failure Analysis of Brittle Materials, Advances in Ceramics, Vol. 28, The American Ceramic Society, Inc., Westervike, Ohio, 1990. 

McHenry, H. I., Read, D. T. and Shives, T. R., Failure analysis of an amine-absorber pressure vessel. Materials Performance, 26, 18-24 (1987)... 

J. Scheirs, Compositional and Failure Analysis of Polymers. A Practical Approach, John Wiley Sons, Ltd, Chichester (2000). 

Carson, R, Ziesche, S., Johnson, G. et al. (1999). Racial differences in response to therapy for heart failure analysis of the vasodilator-heart failure trials. /. Card. Pail., 5, 178-87. 

A comprehensive review of compositional and failure analysis of polymers, which includes many further examples of analysis of contaminants, inclusions, chemical attack, degradation, etc., was published in 2000 [2], It includes details on methodologies, sampling, and sample preparation, and microscopy, infrared spectroscopy, and thermal analysis techniques. 

Figure 4 IR-ATR microscopy study of the plane of failure analysis of a polymer ID card.

Several catastrophic fire incidents in the petroleum industry have been the result of the facility firewater pumps being directly affected by the initial effects of the incident. The cause of these impacts has been mainly due to the siting of the fire pumps in vulnerable locations without adequate protection measures from the probable incident and the unavailability or provision of other backup water sources. A single point failure analysis of firewater distribution systems is an effective analysis that can be performed to identify where design deficiencies may exist. For all high risk locations, fire water supplies should be available from several remotely located sources that are totally independent of each and utility systems which are required for support. 

Weldon, D. G., Failure analysis of paints and coatings, Wiley, 2002. 

Beaumont P.W.R. and Anstice P.D. (1980). A failure analysis of the micro-mechanisms of fracture of carbon fiber and glass fiber composites in monotonic loading. J. Mater. Sci. 15, 2691-2635. 

Lacey P, Lestz S. 1991. Failure analysis of fuel injection pumps from generator sets fueled with Jet A-1. Southwest Research Int San Antonio, TX. Belvoir Fuels and Lubricants Research Facility. 

Figure 4. XPS locus of failure analysis of PMDA-ODA on SiO,. (A) PI failure surface C(ls) and N(l ) data, (B) SiO, failure surface C(ls) and N(l ) data.

Williamson JA, Webb RK, Sellen A, Runciman WB, Van der Walt JH. Human failure analysis of 2000 incident reports. Anesth Intens Care 1993 21 678-683. 

Goldstein S, Fagerberg B, Hjalmarson A, et al. Metoprolol controlled release/extended release in patients with severe heart failure analysis of the experience in the MERIT-HF study, J Am Coll Cardiol 2001 38 932-938. 

The propellant was simply pent-up water and steam pressure. The destructive pressure buildup occurred as the compressor operated for over five hours with no cooling water flow. Cooling water was trapped in the water jacket on the compression head as the compressor piston continued operating. The team concluded that the fragmentation of the compressor water jacket was a consequence of the operating condition, and a metal failure analysis of the compressor head was not necessary. The damage was immediate and limited, there was no release of gas, and the incident did not require the attention of the available on-site emergency squad. Fortunately, there were no personnel injuries due to this incident. 

The various methods used in failure analysis of polymeric materials are noted below ... 

---