Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Explosion, scale

On the simplest type of instrument (an explosimeter) only one scale is provided, usually with readings from 0 to 100% LEL. However, the detectable changes produced by combustion are too small to be measured accurately in the presence of the low concentrations of contaminants usually encountered in evaluating potential health hazards. For example, the LEL of even the most explosive gas is of the order of 1 %, or 10,000 ppm, which is well in excess of the toxic limit for any gas. Therefore, explosimeters or combustible gas indicators which have only a 0-to-l(X)% LEL explosive scale are not suitable for environmental health testing in the ppm range. More sensitive instruments, including the type used in sampling for environmental health purposes, have a dual scale, in which the second, more... [Pg.270]

Kst Severity of Dust Explosion Scale, which is a combination of maximum pressure and rate of pressure rise. [Pg.237]

High explosive Scaling factor for over-pressure [-] Scaling factor for for blast [-]... [Pg.1036]

The structure of the secular terms suggests the next scale as p = (0 -v)le. Note, this new scale - v) e = e t - vie corresponds to the obvious scale but this occurs when the slow time 6 is near v and not zero. This new scale is fast with respect to the slow one 0 = e f. Therefore, it seems a good idea to call it an explosive scale. [Pg.31]

Thus, on the explosive scale, we have the asymptotic approximations of x°, yl p) both at plus and at minus infinity (as p— >). To obtain the... [Pg.33]

Explosive power index The power of explosives scaled to that of picric add and expressed as a percentage. [Pg.619]

Picric acid is used on a large scale as a high explosive, but for this purpose requires a detonator. If a few small crystals of the pure acid are heated on a crucible lid, they first melt, and ultimately burn harmlessly with a smoky flame. Metallic salts of picric acid are much less stable than the free acid,... [Pg.174]

If undiluted diacetylene is required, the experiment can be carried out in the same way, but preferably on a smaller scale. 3 Traps should then be used and the stream of nitrogen should be slower. The boiling point of diacetylene is said to be about 10°C. The solutions of diacetylene probably can be stored (under nitrogen in the refrigerator) for at least 24 h without decomposition. Though explosions have never been experienced by the authors, it is advisable to handle diacetylene with the necessary respect. [Pg.148]

The derivatives are hydroxyethyl and hydroxypropyl cellulose. AH four derivatives find numerous appHcations and there are other reactants that can be added to ceUulose, including the mixed addition of reactants lea ding to adducts of commercial significance. In the commercial production of mixed ethers there are economic factors to consider that include the efficiency of adduct additions (ca 40%), waste product disposal, and the method of product recovery and drying on a commercial scale. The products produced by equation 2 require heat and produce NaCl, a corrosive by-product, with each mole of adduct added. These products are produced by a paste process and require corrosion-resistant production units. The oxirane additions (eq. 3) are exothermic, and with the explosive nature of the oxiranes, require a dispersion diluent in their synthesis (see Cellulose ethers). [Pg.314]

Many compounds explode when triggered by a suitable stimulus however, most are either too sensitive or fail to meet cost and production-scale standards, requirements for safety in transportation, and storage stability. Propellants and explosives in large-scale use are based mosdy on a relatively small number of well-proven iagredients. Propellants and explosives for military systems are manufactured ia the United States primarily ia government owned plants where they are also loaded iato munitions. Composite propellants for large rockets are produced mainly by private iadustry, as are small arms propellants for sporting weapons. [Pg.3]

HMX, the highest density and highest energy soHd explosive produced on a large scale, primarily for military use, exists in four polymorphic forms. The beta form is the least sensitive, most stable, and the type requited for military use. The mole fraction products of detonation of HMX in a calorimetric bomb are 3.68 N2, 3.18 H2, 1.92 CO2, 1.06 CO, 0.97 C, 0.395 NH3, and 0.30 H2. [Pg.15]

Manufacture and Economics. Nitrogen tritiuoride can be formed from a wide variety of chemical reactions. Only two processes have been technically and economically feasible for large-scale production the electrolysis of molten ammonium acid fluoride and the direct fluorination of the ammonia in the presence of molten ammonium fluoride. In the electrolytic process, NF is produced at the anode and H2 is produced at the cathode. In a divided cell of 4 kA having nickel anodes, extensive dilution of the gas streams with N2 was used to prevent explosive reactions between NF and H2 (17). [Pg.217]

Explosions have been reported during preparation of duoronitroaromatics by the Halex reaction on a laboratory or industrial scale (9-duoronitroben2ene (65) 2,4-dinitroduoroben2ene (66) 2,4-diduoronitroben2ene (67) and l,5-diduoro-2,4-dinitroben2ene (68). [Pg.319]

Explosives. Mercury, in the form of organic complexes, eg, mercury fulminate [628-86-4] has had long usage in explosives (see Explosives and propellants). In the United States all mercury for use in explosives is diverted to military uses. An explosive based on mercuric 5-nitrotetra2ole [60345-95-1] has been developed, but its use is on a small scale and in research and development only (3). [Pg.110]

Economic Aspects. Oxetanes are expensive monomers and are not readily available in commercial quantities. Commercial production of PBCMO has been discontinued its end uses were not able to support its comparatively high selling price. Energetic polymers prepared from appropriately substituted oxetanes have opened a new market for their use to prepare soHd rocket propeUants and explosives. Should this specialty market result in the large-scale production of these oxetanes even at current (1996) high prices and/or in a cheap synthetic route to oxetanes, this economic picture could change. [Pg.369]


See other pages where Explosion, scale is mentioned: [Pg.31]    [Pg.328]    [Pg.72]    [Pg.31]    [Pg.328]    [Pg.72]    [Pg.1958]    [Pg.2184]    [Pg.2189]    [Pg.2698]    [Pg.665]    [Pg.56]    [Pg.81]    [Pg.8]    [Pg.260]    [Pg.272]    [Pg.6]    [Pg.10]    [Pg.20]    [Pg.24]    [Pg.28]    [Pg.43]    [Pg.352]    [Pg.124]    [Pg.150]    [Pg.455]    [Pg.280]    [Pg.490]    [Pg.46]    [Pg.527]    [Pg.537]   


SEARCH



Explosion calculations Scaled distance

Explosion from scale

Time scales explosive scale

© 2024 chempedia.info