Evaporator disturbances

In aqueous solution at 100° the change is reversible and equilibrium is reached when 95 per cent, of the ammonium cyanate has changed into urea. Urea is less soluble in water than is ammonium sulphate, hence if the solution is evaporated, urea commences to separate, the equilibrium is disturbed, more ammonium cyanate is converted into urea to maintain the equilibrium and evfflitually the change into urea becomes almost complete. The urea is isolated from the residue by extraction with boiling methyl or ethyl alcohol. The mechanism of the reaction which is generally accepted involves the dissociation of the ammonium cyanate into ammonia and cyanic acid, and the addition of ammonia to the latter ... 

Peroxide Formation. Except for the methyl alkyl ethers, most ethers tend to absorb and react with oxygen from the air to form unstable peroxides that may detonate with extreme violence when concentrated by evaporation or distillation, when combined with other compounds that give a detonable mixture, or when disturbed by heat, shock, or friction. Appreciable quantities of crystalline soHds have been observed as gross evidence for the formation of peroxides, and peroxides may form a viscous Hquid in the bottom of ether-fiHed containers. If viscous Hquids or crystalline soHds are observed in ethers, no further tests for the detection of peroxides are recommended. Several chemical and physical methods for detecting and estimating peroxide concentrations have been described. Most of the quaHtative tests for peroxides are readily performed and strongly recommended when any doubt is present (20). 

Another theory of liquid-liquid explosion comes from Board et al. (1975). They noticed that when an initial disturbance, for example, at the vapor-liquid interface, causes a shock wave, some of the liquid is atomized, thus enhancing rapid heat transfer to the droplets. This action produces further expansion and atomization. When the droplets are heated to a temperature equal to the superheat temperature limit, rapid evaporation (flashing liquid) may cause an explosion. In fact, this theory resembles the theory of Reid (1979), except that only droplets, and not bulk liquid, have to be at the superheat temperature limit of atmospheric pressure (McDevitt et al. 1987). 

Providing the surrounding air is reasonably still, the lids may be omitted. It helps to have glass walls at the sides to reduce draughts, which would disturb the layer of very cold air in the cabinet. The evaporator may be pipe coils on the outside of the inner wall, but is more usually a finned coil at the back or sides. It is important that produce is kept below the design level of the cold air blanket. The construction with discrete cold trays is now taken a stage further, where several trays may be arranged one above the other. 

The capillary flow with distinct evaporative meniscus is described in the frame of the quasi-dimensional model. The effect of heat flux and capillary pressure oscillations on the stability of laminar flow at small and moderate Peclet number is estimated. It is shown that the stable stationary flow with fixed meniscus position occurs at low wall heat fluxes (Pe -Cl), whereas at high wall heat fluxes Pe > 1, the exponential increase of small disturbances takes place. The latter leads to the transition from stable stationary to an unstable regime of flow with oscillating meniscus. 

In SEC analysis of additive extracts from polymers, the effect of the extraction solvent on the mobile phase is less critical than in HPLC analysis. The extraction solvents typically employed generally do not interfere with the SEC mobile phases. Moreover, the same solvents are often used both as extraction solvent and as mobile phase. Therefore, there is no need to evaporate the extract to dryness prior to analysis and then to redissolve it in a suitable solvent. Typical extraction procedures often produce extracts that generally contain a small amount of wax. Frequently, removal of such oligomers from an extract is necessary, e.g. by means of precipitation, centrifuging, precolumn filtration or protection (use of a reversed-phase guard column). In SEC separations the presence of polyolefin wax does not usually disturb provided that the MW of the wax is higher than that of the analysed compounds. 

An aqueous solution of aluminium formate was being evaporated over a low flame. When the surface crust was disturbed, an explosion occurred. This seems likely to have been due to thermal decomposition of the solid, liberation of carbon monoxide and ignition of the latter admixed with air. 

Barker, M. D Chem. IncL, 1971, 1234 The sodium salt obtained by vacuum evaporation at 50°C of an aqueous alcoholic mixture of the above ingredients exploded violently when disturbed. 

A conclusion can be drawn that it is difficult to remove traces of disturbing impurities by charcoal or alumina. A slight decolorization may occur, but not without a considerable loss of the product due to the dilution and evaporation of fhe solvenf. 

---