Ethylene metal complexes

The olefin signal in the tris(ethylene)metal complexes experiences a coordination shift of approximately -60 ppm. Interestingly, the magnitude of the complexation shifts increases in the order Pd < Ni < Pt. This result has also been observed for the bis(r/3-allyl)metal complexes discussed in Section IV. 

Another reaction which appears to be general for o-allyl complexes is their facile protonation with acids, thereby affording novel tr-ethylenic metal complexes,... 

Dehalogenation of monochlorotoluenes can be readily effected with hydrogen and noble metal catalysts (34). Conversion of -chlorotoluene to Ncyanotoluene is accompHshed by reaction with tetraethyl ammonium cyanide and zero-valent Group (VIII) metal complexes, such as those of nickel or palladium (35). The reaction proceeds by initial oxidative addition of the aryl haHde to the zerovalent metal complex, followed by attack of cyanide ion on the metal and reductive elimination of the aryl cyanide. Methylstyrene is prepared from -chlorotoluene by a vinylation reaction using ethylene as the reagent and a catalyst derived from zinc, a triarylphosphine, and a nickel salt (36). 

Manufacture of alkylsulfones, important intermediates for metal-complex dyes and for reactive dyes, also depends on O-alkylation. An arylsulphinic acid in an aqueous alkaline medium is treated with an alkylating agent, eg, alkyl haUde or sulfate, by a procedure similar to that used for phenols. In the special case of P-hydroxyethylsulfones (precursors to vinylsulfone reactive dyes) the alkylating agent is ethylene oxide or ethylene chlorohydrin. 

Pyridine 1-oxide, like pyridine, can act as a ligand in transition metal complexes, but unfortunately good stability constants are not known. However, Shupack and Orchin have found that the C===C stretching frequency of the ethylene ligand in trans-ethylene pyridine 1-oxide dichloroplatinum(II) varies linearly with the pA and hence with the C7-value (ct+ or a, respectively) of substituents in the pyridine oxide. The data for the above reaction series are included in Table V. 

The polymerization filling was effected by the ion-coordination mechanism [17-19]. The monomers were ethylene, propylene, allene, os-butylene, butadiene. The fillers were mineral materials such as ash, graphite, silica gel, glass fibers. The ultimate aim of filler conditioning prior to polymerization is to secure, on its surface, metal complex or organometallic catalysts by either physical or chemical methods [17-19],... 

Coordination-catalyzed ethylene oligomerization into n-a-olefins. The synthesis of homologous, even-numbered, linear a-olefins can also be performed by oligomerization of ethylene with the aid of homogeneous transition metal complex catalysts [26]. Such a soluble complex catalyst is formed by reaction of, say, a zero-valent nickel compound with a tertiary phosphine ligand. A typical Ni catalyst for the ethylene oligomerization is manufactured from cyclo-octadienyl nickel(O) and diphenylphosphinoacetic ester ... 

Group 4 metal complexes of the dianion [ BuNP( -N Bu)2PN Bu] polymerize ethylene in the presence of a co-catalyst, but they are readily deactivated [10,14]. This behaviour is attributed to coordination of the lone-pair electrons on the phosphorus(III) centers to Lewis acid sites, which initiates ring opening of the ligand [15]. 

All mechanisms proposed in Scheme 7 start from the common hypotheses that the coordinatively unsaturated Cr(II) site initially adsorbs one, two, or three ethylene molecules via a coordinative d-7r bond (left column in Scheme 7). Supporting considerations about the possibility of coordinating up to three ethylene molecules come from Zecchina et al. [118], who recently showed that Cr(II) is able to adsorb and trimerize acetylene, giving benzene. Concerning the oxidation state of the active chromium sites, it is important to notice that, although the Cr(II) form of the catalyst can be considered as active , in all the proposed reactions the metal formally becomes Cr(IV) as it is converted into the active site. These hypotheses are supported by studies of the interaction of molecular transition metal complexes with ethylene [119,120]. Groppo et al. [66] have recently reported that the XANES feature at 5996 eV typical of Cr(II) species is progressively eroded upon in situ ethylene polymerization. 

The above example outlines a general problem in immobilized molecular catalysts - multiple types of sites are often produced. To this end, we are developing techniques to prepare well-defined immobilized organometallic catalysts on silica supports with isolated catalytic sites (7). Our new strategy is demonstrated by creation of isolated titanium complexes on a mesoporous silica support. These new materials are characterized in detail and their catalytic properties in test reactions (polymerization of ethylene) indicate improved catalytic performance over supported catalysts prepared via conventional means (8). The generality of this catalyst design approach is discussed and additional immobilized metal complex catalysts are considered. 

Polymerization of Ethylene in the Dark with Sigma-Bonded Metal Complexes, Solvent Toluene at 80°C, Partial Pressures of Ethylene 10 atm [catalyst] = 0.003 M... 

A range of rare earth metal complexes were subsequently shown to catalyze ethylene polymerization and, on occasion, living characteristics have been reported.226-228 Dimeric hydrides such as (79)—(82) are extremely active with turnover numbers > 1800 s-1 recorded for (79) at room temperature. The samarium hydride (82) also effects the block copolymerization of methyl methacrylate (MMA) and ethylene 229 further discussion may be found in Section 9.1.4.4. 

The band at 1600 cm-1 due to a double-bond stretch shows that chemisorbed ethylene is olefinic C—H stretching bands above 3000 cm-1 support this view. Interaction of an olefin with a surface with appreciable heat suggests 7r-bonding is involved. Powell and Sheppard (4-1) have noted that the spectrum of olefins in 7r-bonded transition metal complexes appears to involve fundamentals similar to those of the free olefin. Two striking differences occur. First, infrared forbidden bands for the free olefin become allowed for the lower symmetry complex second, the fundamentals of ethylene corresponding to v and v% shift much more than the other fundamentals. In Table III we compare the fundamentals observed for liquid ethylene (42) and a 7r-complex (43) to those observed for chemisorbed ethylene. Two points are clear from Table III. First, bands forbidden in the IR for gaseous ethylene are observed for chemisorbed ethyl-... 

A large number of transition metal complexes whose cationic complexes are 10- to 16-electron species (including those with the ligands summarized in Fig. 7) were investigated to determine their potential as ethylene polymerization catalysts with methyaluminoxane (MAO) activation at 25 °C under atmospheric pressure. As a result, we discovered a number of high-activity catalysts for ethylene polymerization that contain electronically flexible ligands [11]. 

Among the highly active catalysts introduced above, bis(phenoxy-imine) early transition metal complexes (Fig. 9) in particular show strikingly high activities for the polymerization of ethylene [14, 51-54]. 

---