Esters, vinyl cycloaddition reactions

The other main source of various pyridopyridazines from pyridines are the [4 + 2] cycloaddition reactions, already mentioned (Section 2.15.8.3), between vinylpyridines and azodicarboxylic esters (79T2027, 79KGS639) or triazolidinediones e.g. 78KGS651). 2-Vinyl-pyridines gave reduced pyrido[3,2-c]pyridazines (370), 4-vinylpyridines gave [3,4-c] analogues, whilst 2-methyl-5-vinylpyridine furnishes a mixture of the [2,3-c] and [4,3-c] compounds. Yields are low, however, and these remain curiosities for practical synthetic purposes. 

The stereochemistry of the product formed in the cycloaddition reaction depends on the approach of the substrate. There are two different approaches by which the reaction can proceed - endo and exo. For the reaction of e.g., a / , y-un-saturated a-keto ester with an ethyl vinyl ether there are four possible approaches... 

Our development of the catalytic enantioselective inverse electron-demand cycloaddition reaction [49], which was followed by related papers by Evans et al. [38, 48], focused in the initial phase on the reaction of mainly / , y-unsaturated a-keto esters 53 with ethyl vinyl ether 46a and 2,3-dihydrofuran 50a (Scheme 4.34). 

It has been established that alkoxy alkenylcarbene complexes participate as dienophiles in Diels-Alder reactions not only with higher rates but also with better regio- and stereoselectivities than the corresponding esters [95]. This is clearly illustrated in Scheme 51 for the reactions of an unsubstituted vinyl complex with isoprene. This complex reacts to completion at 25 °C in 3 h whereas the cycloaddition reaction of methyl acrylate with isoprene requires 7 months at the same temperature. The rate enhancement observed for this complex is comparable to that for the corresponding aluminium chloride-catalysed reactions of methyl acrylate and isoprene (Scheme 51). 

Both ( )-l-phenylsulfonyl and (5)-(+)-3-p-tolylsulfmyl -alk-3-en-2-ones can exhibit high diastereoselectivity in their reactions with vinyl ethers and styrenes, with the dienophile having a dominant influence on the stereochemical outcome <96T1205,96TL3687>. Indol-2-ylideneacetic acid esters can act as both dienophile and heterodiene in cycloaddition reactions in the latter case pyrano[3,2-h]indoles are formed <96SYN519>. 

However, most asymmetric 1,3-dipolar cycloaddition reactions of nitrile oxides with alkenes are carried out without Lewis acids as catalysts using either chiral alkenes or chiral auxiliary compounds (with achiral alkenes). Diverse chiral alkenes are in use, such as camphor-derived chiral N-acryloylhydrazide (195), C2-symmetric l,3-diacryloyl-2,2-dimethyl-4,5-diphenylimidazolidine, chiral 3-acryloyl-2,2-dimethyl-4-phenyloxazolidine (196, 197), sugar-based ethenyl ethers (198), acrylic esters (199, 200), C-bonded vinyl-substituted sugar (201), chirally modified vinylboronic ester derived from D-( + )-mannitol (202), (l/ )-menthyl vinyl ether (203), chiral derivatives of vinylacetic acid (204), ( )-l-ethoxy-3-fluoroalkyl-3-hydroxy-4-(4-methylphenylsulfinyl)but-1 -enes (205), enantiopure Y-oxygenated-a,P-unsaturated phenyl sulfones (206), chiral (a-oxyallyl)silanes (207), and (S )-but-3-ene-1,2-diol derivatives (208). As a chiral auxiliary, diisopropyl (i ,i )-tartrate (209, 210) has been very popular. 

Chiacchio et al. (43,44) investigated the synthesis of isoxazolidinylthymines by the use of various C-functionalized chiral nitrones in order to enforce enantioselec-tion in their cycloaddition reactions with vinyl acetate (Scheme 1.3). They found, as in the work of Merino et al. (40), that asymmetric induction is at best partial with dipoles whose chiral auxiliary does not maintain a fixed geometry and so cannot completely direct the addition to the nitrone. After poor results with menthol ester-and methyl lactate-based nitrones, they were able to prepare and separate isoxazo-lidine 8a and its diastereomer 8b in near quantitative yield using the A-glycosyl... 

Vinylpyrroles 42 having electron-withdrawing substituents on the vinyl group are poor dienes for cycloaddition reactions with acetylenic esters. General reaction conditions such as heating at reflux in benzene or carbon... 

Characteristic of such dienes, a-keto-p,7-unsaturated esters such as (3 see also Table 3 and Table 5) exhibit good thermal reactivity toward simple vinyl ethers in [4 + 2] cycloaddition reactions that proceed with exclusive regiocontrol predominately through an erulo transition state. The endo selectivity increases as the reaction temperature is decreased and both the reaction rate and the endo selectivity increase as the reaction pressure is increased (Figure 3, Table 3). The substantial increase in the diastereoselectivity of the pressure-promoted [4 + 2] cycloaddition reaction of (3) with a cis 1,2-disub-stituted dienophile has been attributed to the additional differences in the volume of activation between the reaction paths leading to the endo and exo diastereomers due to the additional cis C-2 dienophile sub-... 

This approach is based on the rearrangement of the bicyclic seleno ester 67 prepared by pressure-promoted inverse electron demand cycloaddition of carbomethoxypyrone 65 and vinyl selenide 66 (Scheme 7.15). The cycloaddition reaction occurs regioselectively and czzc/u-diastereoselectively. 

Early extensive accounts of the 4v participation of a,/)-unsaturated carbonyl compounds in [4 + 2] cycloadditions detailed their reactions with electron-deficient dienophiles including a,/3-unsaturated nitriles, aldehydes, and ketones simple unactivated olefins including allylic alcohols and electron-rich dienophiles including enol ethers, enamines, vinyl carbamates, and vinyl ureas.23-25 31-33 Subsequent efforts have recognized the preferential participation of simple a,/3-unsaturated carbonyl compounds (a,/3-unsaturated aldehydes > ketones > esters) in inverse electron demand [4 + 2] cycloadditions and have further explored their [4 + 2]-cycloaddition reactions with enol ethers,34-48 acetylenic ethers,48 49 ke-tene acetals,36-50 enamines,4151-60-66 ynamines,61-63 ketene aminals,66 and selected simple olefins64-65 (Scheme 7-1). Additional examples may be found in Table 7-1. 

The reaction transformation should start by reacting malonic ester and hydrazine to prepare cyclic malonic hydrazide. It is well known that thionyl chloride can transfer amides to vinyl chloride, but in our case we used the pyrazole tautomer. We believe that this tautomer must be a sufficiently reactive diene for a Diels-Alder cycloaddition reaction because of the findings of one experimental study performed by Adam and coworkers [62] and one computational study presented above. There are at least two key factors that must be addressed before this reaction scheme can be considered seriously the likelihood that 3,5-dichloro-[4//]-pyrazole will participate in a cycloaddition reaction and the stability of the formed cycloadduct. One can also question the stability and the availability of cyclic hydrazides of malonic ester. These compounds are unstable but they can... 

The preceding study has demonstrated [2.2.1]bicycloheptenyl functionalized resins can be useful and interesting ene components in photoinitiated thiolene polymerizations. The addition of thiols to the unsaturation of this bicyclic system appears to be rapid and exothermic. The relative rates of this addition compared with allylic derivatives and vinyl ethers are quite favorable. The organic resins can be readily prepared from either polyols, f>olyamines, or acrylic precursors (Figure 10) and the yields are generally quite good. When acrylate esters are used as precursors, the cycloaddition reaction occurs spontaneously and no catalysis of the reaction is necessary. 

A number of cycloaddition reactions involving allene derivatives as dienophiles have been recorded. Allene itself reacts only with electron-deficient dienes but allene carboxylic acid or esters, in which a double bond is activated by conjugation with the carboxylic group, react readily with cyclopentadiene to give 1 1 adducts in excellent yield. For example, the allene 12 gave, with very high yield and selectivity, the cycloadduct 13, used in a synthesis of (-)-P-santalene (3.19). An allene equivalent is vinyl triphenylphosphonium bromide, which is reported to react with a number of dienes to form cyclic phosphonium salts. These can be converted into methylene compounds by the usual Wittig reaction procedure (3.20). 

Diels-Alder reactions may be accelerated and the selectivities enhanced if the cycloaddition reactions are conducted in water or under high pressure or in the presence of a Lewis acid (see Section 3.1.3). In water at room temperature, cyclopentadi-ene reacts with methyl vinyl ketone 700 times faster than in 2,2,4-trimethylpentane and the endo exo selectivity rises from about 4 1 to more than 20 1. This can be ascribed to hydrophobic effects, which promote aggregation of non-polar species. Diels-Alder reactions in water are normally carried out with (at least partially) water-soluble dienes such as sodium salts of dienoic acids. Thus, a key step in a formal synthesis of vitamin D3 involved the cycloaddition of the sodium salt 46 with methacrolein in water, to give the adducts 47 and 48 in high yield and a ratio of 4.7 1 after 16 h (3.43). In contrast, the corresponding methyl ester of the diene in excess neat methacrolein at 55 °C gave only a 10% yield of a 1 1 mixture of isomers after 63... 

Vinylic ester 60 can undergo a cycloaddition reaction in the presence of zinc to produce 61 (Meyer et al. 1993) (Schane 7.22). 

---