Enol esters reaction

The stereo-defined enol ester 432 is prepared by the reaction of the vinyl-mercurial 431, obtained by acetoxymercuration of 2-butyne. with mercury(II) carboxylates using a catalytic amount of Pd(OAc)2[392]. 

Similarly, enol esters undergo rearrangement to give the corresponding 1,3-diketones. This reaction can be accompHshed thermally (500°C) or with a catalyst (58,59) ... 

In 1959 Carboni and Lindsay first reported the cycloaddition reaction between 1,2,4,5-tetrazines and alkynes or alkenes (59JA4342) and this reaction type has become a useful synthetic approach to pyridazines. In general, the reaction proceeds between 1,2,4,5-tetrazines with strongly electrophilic substituents at positions 3 and 6 (alkoxycarbonyl, carboxamido, trifluoromethyl, aryl, heteroaryl, etc.) and a variety of alkenes and alkynes, enol ethers, ketene acetals, enol esters, enamines (78HC(33)1073) or even with aldehydes and ketones (79JOC629). With alkenes 1,4-dihydropyridazines (172) are first formed, which in most cases are not isolated but are oxidized further to pyridazines (173). These are obtained directly from alkynes which are, however, less reactive in these cycloaddition reactions. In general, the overall reaction which is presented in Scheme 96 is strongly... 

The acylation of enamino ketones can take place on oxygen or on carbon. While reaction at nitrogen is a possibility, the N-acylated products are themselves acylating agents, and further reaction normally takes place. The first reported acylation of enamino ketones (72) was that of 129, prepared by acylation of the enamine (113), which was shown to have undergone O acylation because on mild hydrolysis the enol ester (130) could be isolated. A similar reaction took place with other aliphatic acid chlorides (80) and with dibasic acid chlorides [e.g., with succinyl chloride to give 118 above]. 

In its present form, intermediate 12 is not a viable substrate for the crucial Dieckmann condensation it must undergo prior epimerization at C-16. When intermediate 12 is treated with sodium methoxide in hot methanol, enolization at C-16 occurs and an equilibrium is established between 12 and a diastereomeric substance, intermediate 11. Once formed, 11 can either revert back to 12 through the planar enolate form, or it can participate in a productive cyclization reaction to give a new six-membered ring. Under these conditions, the desired transformations take place with exceptional facility to give, after acidification of the reaction medium, enol ester 10. 

Dimethyldioxirane DMDO discovered by Murray and coworkers, is a superior choice for the epoxidation of most olefins, giving comparable or higher yields than m-CPBA-based epoxidation [21]. Proceeding rapidly under neutral and mild conditions, it is especially well suited for the synthesis of sensitive epoxides of enol esters, enol lactones [22], and enol ethers [23]. The reaction is stereospecific, gen-... 

Since the initially formed enol ester rearranges slowly to an imide,3 the yield depends on the rate at which the isoxazolium salt reacts, and that rate is increased by vigorous stirring. The reaction time for the activation step is approximately 8 minutes in nitromethane at 25° and approximately 1 hour in acetonitrile at 0°. In reactions performed with acetonitrile as the solvent, the checkers did not obtain complete solution. The reaction flask should be kept in a water bath to minimize heat transfer from the magnetic stirrer to the reaction mixture. 

Enolizable compounds can be used for Meerwein reactions provided that the keto-enol equilibrium is not too far on the side of the ketone for example, P-dicar-bonyl compounds such as acetylacetone are suitable (Citterio and Ferrario, 1983). The arylation of enol esters or ethers (10.12) affords a convenient route for arylating aldehydes and ketones at the a-carbon atom (Scheme 10-48). Silyl enol ethers [10.12, R = Si(CH3)3] can be used instead of enol ethers (Sakakura et al., 1985). The reaction is carried out in pyridine. 

The acid-catalyzed hydrolysis of enol esters (RCOOCR =CR) can take place either by the normal Aac2 mechanism or by a mechanism involving initial protonation on the double-bond carbon, similar to the mechanism for the hydrolysis of enol ethers given in 10-6, ° depending on reaction conditions. In either case, the products are the carboxylic acid RCOOH and the aldehyde or ketone R2" CHCOR. ... 

The reaction between acyl halides and alcohols or phenols is the best general method for the preparation of carboxylic esters. It is believed to proceed by a 8 2 mechanism. As with 10-8, the mechanism can be S l or tetrahedral. Pyridine catalyzes the reaction by the nucleophilic catalysis route (see 10-9). The reaction is of wide scope, and many functional groups do not interfere. A base is frequently added to combine with the HX formed. When aqueous alkali is used, this is called the Schotten-Baumann procedure, but pyridine is also frequently used. Both R and R may be primary, secondary, or tertiary alkyl or aryl. Enolic esters can also be prepared by this method, though C-acylation competes in these cases. In difficult cases, especially with hindered acids or tertiary R, the alkoxide can be used instead of the alcohol. Activated alumina has also been used as a catalyst, for tertiary R. Thallium salts of phenols give very high yields of phenolic esters. Phase-transfer catalysis has been used for hindered phenols. Zinc has been used to couple... 

Therefore, transesterification reactions frequently fail when R is tertiary, since this type of substrate most often reacts by alkyl-oxygen cleavage. In such cases, the reaction is of the Williamson type with OCOR as the leaving group (see 10-14). With enol esters, the free alcohol is the enol of a ketone, so such esters easily... 

Hence, enol esters such as isopropenyl acetate are good acylating agents for alcohols. Isopropenyl acetate can also be used to convert other ketones to the corresponding enol acetates in an exchange reaction ... 

Enol esters can also be prepared in the opposite type of exchange reaction, catalyzed by mercuric acetate or Pd(II) chloride, for example. 

In a related reaction, enolate 71 is undergoing an electrophilic chlorination with 2,2,6,6-tetrachloro-cyclohexanone (74, Fig. 39), eventually leading to a-chlorinated enol esters 75 [91]. However, a different mechanism cannot be completely ruled out, where the catalyst is not acylated by the ketene, but chlorinated by the tetrachloro-ketone to form [64c-Cl] as the reactive species. 

The preparation of ketones and ester from (3-dicarbonyl enolates has largely been supplanted by procedures based on selective enolate formation. These procedures permit direct alkylation of ketone and ester enolates and avoid the hydrolysis and decarboxylation of keto ester intermediates. The development of conditions for stoichiometric formation of both kinetically and thermodynamically controlled enolates has permitted the extensive use of enolate alkylation reactions in multistep synthesis of complex molecules. One aspect of the alkylation reaction that is crucial in many cases is the stereoselectivity. The alkylation has a stereoelectronic preference for approach of the electrophile perpendicular to the plane of the enolate, because the tt electrons are involved in bond formation. A major factor in determining the stereoselectivity of ketone enolate alkylations is the difference in steric hindrance on the two faces of the enolate. The electrophile approaches from the less hindered of the two faces and the degree of stereoselectivity depends on the steric differentiation. Numerous examples of such effects have been observed.51 In ketone and ester enolates that are exocyclic to a conformationally biased cyclohexane ring there is a small preference for... 

When this reaction sequence is applied to enol esters or enol ethers, the result is a-oxygenation of the starting carbonyl compound. Enol acetates form epoxides that rearrange to a-acetoxyketones. 

In lipase-catalyzed transesterifications, frequent use of enol esters as acyl agents has been seen [1, 5], since the leaving unsaturated alcohol irreversibly tautomerizes to an aldehyde or a ketone, leading to the desired product in high yields. The polymerization of divinyl adipate and 1,4-butanediol proceeded in the presence of lipase PF at 45 °C [39]. Under similar reaction conditions, adipic acid and diethyl adipate did not afford the polymeric materials, indicating the high polymerizability of bis(enol ester) toward lipase catalyst. 

In 1992, Thornton et al. reported that Mn(salen) (43) catalyzed the asymmetric oxidation of silyl enol ethers to give a mixture of a-siloxy and a-hydroxy ketones, albeit with moderate enantioselectivity (Scheme 28).135 Jacobsen et al. examined the oxidation of enol esters with Mn(salen) (27) and achieved good enantioselectivity.136 Adam et al. also reported that the oxidation of enol ethers with (27) proceeded with moderate to high enantioselectivity.137 Good substrates for these reactions are limited, however, to conjugated enol ethers and esters. Based on the analysis of the stereochemistry,137 enol ethers have been proposed to approach the oxo-Mn center along the N—Mn bond axis (trajectory c, vide supra). 

In contrast to the reactions of acyclic ADC compounds, good evidence exists for dipolar intermediates in the reaction of PTAD with enol esters. Vinyl acetate (54, R = Me) and PTAD react in dichloromethane at 60°C to give the triazole 55 via the dipolar intermediate 56.96 When the bulkier... 

This novel resin-bound CHD derivative was then utilized in the preparation of an amide library under microwave irradiation. Reaction of the starting resin-bound CHD with an acyl or aroyl chloride yields an enol ester, which, upon treatment with amines, leads to the corresponding amide, thus regenerating the CHD. This demonstrates the feasibility of using the CHD resin as a capture and release reagent for the synthesis of amides. The resin capture/release methodology [126] aids in the removal of impurities and facilitates product purification. 

The value of 2-acyl-1,3-dithiane 1-oxides in stereocontrolled syntheses has been extended to the enantioselective formation of (3-hydroxy-y-ketoesters through ester enolate aldol reactions <00JOC6027>. 

Covalently bonded chiral auxiliaries readily induce high stereoselectivity for propionate enolates, while the case of acetate enolates has proved to be difficult. Alkylation of carbonyl compound with a novel cyclopentadienyl titanium carbohydrate complex has been found to give high stereoselectivity,44 and a variety of ft-hydroxyl carboxylic acids are accessible with 90-95% optical yields. This compound was also tested in enantioselective aldol reactions. Transmetalation of the relatively stable lithium enolate of t-butyl acetate with chloro(cyclopentadienyl)-bis(l,2 5,6-di-<9-isopropylidene-a-D-glucofuranose-3-0-yl)titanate provided the titanium enolate 66. Reaction of 66 with aldehydes gave -hydroxy esters in high ee (Scheme 3-23). 

---