Electronic surface resonances

LEED 45 Electronic surface resonance band structure of S-covered surface can be described by 2-D free-electron model... 

McRae EG (1979) Electronic surface resonances of crystals. Reviews of Modem Physics 51 541- 568. 

The polymer concentration profile has been measured by small-angle neutron scattering from polymers adsorbed onto colloidal particles [70,71] or porous media [72] and from flat surfaces with neutron reflectivity [73] and optical reflectometry [74]. The fraction of segments bound to the solid surface is nicely revealed in NMR studies [75], infrared spectroscopy [76], and electron spin resonance [77]. An example of the concentration profile obtained by inverting neutron scattering measurements appears in Fig. XI-7, showing a typical surface volume fraction of 0.25 and layer thickness of 10-15 nm. The profile decays rapidly and monotonically but does not exhibit power-law scaling [70]. 

Mechanisms of micellar reactions have been studied by a kinetic study of the state of the proton at the surface of dodecyl sulfate micelles [191]. Surface diffusion constants of Ni(II) on a sodium dodecyl sulfate micelle were studied by electron spin resonance (ESR). The lateral diffusion constant of Ni(II) was found to be three orders of magnitude less than that in ordinary aqueous solutions [192]. Migration and self-diffusion coefficients of divalent counterions in micellar solutions containing monovalent counterions were studied for solutions of Be2+ in lithium dodecyl sulfate and for solutions of Ca2+ in sodium dodecyl sulfate [193]. The structural disposition of the porphyrin complex and the conformation of the surfactant molecules inside the micellar cavity was studied by NMR on aqueous sodium dodecyl sulfate micelles [194]. 

The direct measurement of CH,- radicals, using a matrix isolation electron spin resonance system (MIESR), has previously demonstrated that surface-generated CH,-radicals are produced during the oxidative coupling of CH4 and emanate into the gas phase... 

In general, several spectroscopic techniques have been applied to the study of NO, removal. X-ray photoelectron spectroscopy (XPS), electron paramagnetic resonance (EPR), nuclear magnetic resonance (NMR), extended X-ray absorption fine structure (EXAFS) and X-ray absorption near-edge structure (XANES) are currently used to determine the surface composition of the catalysts, with the aim to identify the cationic active sites, as well as their coordinative environment. 

The electron spin resonance (ESR) technique has been extensively used to study paramagnetic species that exist on various solid surfaces. These species may be supported metal ions, surface defects, or adsorbed molecules, ions, etc. Of course, each surface entity must have one or more unpaired electrons. In addition, other factors such as spin-spin interactions, the crystal field interaction, and the relaxation time will have a significant effect upon the spectrum. The extent of information obtainable from ESR data varies from a simple confirmation that an unknown paramagnetic species is present to a detailed description of the bonding and orientation of the surface complex. Of particular importance to the catalytic chemist... 

The electron paramagnetic resonance spectrum of transition metal ions has been widely used to interpret the state of these ions in systems of catalytic interest. Major emphasis has been placed on supported chromia because of its catalytic importance in low-pressure ethylene polymerization and other commercial reactions. Earlier work on chromia-alumina catalysts has been reviewed by Poole and Maclver 146). On alumina it appears that the chromium is present in three general forms the S phase, which is isolated Cr3+ on the surface or in the lattice the 0 phase, which is clusters of Cr3+ and the y phase, which is isolated Cr5+ on the surface. The S and 0... 

The chapter Electron Spin Resonance in Catalysis by Lunsford was prompted by the extensive activity in this field since the publication of an article on a similar subject in Volume 12 of this serial publication. This chapter is limited to paramagnetic species that are reasonably well defined by means of their spectra. It contains applications of ESR technique to the study of adsorbed atoms and molecules, and also to the evaluation of surface effects. The application of ESR to the determination of the state of transition metal ions in catalytic reactions is also discussed. 

The title Spectroscopy in Catalysis is attractively compact but not quite precise. The book also introduces microscopy, diffraction and temperature programmed reaction methods, as these are important tools in the characterization of catalysts. As to applications, I have limited myself to supported metals, oxides, sulfides and metal single crystals. Zeolites, as well as techniques such as nuclear magnetic resonance and electron spin resonance have been left out, mainly because the author has little personal experience with these subjects. Catalysis in the year 2000 would not be what it is without surface science. Hence, techniques that are applicable to study the surfaces of single crystals or metal foils used to model catalytic surfaces, have been included. 

---