Electricity reducing electric bill

Note ( ) Adopted from the U.S. Department of Energy 1997 Insulation Fact sheet, (b) Insulation is also effective at reducing cooling bills. These levels assume that you have electric air-conditioning, (c) R-Values are for insulation only (not whole wall) and may be achieved through a combination of cavity (batt, loose fill, or spray) and rigid board materials, (d) Do not insulate crawl space walls if crawl space is wet or ventilated with outdoor air. 

An assessment to help reduce the spending on electricity bills and the amount of the pollutants produced was the highlight of the project. 

Before the third series of tests was made, additional research was required to find or develop an ultra-fast opening valve. This was the only major component that could be replaced to further reduce the response time. Information from Detector Electronics Corporation introduced us to a valve manufactured by Grinnell, called the Primac valve, which seemed to fit the bill. The valve uses a primer detonating device with redundant detonators to blow the valve open. The same electrical signal initiated by the ultraviolet sensor could now be used to actuate the detonators, thus further reducing lost motion. 

Excess Emission Reduction Targets — Most of the serious proposals for acid rain control (in fact, both the House and Senate bills of 1984) involve some formula for allocating reductions excess emissions of SO2 over a defined population of emitters (in almost all cases, electric utilities). The principal focus of these efforts is to reduce total regional emissions, thus avoiding the nationally uniform, ambient requirements of the NAAQS. While the proposals differ as to who must come into compliance with what, when, and how, they share the common feature of requiring proportional reductions, in emissions above some threshold level (7). The political and economic implications of this approach have been discussed extensively elsewhere (8). 

The load factor on an electric utility company bill is a product of the peak demand and energy usage, ft usually is calculated and applied to the customer s bill each month. Reducing either the peak demand or energy usage levels, or both, will decrease this added cost factor. Reducing power factor penalties also will help to reduce load factor charges. 

---