Dropwise addition

Alkynes undergo stoichiometric oxidative reactions with Pd(II). A useful reaction is oxidative carboiiyiation. Two types of the oxidative carbonyla-tion of alkynes are known. The first is a synthesis of the alkynic carbox-ylates 524 by oxidative carbonylation of terminal alkynes using PdCN and CuCh in the presence of a base[469], Dropwise addition of alkynes is recommended as a preparative-scale procedure of this reation in order to minimize the oxidative dimerization of alkynes as a competitive reaction[470]. Also efficient carbonylation of terminal alkynes using PdCU, CuCI and LiCi under CO-O2 (1 I) was reported[471]. The reaction has been applied to the synthesis of the carbapenem intermediate 525[472], The steroidal acetylenic ester 526 formed by this reaction undergoes the hydroarylalion of the triple bond (see Chapter 4, Section 1) with aryl iodide and formic acid to give the lactone 527(473],... 

The previous product was added to LiAlH (6 eq.) in THF. The solution was heated at reflux for 1 h. The excess hydride was destroyed by dropwise addition of water and the resulting mixture filtered through Celite. The filtrate was diluted with EtOAc, washed with brine and dried (Na2S04). The product was an oil (3.4 g, 98%). 

Dissolve 1.000 g Au in 10 ml of hot HNO3 by dropwise addition of HCI, boil to expel oxides of nitrogen and chlorine, and dilute to volume. Store in amber container away from light. 

Titanium Dissolve 1.000 g Ti in 10 ml of H2SO4 with dropwise addition of HNO3 dilute to vol-... 

It was recrystd twice as the free base from ethanol or methanol/water by dropwise addition of NaOH (less than O.IM). The ppte was washed with water and dried under vacuum. It was dissolved in CHCI3 and chromatographed on alumina the main sharp band was collected, concentrated and cooled to -20 . The ppte was filtered, dried in air, then dried for 2h under vacuum at 70°- [Stone and Bradley J Am Chem Soc 83 3627 1961 , Blauer and Linschitz J Phys Chem 66 453 1962.]... 

Bromocresol Green (3, 3",5, 5"-tetrabromo-m-cresolsulfonephthalein) [76-60-8] M 698.0, m 218-219 (dec), 225 (dec), pK 4.51. Crystd from glacial acetic acid or dissolved in aqueous 5% NaHC03 soln and ppted from hot soln by dropwise addition of aqueous HCl. Repeated until the extinction did not increase (X ,ax 423nm). Indicator at pH 3.81 (yellow) and pH 5.4 (blue-green). 

Methyl Red (4-dimethylaminoazobenzene-2 -carboxylic acid) [493-52-7] M 269.3, m 181-182 , Cl 13020, pK j 2.30, pK2 4.82. The acid is extracted with boiling toluene using a Soxhlel apparatus. The crystals which separated on slow cooling to room temperature are filtered off, washed with a little toluene and recrysld from glacial acetic acid, benzene or toluene followed by pyridine/waler. Alternatively, dissolved in aq 5% NaHC03 soln, and ppted from hot soln by dropwise addition of aq HCl. Repealed until the extinction coefficients did not increase. 

Hydrazine monohydrochloride [2644-70-4] M 68.5, m 89°. Prepared by dropwise addition of cold cone HCl to cold liquid hydrazine in equimolar amounts. The crystals were harvested from water and were twice recrystd from absolute MeOH and dried under vacuum. [Kovack et al. J Am Chem Soc 107 7360 1985.]... 

Fructose-1,6-diphosphate (trisodium sait) [38099-82-0] M 406.1, pKj 6.14, pK 6.93 (free acid). For purification via the acid strychnine salt, see Neuberg, Lustig and Rothenberg [Arch Biochem 3 33 1943]. The calcium salt can be partially purified by soln in ice-cold M HCl (Ig per lOmL) and repptn by dropwise addition of 2M NaOH the ppte and supernatant are heated on a boiling water bath for a short time, then filtered and the ppte is washed with hot water. The magnesium salt can be pptd from cold aqueous soln by adding four volumes of EtOH. 

Ethanol-free ether should be used. Dropwise addition of 50 ml. of concentrated sulfuric acid to 1 1. of ether, and distillation of the ether from a steam bath gives a satisfactory solvent. 

In a 600-ml. beaker fitted with a thermometer and mechanical stirrer are placed 150 ml. of concentrated hydrochloric acid and 55 g. (0.32 mole) of o-bromoaniline. After brief stirring, 100 g. of ice is added and the beaker is surrounded by an ice-salt bath. The solution is then diazotized by the dropwise addition with stirring of a solution of 24.3 g. (0.35 mole) of sodium nitrite in 100 ml. of water, the temperature being kept at 0-5°. 

A solution of the ketol diacetate (15 g, 0.028 mole) in toluene (200 ml) is dried by concentration to 150 ml at normal pressure. The solution is cooled to room temperature and then added with vigorous stirring to a solution of calcium turnings (4.2 g, 0.11 g-atom) in liquid ammonia (500 ml). The addition is made in 5 min, the mixture is stirred for a further 3 min, and excess calcium is then destroyed by the dropwise addition of bromobenzene ca. 4 ml). Water (5 ml) is added cautiously and the ammonia is allowed to evaporate. The toluene is removed by distillation on a steam-bath under reduced pressure and methanol (200 ml) is added to the residue, followed by a solution of potassium hydroxide (5 g) in water (10 ml). The mixture is boiled for 1 hr, water (50 ml) is added, and the mixture is warmed on the steam bath for 30 min in order to coagulate the product. Water (250 ml) and acetic acid (15 ml) are added, the mixture is cooled and the product filtered, washed thoroughly with water and dried to give 12.3 g of crude 11-ketotigogenin, mp 209-218° Md, -31°. 

A 8 A solution of chromic acid is prepared by dissolving 26.72 g of chromium trioxide in a mixture of 23 ml of concentrated sulfuric acid and enough water to make the total volume of the solution 100 ml. Rapid dropwise addition of a slight excess of this reagent to an acetone solution (2 % or less) of the hydroxy steroid at room temperature or below with stirring usually results in complete conversion to ketone in less than 10 min. The product is isolated by dilution with water followed by filtration or extraction. 

A total of 3 g (0.13 moles) of sodium hydride is added to a solution consisting of 10 g of 17 -hydroxy-5a-androstan-3-one (36 mmoles) in 200 ml of benzene and 10 ml of ethyl formate. The reaction mixture is allowed to stand under nitrogen for 3 days followed by dropwise addition of 10 ml of methanol to decompose the excess of sodium hydride. The solution is then diluted with 300 ml water and the layers are separated. The basic aqueous solution is extracted with ether to remove neutral material. The aqueous layer is acidified with 80 ml of 3 A hydrochloric acid and the hydroxymethylene steroid is extracted with benzene and ether. The combined organic extracts are washed with water and saturated sodium chloride solution and then dried over magnesium sulfate and concentrated. The residue, a reddish-yellow oil, crystallized from 10 ml of ether to yield 9.12 g (83%) of 17 -hydroxy-2-hydroxymethylene-5a-androstan-3-one mp 162-162.5°. Recrystallization from chloroform-ether gives an analytical sample mp 165-165.5° [a]o 53° (ethanol) 2 ° 252 mjj. (g 11,500), 307 m u (e 5,800). 

P-Formyl-B-nor-5 -cholestane-3, 5P-diol 3-Acetate (74). To an ozonized solution of 5 g of cholesterol acetate prepared as above is added 10 g of zinc dust followed by dropwise addition of 40 ml of acetic acid with stirring and... 

Hydroxy- 6-diazoandrost-5-en- l-one (96) To a stirred solution of 750 ml of methanol and 144 ml of 5 A sodium hydroxide is added 36 g (0.114 mole) of oximino ketone. Concentrated aqueous ammonia (56.6 ml, 0.850 mole) is then added followed by dropwise addition of 265 ml of cold 3 M sodium hypochlorite at a rate sufficient to maintain the temperature of the exothermic reaction mixture at 20 + 1° while cooling with an external ice bath. At temperatures below 20° appreciable amounts of a-mono- and a-dichloro ketones are obtained above 20° the chloramine decomposes before reacting with the oximino ketone. As soon as all of the sodium hypochlorite has been added, the ice bath is removed and the reaction mixture is allowed to warm to room temperature with continued stirring for 6 hr. The reaction mixture is diluted with an equal volume of water and extracted twice with... 

A solution of 12.5 g (0.088 mole) of l,4-dioxaspiro[4.5]decane (Chapter 7, Section IX) in 200 ml of anhydrous ether is added to the stirred mixture at a rate so as to maintain a gentle reflux. (Cooling in an ice bath is advisable.) The reaction mixture is then refluxed for 3 hours on a steam bath. Excess hydride is carefully destroyed by the dropwise addition of water (1-2 ml) to the ice-cooled vessel until hydrogen is no longer evolved. Sulfuric acid (100 ml of 10% solution) is now added followed by 40 ml of water, resulting in the formation of two clear layers. The ether layer is separated and the aqueous layer extracted with three 20-ml portions of ether. The combined ethereal extracts are washed with saturated sodium bicarbonate solution followed by saturated sodium chloride solution. The ethereal solution is dried over anhydrous potassium carbonate (20-24 hours), filtered, and concentrated by distillation at atmospheric pressure. The residue is distilled under reduced pressure affording 2-cyclohexyloxy-ethanol as a colorless liquid, bp 96-98°/ 3 mm, 1.4600-1.4610, in about 85% yield. 

The trialkylborane is oxidized by the addition to the stirred reaction mixture of 32 ml of a 3 solution of sodium hydroxide, followed by the dropwise addition of 32 ml of 30 % hydrogen peroxide at a temperature of 30-32° (water bath). The reaction mixture is saturated with sodium chloride and the tetrahydrofuran layer formed is separated and washed with saturated sodium chloride solution. The organic solution is dried over anhydrous magnesium sulfate and the THF is removed. Distillation affords 24.5 g (80%) of 4-methyl-1-pentanol, bp I51-153°/735 mm. 

The excess diborane in the hydroboration flask is decomposed by the cautious addition of 20 ml of water. The organoborane is oxidized by the addition of 32 ml of 3 A sodium hydroxide, followed by dropwise addition of 32 ml of 30% hydrogen peroxide... 

A 500-ml flask is equipped with a thermometer, a magnetic stirrer, and a dropping funnel, and all openings are protected by drying tubes. The system is flushed with nitrogen and a solution of 2.84 g (0.075 mole) of sodium borohydride in 150 ml of diglyme is introduced followed by 28.3 g (0.30 mole) of norbornene. The flask is immersed in an ice-water bath and the hydroboration is achieved by the dropwise addition of 27.4 ml (0.10 mole) of boron trifluoride diglymate. The solution is stirred... 

A dry 5(X)-mI flask equipped with a thermometer, pressure-equalizing dropping funnel, and magnetic stirrer is flushed with nitrogen and then maintained under a static pressure of the gas. The flask is charged with 50 ml of tetrahydrofuran and 13.3 ml (0.15 mole) of cyclopentene, and then is cooled in an ice bath. Conversion to tricyclo-pentylborane is achieved by dropwise addition of 25 ml of a 1 M solution of diborane (0.15 mole of hydride see Chapter 4, Section 1 for preparation) in tetrahydrofuran. The solution is stirred for 1 hour at 25° and again cooled in an ice bath, and 25 ml of dry t-butyl alcohol is added, followed by 5.5 ml (0.05 mole) of ethyl bromoacetate. Potassium t-butoxide in /-butyl alcohol (50 ml of a 1 M solution) is added over a period of 10 minutes. There is an immediate precipitation of potassium bromide. The reaction mixture is filtered from the potassium bromide and distilled. Ethyl cyclopentylacetate, bp 101730 mm, 1.4398, is obtained in about 75% yield. Similarly, the reaction can be applied to a variety of olefins including 2-butene, cyclohexene, and norbornene. 

Formation of azo-type products might be troublesome. These by-products, arising from reduction of aromatic nitro compounds, usually are assumed to be derived from the coupling of intermediate nitroso and hydroxylamine compounds. The coupling problem is accentuated in reduction of nitroso compounds because of much higher concentrations. It can be alleviated by dropwise addition of the substrate to the hydrogenation and use of acidic media. 

The mixture was hydrolyzed in the cold by the dropwise addition of 50 ml of water. The benzene layer was separated by decantation and the gelatinous precipitate washed with two 100 ml portions of benzene. 

---