Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Divalent formation

The effect is more than just a matter of pH. As shown in Fig. XV-14, phospholipid monolayers can be expanded at low pH values by the presence of phosphotungstate ions [123], which disrupt the stmctival order in the lipid film [124]. Uranyl ions, by contrast, contract the low-pH expanded phase presumably because of a type of counterion condensation [123]. These effects caution against using these ions as stains in electron microscopy. Clearly the nature of the counterion is very important. It is dramatically so with fatty acids that form an insoluble salt with the ion here quite low concentrations (10 M) of divalent ions lead to the formation of the metal salt unless the pH is quite low. Such films are much more condensed than the fatty-acid monolayers themselves [125-127]. [Pg.557]

Certain salts of divalent metals (e.g., lead and copper formate, calcium acetate) are exceptional in giving bright green fluorescences. In each case confirmatory tests must always be employed. [Pg.351]

Separation Processes. The product of ore digestion contains the rare earths in the same ratio as that in which they were originally present in the ore, with few exceptions, because of the similarity in chemical properties. The various processes for separating individual rare earth from naturally occurring rare-earth mixtures essentially utilize small differences in acidity resulting from the decrease in ionic radius from lanthanum to lutetium. The acidity differences influence the solubiUties of salts, the hydrolysis of cations, and the formation of complex species so as to allow separation by fractional crystallization, fractional precipitation, ion exchange, and solvent extraction. In addition, the existence of tetravalent and divalent species for cerium and europium, respectively, is useful because the chemical behavior of these ions is markedly different from that of the trivalent species. [Pg.543]

Rates of Reaction. The rates of formation and dissociation of displacement reactions are important in the practical appHcations of chelation. Complexation of many metal ions, particulady the divalent ones, is almost instantaneous, but reaction rates of many higher valence ions are slow enough to measure by ordinary kinetic techniques. Rates with some ions, notably Cr(III) and Co (III), maybe very slow. Systems that equiUbrate rapidly are termed kinetically labile, and those that are slow are called kinetically inert. Inertness may give the appearance of stabiUty, but a complex that is apparentiy stable because of kinetic inertness maybe unstable in the thermodynamic equihbrium sense. [Pg.386]

There are two distinct groups of aldolases. Type I aldolases, found in higher plants and animals, require no metal cofactor and catalyze aldol addition via Schiff base formation between the lysiae S-amino group of the enzyme and a carbonyl group of the substrate. Class II aldolases are found primarily ia microorganisms and utilize a divalent ziac to activate the electrophilic component of the reaction. The most studied aldolases are fmctose-1,6-diphosphate (FDP) enzymes from rabbit muscle, rabbit muscle adolase (RAMA), and a Zn " -containing aldolase from E. coli. In vivo these enzymes catalyze the reversible reaction of D-glyceraldehyde-3-phosphate [591-57-1] (G-3-P) and dihydroxyacetone phosphate [57-04-5] (DHAP). [Pg.346]

Metal ion complexation rates have been studied by the T-jump method. ° Divalent nickel and cobalt have coordination numbers of 6, so they can form complexes ML with monodentate ligands L with n = 1—6 or with bidentate ligands, n = 1-3. The ligands are Bronsted bases, and only the conjugate base form undergoes coordination with the metal ion. The complex formation reaction is then... [Pg.150]

Two classes of aldolase enzymes are found in nature. Animal tissues produce a Class I aldolase, characterized by the formation of a covalent Schiff base intermediate between an active-site lysine and the carbonyl group of the substrate. Class I aldolases do not require a divalent metal ion (and thus are not inhibited by EDTA) but are inhibited by sodium borohydride, NaBH4, in the presence of substrate (see A Deeper Look, page 622). Class II aldolases are produced mainly in bacteria and fungi and are not inhibited by borohydride, but do contain an active-site metal (normally zinc, Zn ) and are inhibited by EDTA. Cyanobacteria and some other simple organisms possess both classes of aldolase. [Pg.620]

During the next fifty years the interest in derivatives of divalent carbon was mainly confined to methylene (CHg) and substituted methylenes obtained by decomposition of the corresponding diazo compounds this phase has been fully reviewed by Huisgen. The first convincing evidence for the formation of dichlorocarbene from chloroform was presented by Hine in 1950. Kinetic studies of the basic hydrolysis of chloroform in aqueous dioxane led to the suggestion that the rate-determining step was loss of chloride ion from the tri-chloromethyl anion which is formed in a rapid pre-equilibrium with hydroxide ions ... [Pg.58]

The combined effects of a divalent Ca counterion and thermal treatment can be seen from studies of PMMA-based ionomers [16]. In thin films of Ca-salts of this ionomer cast from methylene chloride, and having an ion content of only 0.8 mol%, the only observed deformation was a series of long, localized crazes, similar to those seen in the PMMA homopolymer. When the ionomer samples were subject to an additional heat treatment (8 h at 100°C), the induced crazes were shorter in length and shear deformation zones were present. This behavior implies that the heat treatment enhanced the formation of ionic aggregates and increased the entanglement strand density. The deformation pattern attained is rather similar to that of Na salts having an ion content of about 6 mol% hence, substitution of divalent Ca for monovalent Na permits comparable deformation modes, including some shear, to be obtained at much lower ion contents. [Pg.149]

Curve B describes the corresponding relation for the oxidation of divalent lead ions Pb2+ -> Pb4+, which implies the formation of lead dioxide since Pb4+ does not exist alone ... [Pg.158]

Adenylyl Cyclases. Table 4 Nucleotide inhibitors of adenylyl cyclase. Enzyme source and assay conditions were as for Table 3. Values obtained for 3 -ATP are overestimations due to the formation of 2 3 -cAMP from 3 -ATP that occurs nonenzymatically in the presence of divalent cation... [Pg.35]

The type of catalyst influences the rate and reaction mechanism. Reactions catalyzed with both monovalent and divalent metal hydroxides, KOH, NaOH, LiOH and Ba(OH)2, Ca(OH)2, and Mg(OH)2, showed that both valence and ionic radius of hydrated cations affect the formation rate and final concentrations of various reaction intermediates and products.61 For the same valence, a linear relationship was observed between the formaldehyde disappearance rate and ionic radius of hydrated cations where larger cation radii gave rise to higher rate constants. In addition, irrespective of the ionic radii, divalent cations lead to faster formaldehyde disappearance rates titan monovalent cations. For the proposed mechanism where an intermediate chelate participates in the reaction (Fig. 7.30), an increase in positive charge density in smaller cations was suggested to improve the stability of the chelate complex and, therefore, decrease the rate of the reaction. The radii and valence also affect the formation and disappearance of various hydrox-ymethylated phenolic compounds which dictate the composition of final products. [Pg.405]

The solubility of numerous ionic surfactants in water is strongly reduced in the presence of divalent cations. Stability in hard water is thus an important fact for surfactants used as detergents. Their stability can be measured as the amount of divalent cations at which the formation of a poorly soluble surfactant salt leads to permanent turbidity. The values given in the literature can only be... [Pg.480]

On the left, the divalent metal ion is spherical with a J-electron configuration which is amply described as d". On the right, the metal is engaged in six octahedrally disposed bonds and its J-electron configuration is best recorded as The electronic contributions to the hydration process refer, as usual, to the formation of the bonds and the attraction of electrons to the central metal, to the... [Pg.152]

The majority of the work on xanthates of divalent nickel has, in recent years, been centered on the formation of base adducts with [Ni(Rxant)2]. Carlin and Siegel (348) and Daktenieks and Graddon (349) reported the formation of paramagnetic [Ni(Etxant)2B2] or [Ni(Etaxant)2B], where B = pyridine, 4-methylpyridine, bipyridyl, or... [Pg.256]


See other pages where Divalent formation is mentioned: [Pg.34]    [Pg.222]    [Pg.222]    [Pg.62]    [Pg.63]    [Pg.205]    [Pg.288]    [Pg.510]    [Pg.121]    [Pg.296]    [Pg.299]    [Pg.549]    [Pg.194]    [Pg.311]    [Pg.472]    [Pg.400]    [Pg.488]    [Pg.359]    [Pg.53]    [Pg.152]    [Pg.317]    [Pg.438]    [Pg.891]    [Pg.112]    [Pg.266]    [Pg.822]    [Pg.1088]    [Pg.1244]    [Pg.154]    [Pg.275]    [Pg.375]    [Pg.54]    [Pg.168]    [Pg.308]    [Pg.180]    [Pg.232]   
See also in sourсe #XX -- [ Pg.24 ]




SEARCH



Divalent

Divalents

© 2024 chempedia.info