Depression solvents

Osmotic distillation also removes the solvent from a solution through a microporous membrane that is not wetted by the liquid phase. Unlike membrane distillation, which uses a thermal gradient to manipulate the activity of the solvent on the two sides of the membrane, an activity gradient in osmotic distillation is created by using a brine or other concentrated solution in which the activity of the solvent is depressed. Solvent transport occurs at a rate proportional to the local activity gradient. Since the process operates essentially isothermally, heat-sensitive solutions may be concentrated quickly without an adverse effect. Commercially, osmotic distillation has been used to de-water fruit juices and liquid foods. In principle, pharmaceuticals and other delicate solutes may also be processed in this way. 

Solvent Molecular depression constant CCjmole) water 1-86... 

Raoult s law When a solute is dissolved in a solvent, the vapour pressure of the latter is lowered proportionally to the mole fraction of solute present. Since the lowering of vapour pressure causes an elevation of the boiling point and a depression of the freezing point, Raoult s law also applies and leads to the conclusion that the elevation of boiling point or depression of freezing point is proportional to the weight of the solute and inversely proportional to its molecular weight. Raoult s law is strictly only applicable to ideal solutions since it assumes that there is no chemical interaction between the solute and solvent molecules. 

Neither Friedel-Crafts acylation nor alkylation reactions can be earned out on mtroben zene The presence of a strongly deactivating substituent such as a nitro group on an aromatic ring so depresses its reactivity that Friedel-Crafts reactions do not take place Nitrobenzene is so unreactive that it is sometimes used as a solvent m Friedel-Crafts reactions The practical limit for Friedel-Crafts alkylation and acylation reactions is effectively a monohalobenzene An aromatic ring more deactivated than a mono halobenzene cannot be alkylated or acylated under Friedel-Crafts conditions... 

The cryoscopic constant Kj gives the depression of the melting point AT (in degrees Celsius) produced when 1 mol of solute is dissolved in 1000 g of a solvent. It is applicable only to dilute solutions for which the number of moles of solute is negligible in comparison with the number of moles of solvent. It is often used for molecular weight determinations. 

This is an expression of Raoult s law which we have used previously. Freezing point depression. A solute which does not form solid solutions with the solvent and is therefore excluded from the solid phase lowers the freezing point of the solvent. It is the chemical potential of the solvent which is lowered by the solute, so the pure solvent reaches the same (lower) value at a lower temperature. At equilibrium... 

Full eye protection should be worn whenever handling acryhc monomers contact lenses must never be worn. Prolonged exposure to Hquid or vapor can result in permanent eye damage or blindness. Excessive exposure to vapors causes nose and throat irritation, headaches, nausea, vomiting, and dizziness or drowsiness (solvent narcosis). Overexposure may cause central nervous system depression. Both proper respiratory protection and good ventilation are necessary wherever the possibiHty of high vapor concentration arises. 

In more recent times, naphthalene has been used in condensation products from naphthalene sulfonic acids, utili2ing formaldehyde as additives to improve the flow properties of concrete these are referred to as superplastici2ers. Another newer appHcation is the production of diisopropylnaphthalenes. The mutual depression of the melting points in the mixture gives a Hquid which is used as a solvent for dyes in the production of carbonless copy paper. 

The polarity of the polymer is important only ia mixtures having specific polar aprotic solvents. Many solvents of this general class solvate PVDC strongly enough to depress the melting temperature by more than 100°C. SolubiUty is normally correlated with cohesive energy densities or solubiUty parameters. For PVDC, a value of 20 0.6 (J/cm (10 0.3 (cal/cm ) has been estimated from solubiUty studies ia nonpolar solvents. The value... 

AH volatile organic solvents are toxic to some degree. Excessive vapor inhalation of the volatile chloriaated solveats, and the central nervous system depression that results, is the greatest hazard for iadustrial use of these solvents. Proper protective equipment and operating procedures permit safe use of solvents such as methylene chloride, 1,1,1-trichloroethane, trichloroethylene, and tetrachloroethylene ia both cold and hot metal-cleaning operations. The toxicity of a solvent cannot be predicted from its chlorine content or chemical stmcture. For example, 1,1,1-trichloroethane is one of the least toxic metal-cleaning solvents and has a recommended threshold limit value (TLV) of 350 ppm. However, the 1,1,2-trichloroethane isomer is one of the more toxic chloriaated hydrocarboas, with a TLV of only 10 ppm. 

Toxicity. 1,1-Dichloroethane, like all volatile chlorinated solvents, has an anesthetic effect and depresses the central nervous system at high vapor concentrations. The 1991 American Conference of Governmental Industrial Hygienists (ACGIH) recommends a time-weighted average (TWA) solvent vapor concentration of 200 ppm and a permissible short term exposure level (STEL) of 250 ppm for worker exposure. The oral LD q of... 

Anaestheties and nareoties, e.g. hydroearbons and eertain derivatives sueh as tlie various ehlorinated solvents or ether, exert a depressant aetion on the eentral nervous system. 

The solvent has a sweetish odour similar to chloroform detectable at about 30 ppm. It is primarily a depressant of tlie central nervous system (CNS). Significant impairment of performance in behavioural tests and some CNS effects have occuiTed at 1000 ppm but not at 300 ppm prenarcotic symptoms have occuired at mean levels of 200 ppm to 300 ppm. 

Solvents acetone, methyl ethyl ketone (MEK), toluene, xylene, glycol, ethers, alcohol defats and dries skin some may be absorbed may carry other components through skin high volatility, exposure possible irritation central nervous system depression (e.g. dizziness, loss of coordination) low to high toxicity, longterm effects... 

The most widely known aleohol is ethyl aleohol, simply beeause it is the aleohol in aleoholie drinks. It is also known as grain aleohol, or by its proper name, ethanol. Ethyl aleohol is a eolorless, volatile liquid with a eharaeteristie odor and a pungent taste. It has a flash point of 55°F, is classified as a depressant drug, and is toxic when ingested in large quantities. Its molecular formula is CjHjOH. In addition to its presence in alcoholic beverages, ethyl alcohol has many industrial and medical uses, such as a solvent in many manufacturing processes, as antifreeze, antiseptics, and cosmetics. 

Aromatic steroids are virtually insoluble in liquid ammonia and a cosolvent must be added to solubilize them or reduction will not occur. Ether, ethylene glycol dimethyl ether, dioxane and tetrahydrofuran have been used and, of these, tetrahydrofuran is the preferred solvent. Although dioxane is often a better solvent for steroids at room temperature, it freezes at 12° and its solvent effectiveness in ammonia is diminished. Tetrahydrofuran is infinitely miscible with liquid ammonia, but the addition of lithium to a 1 1 mixture causes the separation of two liquid phases, one blue and one colorless, together with the separation of a lithium-ammonia bronze phase. Thus tetrahydrofuran and lithium depress the solubilities of each other in ammonia. A tetrahydrofuran-ammonia mixture containing much over 50 % of tetrahydrofuran does not become blue when lithium is added. In general, a 1 1 ratio of ammonia to organic solvents represents a reasonable compromise between maximum solubility of steroid and dissolution of the metal with ionization. 

---