Ethylene glycol, dimethyl ether

The addition product, C QHgNa, called naphthalenesodium or sodium naphthalene complex, may be regarded as a resonance hybrid. The ether is more than just a solvent that promotes the reaction. StabiUty of the complex depends on the presence of the ether, and sodium can be Hberated by evaporating the ether or by dilution using an indifferent solvent, such as ethyl ether. A number of ether-type solvents are effective in complex preparation, such as methyl ethyl ether, ethylene glycol dimethyl ether, dioxane, and THF. Trimethyl amine also promotes complex formation. This reaction proceeds with all alkah metals. Other aromatic compounds, eg, diphenyl, anthracene, and phenanthrene, also form sodium complexes (16,20). 

Ethylene glycol dimethyl ether (monoglyme) [110-71-4] M 90.1. See 1,2-dimethoxyethane on... 

Tetrahydrofuran may be purified by refluxing over solid potassium hydroxide, followed by distillation from lithium alu-miniun hydride. Tetrahydrofuran may be replaced by ethylene glycol dimethyl ether (dimethoxyethane). The submitter has indicated that either solvent may be freed conveniently from water, alcohols, and moderate amounts of peroxides by passing the commercial solvent through a column (2 in. diameter X 2-3 ft. length) of Linde Air Products Molecular Sieves (type 13A iQ- n. pellets), at a rate of approximately 100 ml. per minute. 

Aromatic steroids are virtually insoluble in liquid ammonia and a cosolvent must be added to solubilize them or reduction will not occur. Ether, ethylene glycol dimethyl ether, dioxane and tetrahydrofuran have been used and, of these, tetrahydrofuran is the preferred solvent. Although dioxane is often a better solvent for steroids at room temperature, it freezes at 12° and its solvent effectiveness in ammonia is diminished. Tetrahydrofuran is infinitely miscible with liquid ammonia, but the addition of lithium to a 1 1 mixture causes the separation of two liquid phases, one blue and one colorless, together with the separation of a lithium-ammonia bronze phase. Thus tetrahydrofuran and lithium depress the solubilities of each other in ammonia. A tetrahydrofuran-ammonia mixture containing much over 50 % of tetrahydrofuran does not become blue when lithium is added. In general, a 1 1 ratio of ammonia to organic solvents represents a reasonable compromise between maximum solubility of steroid and dissolution of the metal with ionization. 

DME ethylene glycol dimethyl ether TBAI tetra-n-butylammonium iodide... 

The reaction of [CH3Co(salen)H20] with n-C3F7l results in the formation of [ -C3F7Co(salen)] in almost quantitative yield. The reaction occurs in 3 days at room temperature or within 30 minutes on refluxing in ethylene, glycol dimethyl ether 174a). 

SOLINOX SO,. Linde NO,] A process for removing both NOx and SOx from fluegases. The SOx is removed by scrubbing with tetra-ethylene glycol dimethyl ether, circulated in a packed tower (the Selexol process). The NOx is destroyed by Selective Catalytic Reduction ( SCR). The sorbent is regenerated with steam the SOx is recovered for conversion to sulfuric acid. Developed by Linde in 1985 and used in a lead smelter in Austria and several power stations in Germany. In 1990 it was announced that it would be used at the titanium pigment plant in The Netherlands operated by Sachtleben. 

Before use, 1,2-dimethoxyethane (ethylene glycol dimethyl ether) was partially dried over anhydrous calcium chloride and then distilled from lithium aluminum hydride. It was stored over sodium ribbon. 

Benzene, Arsenic trichloride, Aluminum chloride. Hexanes Acetic anhydride. Nitric acid, Hexamine, Acetic acid, Methylene chloride. Sodium bicarbonate, Magnesium sulfate, Dioxane, Hydrogen chloride, Acetone, Sodium azide m-phenylenediamine, Methanol, Sodium carbonate, Ethyl chloromate, Ethylene glycol dimethyl ether, Sulfuric acid, Nitric acid... 

Copper, silver, and gold colloids have been prepared by Chemical Liquid Deposition (CLD) with dimethoxymethane, 2-methoxyethyl ether, and ethylene glycol dimethyl ether. The metals are evaporated to yield atoms which are solvated at low temperatures and during the warm-up process colloidal sols with metal clusters are obtained. Evaporation of the solvent was carried out under vacuum-generating metal films. These films are showing very low carbon/hydrogen content and were characterized by elemental analyses and infrared spectroscopy (Cardenas et al., 1994). 

---