Deagglomeration mechanical

A composition based on diketopiperazine derivatives (3,6-bis (N-fumaryl-N-(n-butyl) amino-2, 5-diketopiperazine) has been investigated as a pulmonary drug delivery system, termed Technospheres (Pharmaceutical Discovery Corp., Elmsford, NY) (Pohl et al. 2000 Steiner et al. 2002). The diketopiperazine derivatives self-assemble into microparticles at low pH with a mean diameter of approximately 2 pm. During self-assembly, diketopiperazine derivatives microencapsulate peptides present in the solution. Insulin incorporated in diketopiperazine derivatives (TI) was administered to five healthy humans by the use of a capsule-based inhaler with a passive powder deagglomeration mechanism. Relative and absolute bioavailability of TI in the first 3 hours (0-180 min) were 26 12% and 15 5%, and for 6 hours (0-360 min) 16 8% and 16 6%, respectively (Steiner et al. 2002). The time to peak action for glucose infusion rates was shorter with both IV (14 6 min) injection and inhalation (39 36 min), as compared to SC administration (163 25 min). This rapid absorption of insulin would be beneficial for diabetic patients who need to rapidly affect their glucose levels. 

Convection heat transfer is dependent largely on the relative velocity between the warm gas and the drying surface. Interest in pulse combustion heat sources anticipates that high frequency reversals of gas flow direction relative to wet material in dispersed-particle dryers can maintain higher gas velocities around the particles for longer periods than possible ia simple cocurrent dryers. This technique is thus expected to enhance heat- and mass-transfer performance. This is apart from the concept that mechanical stresses iaduced ia material by rapid directional reversals of gas flow promote particle deagglomeration, dispersion, and Hquid stream breakup iato fine droplets. Commercial appHcations are needed to confirm the economic value of pulse combustion for drying. 

Screening Particle size reduction by mechanically-induced attrition through a screen (commonly referred to as milling or deagglomeration) Tumble Milling Particle size reduction by attrition, using grinding media... 

A very convincing piece of evidence for agglomeration-deagglomeration as an important loss mechanism is the close empirical relationship between the maximum value of the loss modulus, G"m, and the height of the step in the storage modulus G (y0) as a function of deformation amplitude ... 

The whiskers are normally received from commercial sources in an agglomerated form and appear to be spray-dried balls. Deagglomeration and dispersion of the SiC whiskers has been found to be extremely important in the fabrication of composites with good mechanical... 

---