Cyclopropanation cycloaddition

Cyclopropanation. Cycloaddition involving carbenoids bearing both donor and acceptor substituents is effectively catalyzed by AgSbFg. Alkenes that are reluctant to react with catalysis by Rh2(OAc)4 (e.g., those prefer to undergo C—H insertion or with a stericaUy hindered double bond) are more susceptible to participate/... 

Young, I.S., Williams, J.L., and Kerr, M.A. (2005) Diastereoselective synthesis of pyrrolidines using a nitrone/cyclopropane cycloaddition Synthesis of the tetracyclic core of nakadomarin A. Org. Lett., 7, 953-955. 

Some straightforward, efficient cyclopentanellation procedures were developed recently. Addition of a malonic ester anion to a cyclopropane-1,1-dicarboxylic ester followed by a Dieckmann condensation (S. Danishefsky, 1974) or addition of iJ-ketoester anions to a (l-phenylthiocyclopropyl)phosphonium cation followed by intramolecular Wittig reaction (J.P, Marino. 1975) produced cyclopentanones. Another procedure starts with a (2 + 21-cycloaddition of dichloroketene to alkenes followed by regioselective ring expansion with diazomethane. The resulting 2,2-dichlorocyclopentanones can be converted to a large variety of cyclopentane derivatives (A.E. Greene. 1979 J.-P. Deprds, 1980). 

As final examples, the intramolecular cyclopropane formation from cycloolefins with diazo groups (S.D. Burke, 1979), intramolecular cyclobutane formation by photochemical cycloaddition (p. 78, 297f., section 4.9), and intramolecular Diels-Alder reactions (p. 153f, 335ff.) are mentioned. The application of these three cycloaddition reactions has led to an enormous variety of exotic polycycles (E.J. Corey, 1967A). 

This reaction is called the Smmons-Smith reaction and is one of the few methods avail able for the synthesis of cyclopropanes Mechanistically the Simmons-Smith reaction seems to proceed by a single step cycloaddition of a methylene (CH2) unit from lodomethylzmc iodide to the alkene... 

The behavior of strained,/Zuorimiret/ methylenecyelopropanes depends upon the position and level of fluorination [34], l-(Difluoromethylene)cyclopropane is much like tetrafluoroethylene in its preference for [2+2] cycloaddition (equation 37), but Its 2,2-difluoro isomer favors [4+2] cycloadditions (equation 38). Perfluoromethylenecyclopropane is an exceptionally reactive dienophile but does not undergo [2+2] cycloadditions, possibly because of stenc reasons [34, 45] Cycloadditions involving most possible combinations of simple fluoroalkenes and alkenes or alkynes have been tried [85], but kinetic activation enthalpies (A/f j for only the dimerizations of tetrafluoroethylene (22 6-23 5 kcal/mol), chlorotri-fluoroethylene (23 6 kcal/mol), and perfluoropropene (31.6 kcal/mol) and the cycloaddition between chlorotnfluoroethylene and perfluoropropene (25.5 kcal/mol) have been determined accurately [97, 98] Some cycloadditions involving more functionalized alkenes are listed in Table 5 [99. 100, 101, 102, 103]... 

Similarly, partially fluorinated and perfluorinated methylenecyclopropanes [57, 52], cyclopropenes [55, 84, 55], cyclobutenes [75, 56], and bicychc alkenes [57, 55, 59, 90] apparently denve dienophilic reactivity from relief of their ground-state strain during reaction Thus 2,2-difluoromethylenecyclopropane and perfluoromethylenecyclopropane undergo exclusive [244] cycloadditions [57, 52] (equations 72 and 73), whereas (difluoromethylene)cyclopropane undergoes only [24-2] cycloadditions [57]... 

The types of cycloadditions discovered for enamines range through a regular sequence starting with divalent addition to form a cyclopropane ring, followed by 1,2 addition (i) of an alkene or an alkyne to form a cyclo-cyclobutane or a cyclobutene, then 1,3-dipolar addition with the enamine the dipolarophile 4), and finally a Diels-Alder type of reaction (5) with the enamine the dienophile. 

The similarity between the reactions of alkenes and cyclopropanes is further demonstrated by the reactions of electrophilic cyclopropanes and cyclopropenes with enamines. Cyclopropylcyanoester74, when treated with the pyrrolidine enamine of cyclohexanone, undergoes what would be a 1,2 cycloaddition in the analogous alkene case, but is actually a 1,3 cycloaddition here, to form adduct 75 (90). A similar reaction between the... 

In Corey and Chaykovsky s initial investigation, a cyclic ylide 79 was observed from the reaction of ethyl cinnamate with ylide 1 in addition to 32% of cyclopropane 53. In a similar fashion, an intermolecular cycloaddition between 2-acyl-3,3-bis(methylthio)acrylnitrile 80 and 1 furnished 1-methylthiabenzene 1-oxide 81. Similar cases are found in transformations of ynone 82 to 1-arylthiabenzene 1-oxide 83 and N-cyanoimidate 84 to adduct ylide 85, which was subsequently transformed to 1-methyl-lX -4-thiazin-l-oxide 86. ... 

Enantioselective [2+1] Cycloaddition Cyclopropanation with Zinc Carbenoids... 

Cyclopropane-fused chlorins derived from tetraphenylporphyrins can be prepared by the aforementioned carbene cycloaddition route, e.g. conjugative addition of nialonate to nickel(II) nitrotetraphenylporphyrin 14 (M = Ni) yields the cyclopropane-fused chlorin 15.22... 

Catalytic cyclopropanation of alkenes has been reported by the use of diazoalkanes and electron-rich olefins in the presence of catalytic amounts of pentacarbonyl(rj2-ris-cyclooctene)chromium [23a,b] (Scheme 6) and by treatment of conjugated ene-yne ketone derivatives with different alkyl- and donor-substituted alkenes in the presence of a catalytic amount of pentacarbon-ylchromium tetrahydrofuran complex [23c]. These [2S+1C] cycloaddition reactions catalysed by a Cr(0) complex proceed at room temperature and involve the formation of a non-heteroatom-stabilised carbene complex as intermediate. 

Stabilised sulphur ylides react with alkenylcarbene complexes to form a mixture of different products depending on the reaction conditions. However, at -40 °C the reaction results in the formation of almost equimolecular amounts of vinyl ethers and diastereomeric cyclopropane derivatives. These cyclopropane products are derived from a formal [2C+1S] cycloaddition reaction and the mechanism that explains its formation implies an initial 1,4-addition to form a zwitterionic intermediate followed by cyclisation. Oxidation of the formed complex renders the final products [30] (Scheme 8). 

Alkenylcarbene complexes react with in situ-generated iodomethyllithium or dibromomethyllithium, at low temperature, to produce cydopropylcarbene complexes in a formal [2C+1S] cycloaddition reaction. This reaction is highly diastereoselective and the use of chiral alkenylcarbene complexes derived from (-)-8-phenylmenthol has allowed the enantioselective synthesis of highly interesting 1,2-disubstituted and 1,2,3-trisubstituted cyclopropane derivatives [31] (Scheme 9). As in the precedent example, this reaction is supposed to proceed through an initial 1,4-addition of the corresponding halomethyllithium derivative to the alkenylcarbene complex, followed by a spontaneous y-elimi-nation of lithium halide to produce the final cydopropylcarbene complexes. 

Electronically rich 1,3-butadienes such as Danishefsky s diene react with chromium alkenylcarbene complexes affording seven-membered rings in a formal [4S+3C] cycloaddition process [73a, 95a]. It is important to remark on the role played by the metal in this reaction as the analogous tungsten carbene complexes lead to [4S+2C] cycloadducts (see Sect. 2.9.1.1). Formation of the seven-membered ring is explained by an initial cyclopropanation of the most electron-rich double bond of the diene followed by a Cope rearrangement of the formed divinylcyclopropane (Scheme 65). Amino-substituted 1,3-butadienes also react with chromium alkenylcarbene complexes to produce the corre-... 

---