Cyclopentene conversion

When using the cyclopentene as a starting cycloolefin, equilibrium stereo-content of cometathesis products is achieved at incomplete cyclopentene conversion. Equilibrium concentration of 1,6E-undecadiene is 86 % and of 1,6E,1 lE-hexadecatriene (the product of double insertion of cyclopentene into 1-hexene) - 87 %. At the same time, in the case of initial C7-C10 cycloolefins thermodynamically equilibrium values for corresponding 1,AE-dienes (A= 8-11) are 84 % and for corresponding 1,(8-11)E,( 15-21 )E-trienes are 78 % (Table 2). 

Runs Cyclopentene conversion, % mass Selectivity l,6Z-undecadiene % mass Stereoselectivity l,6Z-undecadiene %... 

Dienes in which a vinyl and alkyl group are cis undergo a reversible thermal rearrangement to the more thermodynamically stable isomer. 1,3-Dienes in which a vinyl and alkyl group are trans appear to be thermally stable.— E 3 - Isopropylidene - 2 - methylene -1 - methylcyclopentane injected into a gas chromatograph at an injection temp, of 360° 2-isopropenyl-l,5-dimethyl-l-cyclopentene. Conversion ca. 100%. F. e. s. J. Wolinsky, B. Ghollar, and M. D. Baird, Am. Soc. 8A, 2775 (1962). 

Dehydrogenation processes in particular have been studied, with conversions in most cases well beyond thermodynamic equihbrium Ethane to ethylene, propane to propylene, water-gas shirt reaction CO -I- H9O CO9 + H9, ethylbenzene to styrene, cyclohexane to benzene, and others. Some hydrogenations and oxidations also show improvement in yields in the presence of catalytic membranes, although it is not obvious why the yields should be better since no separation is involved hydrogenation of nitrobenzene to aniline, of cyclopentadiene to cyclopentene, of furfural to furfuryl alcohol, and so on oxidation of ethylene to acetaldehyde, of methanol to formaldehyde, and so on. 

An interesting probe of reactivity was presented by Burton in his study of cycloadditions of l,2-disubstituted-3,3,4,4-tetrafluorocyclobutenes and 1,2-disub-stituted-3,3,4,4,5,5-hexaf1uorocyclopentenes with butadiene, 2-methylbutadiene, and 2,3-dimethylbutadiene [86], On the basis of the extent of their conversions to adducts, the relative reactivities of the cyclobutenes and of the cyclopentenes are as shown in equation 74. A typical reaction is shown in equation 75. 

Dihydro-2/7- 74 and -4//-l,2-oxazines and thiazines 75 are interrelated by prototropy, being enamines and imines, respectively. In the case of oxazines, the imine form 75 is favored, and there are several well established examples of this system, including the parent heterocycle 75 (X = O) [84MI2]. No tautomeric equilibrium between the 2H and 4H forms has been observed under normal conditions in solution or in the solid state. However, the formation of intermediate 2H isomers 77 was proposed both for the conversion of 3-phenyl-5,6-dihydro-4//-l,2-oxazine 76 (R = Ph, r = R = H) into 2-phenylpyrrole(89TL3471) under strong basic conditions and for thermal decomposition of cyclopentene-fused 1,2-oxazine 76... 

A dry 5(X)-mI flask equipped with a thermometer, pressure-equalizing dropping funnel, and magnetic stirrer is flushed with nitrogen and then maintained under a static pressure of the gas. The flask is charged with 50 ml of tetrahydrofuran and 13.3 ml (0.15 mole) of cyclopentene, and then is cooled in an ice bath. Conversion to tricyclo-pentylborane is achieved by dropwise addition of 25 ml of a 1 M solution of diborane (0.15 mole of hydride see Chapter 4, Section 1 for preparation) in tetrahydrofuran. The solution is stirred for 1 hour at 25° and again cooled in an ice bath, and 25 ml of dry t-butyl alcohol is added, followed by 5.5 ml (0.05 mole) of ethyl bromoacetate. Potassium t-butoxide in /-butyl alcohol (50 ml of a 1 M solution) is added over a period of 10 minutes. There is an immediate precipitation of potassium bromide. The reaction mixture is filtered from the potassium bromide and distilled. Ethyl cyclopentylacetate, bp 101730 mm, 1.4398, is obtained in about 75% yield. Similarly, the reaction can be applied to a variety of olefins including 2-butene, cyclohexene, and norbornene. 

Cyclopentene-l,2-diol, 42, 51 2-Cyclopentene-1,4-dione, 42, 36 2-Cycloeentene-1-one, 42, 38 2-Cycloeentenone, 42,38 Cyclopropane, bromo-, 43, 9 Cyclopropanecarboxylic add, conversion to bromocyclopropane, 43, 9... 

Four members of the tetraponerine family (the major constituents of the contact poison of the New Guinean ant Tetraponera sp.) were prepared by RRM methods [156]. The key step leading to tetraponerine T7 (374) from the readily available cyclopentene precursor 372 is shown in Scheme 72. When compound 372 was exposed to catalyst A in the presence of ethylene, the desired ROM-RCM sequence proceeded smoothly to furnish heterocycle 373 with complete conversion, whereas the corresponding di-nosyl (2-nitrophenylsulfonyl)-protected analog of 372 led only to a 1 2 equilibrium mixture of starting material and RRM product. 

The gas chromatographic analysis of the unreacted monomers in the experiments from Table II discloses a constant C5/C8 ratio comparing the starting comonomer composition to the final composition. This means that monomer conversion is the same for 1,5-cyclooctadiene and cyclopentene in the copolymerization so that copolymer compositions are equal to the charge ratios. This result is consistent with the product analysis by 13C NMR spectroscopy where the copolymer composition is nearly identical to the starting comonomer composition. 13C NMR is used to determine the composition of the cyclopentene/1,5-cyclooctadiene copolymers as part of a detailed study of their microstructure (52). The areas of peaks at 29-30 ppm (the pp carbon from cyclopentene units) and at 27.5 ppm (the four ap carbons from the 1,5-cyclooctadiene) are used to obtain the mole fractions of the two comonomers (53, 54, 55). 13C NMR studies and copolymer composition determinations are described by Ivin (51, 56, 57) for various systems. 

In order to establish the correct absolute stereochemistry in cyclopentanoid 123 (Scheme 10.11), a chirality transfer strategy was employed with aldehyde 117, obtained from (S)-(-)-limonene (Scheme 10.11). A modified procedure for the conversion of (S)-(-)-limonene to cyclopentene 117 (58 % from limonene) was used [58], and aldehyde 117 was reduced with diisobutylaluminium hydride (DIBAL) (quant.) and alkylated to provide tributylstannane ether 118. This compound underwent a Still-Wittig rearrangement upon treatment with n-butyl lithium (n-BuLi) to yield 119 (75 %, two steps) [59]. The extent to which the chirality transfer was successful was deemed quantitative on the basis of conversion of alcohol 119 to its (+)-(9-methyI mande I ic acid ester and subsequent analysis of optical purity. The ozonolysis (70 %) of 119, protection of the free alcohol as the silyl ether (85 %), and reduction of the ketone with DIBAL (quant.) gave alcohol 120. Elimination of the alcohol in 120 with phosphorus oxychloride-pyridine... 

This hypothesis is supported by Chauvin s report (33) on a catalyst derived from (CO)5W=C(OEt)C4H9. This highly stable carbene-W(O) compound does not display catalytic activity for cyclopentene monomer. When mixed in the dark with TiCl4, a slow evolution of 1 equivalent of CO occurs. Subsequent thermal or photochemical activation produces ah extremely efficient catalyst system. Chauvin demonstrated that a high conversion to polypentenamer is obtainable at a W/cyclopentene ratio of 10 li at 5°C. The role of TiCI4 is not well understood nevertheless, it promotes carbonyl displacement which appears to be essential. 

Fig. 3. Effect of catalyst and conversion on microstructure for cyclopentene polymerizations (79, 80).

Table III presents additional cyclopentene polymerization data with 1-pentene as a regulator at 0°C throughout a wide range of conversion. As long as the cis selectivity is maintained, the regulator remains inactive and does not participate in the scrambling process.

Conversions of about 80% were obtained within a few minutes at 90°C. The polymer could also be cleaved by cross-metathesis with an excess of 4-octene which gave, as the main product, 9-tridecenyl-7-undecenoate, thus confirming the structure assignment as indicated in Eq. (62). The unsaturated lactone was also copolymerized with cyclooctene, 1,5-cy-clooctadiene, and cyclopentene under the previously stated conditions to afford linear copolymers which were high molecular weight, unsaturated, rubbery polyesters (110). 

The calculations indicate that only the most highly strained bridgehead olefins, specifically of the rrans-cyclopentene type, are candidates for a rearrangement to carbenes. Only at high temperature is there a chance for tams-cyclohexene analogues to undergo such a conversion. 

Volume 75 concludes with six procedures for the preparation of valuable building blocks. The first, 6,7-DIHYDROCYCLOPENTA-l,3-DIOXIN-5(4H)-ONE, serves as an effective /3-keto vinyl cation equivalent when subjected to reductive and alkylative 1,3-carbonyl transpositions. 3-CYCLOPENTENE-l-CARBOXYLIC ACID, the second procedure in this series, is prepared via the reaction of dimethyl malonate and cis-l,4-dichloro-2-butene, followed by hydrolysis and decarboxylation. The use of tetrahaloarenes as diaryne equivalents for the potential construction of molecular belts, collars, and strips is demonstrated with the preparation of anti- and syn-l,4,5,8-TETRAHYDROANTHRACENE 1,4 5,8-DIEPOXIDES. Also of potential interest to the organic materials community is 8,8-DICYANOHEPTAFULVENE, prepared by the condensation of cycloheptatrienylium tetrafluoroborate with bromomalononitrile. The preparation of 2-PHENYL-l-PYRROLINE, an important heterocycle for the synthesis of a variety of alkaloids and pyrroloisoquinoline antidepressants, illustrates the utility of the inexpensive N-vinylpyrrolidin-2-one as an effective 3-aminopropyl carbanion equivalent. The final preparation in Volume 75, cis-4a(S), 8a(R)-PERHYDRO-6(2H)-ISOQUINOLINONES, il lustrates the conversion of quinine via oxidative degradation to meroquinene esters that are subsequently cyclized to N-acylated cis-perhydroisoquinolones and as such represent attractive building blocks now readily available in the pool of chiral substrates. 

In 1982, it was reported that an aliphatic ketone, on exposure to dimethyl (diazometh-yl)phosphonate, is converted to the corresponding cyclopentene. c.g., the conversion of 2-methyl-5-nonanone to cyclopentencs 1 and 226. 

---