Cyclohexanones, addition

The asymmetric bromination of (3-dicarbonyl compounds was accomplished using a catalytic amount of a chiral primary amine catalyst, with pyridine dicarboxylic acid (PDA) as the co-catalyst and 3,3-dibromo-5,5-dimethylcyclo-hexa-l,3-dione as the bromine source (Scheme 13.25) [55]. The substrate scope was quite broad and included cyclic and acyclic (3-ketoesters, acycfic p-diketones, and the cyclic ketones cyclopentanone and cyclohexanone. Additionally, the conditions for chlorination of (3-dicarbonyl compounds using the benzoylquinidine catalyst depicted in Scheme 13.15 were adapted for the bromination of two substrates [35]. 

Apparently, the stereoselectivity of the cyclohexanone addition is a consequence of electronic effects. By NMR analysis the cyclohexane moiety is most likely trans to the fluorine on C-3. The 3 1 ratio of the two diastereomers indicates selectivity at position 2 in contrast to the work previously reported by Glaxo on the formation of ((2 S)-14 and (2 R)-14. 

While cyclohexanone addition afforded only two diastereomers are observed after cyclization, fluorine and proton NMR resonances attributable to more than two diastereoisomers. Possibly, epimerization of position four occurs during the acylation of the lactam nitrogen. The presence of fluorine on the adjacent carbon atom may make this hydrogen sufficiently acidic to be abstracted by triethylamine, in contrast to the original trinem. 

A solution of 0.21 mol of butyllithium in about 140 ml of hexane (note 1) was cooled below -40°C and 90 ml of dry THF ivere run in. Subsequently a cold (< -20 C) solution of 0.25 nol of propyne in 20 ml of dry THF was added with cooling below -20°C and a white precipitate was formed. A solution of 0.10 mol of anhydrous (note 2) lithium bromide in 30 ml of THF was added, followed by 0.20 mol of freshly distilled cyclopentanone or cyclohexanone, all at -30°C. The precipitate had disappeared almost completely after 20 min. The cooling bath was then removed and when the temperature had reached 0°C, the mixture was hydrolyzed by addition of 100 ml of a solution of 20 g of NHi,Cl in water. After shaking and separation of the layers four extractions with diethyl ether were carried out. The extracts were dried over magnesium sulfate and the solvents removed by evaporation in a water--pump vacuum. Careful distillation of the remaining liquids afforded the following... 

Synthetically useful stereoselective reductions have been possible with cyclic carbonyl compounds of rigid conformation. Reduction of substituted cyclohexanone and cyclopentan-one rings by hydrides of moderate activity, e.g. NaBH (J.-L. Luche, 1978), leads to alcohols via hydride addition to the less hindered side of the carbonyl group. Hydrides with bulky substituents 3IQ especially useful for such regio- and stereoselective reductions, e.g. lithium hydrotri-t-butoxyaluminate (C.H. Kuo, 1968) and lithium or potassium tri-sec-butylhydro-borates or hydrotri-sec-isoamylborates (=L-, K-, LS- and KS-Selectrides ) (H.C. Brown, 1972 B C.A. Brown, 1973 S. Krishnamurthy, 1976). 

DCHA is normally obtained in low yields as a coproduct of aniline hydrogenation. The proposed mechanism of secondary amine formation in either reductive amination of cyclohexanone or arene hydrogenation iHurninates specific steps (Fig. 1) on which catalyst, solvents, and additives moderating catalyst supports all have effects. 

Metallation of 2-picoline N-oxide [931-19-1] with butyUithium followed by addition of the elertrophilir cyclohexanone leads to two carbinol products (47) (4% (49) [34277-46-8] (50) [34277-59-3]). 

PUtzing erReaction. Quinoline-4-carboxyhc acids are easily prepared by the condensation of isatin [91-56-5] (16) with carbonyl compounds (50). The products may be decarboxylated to the corresponding quinolines. The reaction of isatin with cycHc ketones has been reported, eg, the addition of cyclohexanone gives the tricycHc intermediate (17) [38186-54-8] which upon oxidation produces quinoline-2,3,4-tricarboxyhc acid [16880-83-4] (51). 

Dutch State Mines (Stamicarbon). Vapor-phase, catalytic hydrogenation of phenol to cyclohexanone over palladium on alumina, Hcensed by Stamicarbon, the engineering subsidiary of DSM, gives a 95% yield at high conversion plus an additional 3% by dehydrogenation of coproduct cyclohexanol over a copper catalyst. Cyclohexane oxidation, an alternative route to cyclohexanone, is used in the United States and in Asia by DSM. A cyclohexane vapor-cloud explosion occurred in 1975 at a co-owned DSM plant in Flixborough, UK (12) the plant was rebuilt but later closed. In addition to the conventional Raschig process for hydroxylamine, DSM has developed a hydroxylamine phosphate—oxime (HPO) process for cyclohexanone oxime no by-product ammonium sulfate is produced. Catalytic ammonia oxidation is followed by absorption of NO in a buffered aqueous phosphoric acid... 

Cyclohexanone shows most of the typical reactions of aUphatic ketones. It reacts with hydroxjiamine, phenyUiydrazine, semicarbazide, Grignard reagents, hydrogen cyanide, sodium bisulfite, etc, to form the usual addition products, and it undergoes the various condensation reactions that are typical of ketones having cx-methylene groups. Reduction converts cyclohexanone to cyclohexanol or cyclohexane, and oxidation with nitric acid converts cyclohexanone almost quantitatively to adipic acid. 

Photolysis of pyridazine IV-oxide and alkylated pyridazine IV-oxides results in deoxygenation. When this is carried out in the presence of aromatic or methylated aromatic solvents or cyclohexane, the corresponding phenols, hydroxymethyl derivatives or cyclohexanol are formed in addition to pyridazines. In the presence of cyclohexene, cyclohexene oxide and cyclohexanone are generated. 

Also due to the high barrier of inversion, optically active oxaziridines are stable and were prepared repeatedly. To avoid additional centres of asymmetry in the molecule, symmetrical ketones were used as starting materials and converted to oxaziridines by optically active peroxyacids via their ketimines (69CC1086, 69JCS(C)2648). In optically active oxaziridines, made from benzophenone, cyclohexanone and adamantanone, the order of magnitude of the inversion barriers was determined by racemization experiments and was found to be identical with former results of NMR study. Inversion barriers of 128-132 kJ moF were found in the A-isopropyl compounds of the ketones mentioned inversion barriers of the A-t-butyl compounds lie markedly lower (104-110 kJ moF ). Thus, the A-t-butyloxaziridine derived from adamantanone loses half of its chirality within 2.3 days at 20 C (73JCS(P2)1575). 

Chloral forms well-crystallized adducts (126) with diaziridines containing at least one NH group (B-67MI50800). Carbonyl addition products to formaldehyde or cyclohexanone were also described. Mixtures of aldehydes and ammonia react with unsubstituted diaziridines with formation of a triazolidine ring (128). Fused diaziridines like (128) are always obtained in ring synthesis of diaziridines (127) from aldehyde, ammonia and chloramine. The existence of three stereoisomers of compounds (128) was demonstrated (76JOC3221). Diaziridines form Mannich bases with morpholine and formaldehyde (64JMC626), e.g. (129). 

Cyalohexylideneaaetonit ri-le. A 1-L three-necked, round-bottomed flask equipped with a reflux condenser, mechanical stirrer and addition funnel, is charged with potassium hydroxide (855 pellets, 33.0 g, 0.5 mol. Note 1) and acetonitrile (250 ml. Notes 2 and 3). The mixture is brought to reflux and a solution of cyclohexanone (49 g, 0.5 mol. Note 4) in acetonitrile (100 mL) is added over a period of 0.5-1.0 hr. Heating at reflux is continued for 2 hr (Note 5) after the addition is complete and the hot solution is then poured onto cracked ice (600 gl. The resulting binary mixture is separated... 

Cyclohexanone and benaaldehyde were purchased from either Aldrich Chemical Company, Inc., or Eastman Organic Chemicals and used without additional purification. 

Polyvinyl chloride [9002-81-2]. Ppted from cyclohexanone by addition of MeOH. 

The stereoselective reactions in Scheme 2.10 include one example that is completely stereoselective (entry 3), one that is highly stereoselective (entry 6), and others in which the stereoselectivity is modest to low (entries 1,2,4, 5, and 7). The addition of formic acid to norbomene (entry 3) produces only the exo ester. Reduction of 4-r-butylcyclohexanone (entry 6) is typical of the reduction of unhindered cyclohexanones in that the major diastereomer produced has an equatorial hydroxyl group. Certain other reducing agents, particularly sterically bulky ones, exhibit the opposite stereoselectivity and favor the formation of the diastereomer having an axial hydroxyl groi. The alkylation of 4-t-butylpiperidine with benzyl chloride (entry 7) provides only a slight excess of one diastereomer over the other. 

For cyclopentanone, cyclohexanone, and cycloheptanone, the K values for addition are 48, 1000, and 8 M , respectively. For aromatic aldehydes, the equilibria are affected by the electronic nature of the aryl substituent. Electron donors disfavor addition by stabilizing the aldehyde whereas electron-accepting substituents have the opposite effect. 

---