Cyanoacetic aldol condensations with

The decarboxylation of allyl /3-keto carboxylates generates 7r-allylpalladium enolates. Aldol condensation and Michael addition are typical reactions for metal enolates. Actually Pd enolates undergo intramolecular aldol condensation and Michael addition. When an aldehyde group is present in the allyl fi-keto ester 738, intramolecular aldol condensation takes place yielding the cyclic aldol 739 as a main product[463]. At the same time, the diketone 740 is formed as a minor product by /3-eIimination. This is Pd-catalyzed aldol condensation under neutral conditions. The reaction proceeds even in the presence of water, showing that the Pd enolate is not decomposed with water. The spiro-aldol 742 is obtained from 741. Allyl acetates with other EWGs such as allyl malonate, cyanoacetate 743, and sulfonylacetate undergo similar aldol-type cycliza-tions[464]. 

Alkali-exchanged mesoporous molecular sieves are suitable solid base catalysts for the conversion of bulky molecules which cannot access the pores of zeolites. For example, Na- and Cs-exchanged MCM-41 were active catalysts for the Knoevenagel condensation of benzaldehyde with ethyl cyanoacetate (pKa=10.7) but low conversions were observed with the less acidic diethyl malonate (pKa=13.3) [123]. Similarly, Na-MCM-41 catalyzed the aldol condensation of several bulky ketones with benzaldehyde, including the example depicted in Fig. 2.38, in which a flavonone is obtained by subsequent intramolecular Michael-type addition [123]. 

The catalytic activity of the NHs-grafted mesoporous silica, FSMN, was examined in some base-catalysed condensations (eqn. 1). The results were listed in Table 1. The FSMN catalyst used here was FSMN-5 that was prepared by the pre-activation at 1073 K followed by NH3-treatment at 973 K. The Aldol condensation of benzaldehyde and acetone did not proceed in this condition (entry 1). The Knoevenagel condensation of benzaldehyde and diethyl malonate (entry 2) did not occurred. On the other hand, the reactions with malononitrile (entry 3) and with ethyl cyanoacetate (entry 4) were catalysed by the FSMN-5. This shows that the NHa-grafted mesoporous silica would function as base catalyst. 

To decide whether disconnection (a) or (b) suggests a synthetically more convenient route, we consider the relative reactivities of single reactants. Benzaldehyde is more reactive with the acetonide anion than with enone TM 4.9b. Therefore, in the first step, aldol condensation is preferred, followed by Michael addition of enone to the carbanion of ethyl cyanoacetate. Consequently, retrosynthesis (b) suggests the preferred synthetic route to TM 4.9 (Scheme 4.30). 

Diamines grafted on MCM-41 revealed higher base catalytic activity because they were able to catalyse condensation between benzaldehyde and ethyl malonate which is usually less active than ethyl cyanoacetate. The catalytic activity was also high with less reactive carbonyl derivatives, such as cyclic or aliphatic ketones. Moreover, aldolization between acetone and aromatic aldehyde was also possible.11721... 

The COj species in the HT interlayer could be exchanged with OH ions by calcination at 723 K and hydration at room temperature. A spinel phase of Mg-Al mixed oxide obtained after the calcination transforms into the original layered structure during the hydration. This reconstruction is known as the memory effect of HT materials. The reconstructed HT catalyzed the Knoevenagel condensation of various aldehydes with nitriles in the presence of water [119]. The reconstracted HT also showed an aqueous Michael reaction of nitriles with a,p-unsaturated compounds. The layered double-hydroxide-supported diisopropylamine catalyzed the Knoevenagel condensation of aromatic carbonyl compounds with malononitrile or ethyl cyanoacetate [120]. This solid base could be recycled at least four times, and exhibited activity for aldol, Henry, Michael, transesterification, and epoxidation of alkenes. 

---