Cross-linking applications

CMC should be able to participate in the two-step reaction using a sulfo-NHS ester intermediate similar to EDC however, there are no reports in the literature to this effect. Protocols for the use of this reagent in biological cross-linking applications should be essentially the same as those given previously for EDC, except substituting a molar equivalent quantity of CMC. See Chapter 3, Sections 1.1 and 1.2 for additional information concerning carbodiimide reactions. 

The protocol for using GMBS or sulfo-GMBS in protein-protein cross-linking applications is similar to that of SMCC or sulfo-SMCC (see Section 1.3). 

Column Manufacturer Dimension [length x i.d.] (mm) Particle diameter (pm) Degree of cross-linking (%) Application... 

An important application of Eq. (3.39) is the evaluation of M, . Flory et al.t measured the tensile force required for 100% elongation of synthetic rubber with variable crosslinking at 25°C. The molecular weight of the un-cross-linked polymer was 225,000, its density was 0.92 g cm , and the average molecular weight of a repeat unit was 68. Use Eq. (3.39) to estimate M. for each of the following samples and compare the calculated value with that obtained from the known fraction of repeat units cross-linked ... 

The presence of the unsaturated substituent along this polyester backbone gives this polymer crosslinking possibilities through a secondary reaction of the double bond. These polymers are used in paints, varnishes, and lacquers, where the ultimate cross-linked product results from the oxidation of the double bond as the coating cures. A cross-linked polyester could also result from reaction (5.J) without the unsaturated carboxylic acid, but the latter would produce a gel in which the entire reaction mass solidified and is not as well suited to coatings applications as the polymer that crosslinks upon drying. ... 

In order to become useful dmg delivery devices, biodegradable polymers must be formable into desired shapes of appropriate size, have adequate dimensional stability and appropriate strength-loss characteristics, be completely biodegradable, and be sterilizahle (70). The polymers most often studied for biodegradable dmg delivery applications are carboxylic acid derivatives such as polyamides poly(a-hydroxy acids) such as poly(lactic acid) [26100-51-6] and poly(glycolic acid) [26124-68-5], cross-linked polyesters poly(orthoesters) poly anhydrides and poly(alkyl 2-cyanoacrylates). The relative stabiUty of hydrolytically labile linkages ia these polymers (70) is as follows ... 

Sephadex. Other carbohydrate matrices such as Sephadex (based on dextran) have more uniform particle sizes. Their advantages over the celluloses include faster and more reproducible flow rates and they can be used directly without removal of fines . Sephadex, which can also be obtained in a variety of ion-exchange forms (see Table 15) consists of beads of a cross-linked dextran gel which swells in water and aqueous salt solutions. The smaller the bead size, the higher the resolution that is possible but the slower the flow rate. Typical applications of Sephadex gels are the fractionation of mixtures of polypeptides, proteins, nucleic acids, polysaccharides and for desalting solutions. 

---