Copper, additivity principle

Andersen et al. predicted that similar results would be expected for the corrosion of other multivalent metals oxidizing via lower oxidation states. They also pointed out that their interpretation was consistent with the kinetics of the corrosion of copper in oxygenated HCl solutions. Here the final product is Cu and thus there is no vulnerable intermediate. In consequence, the rate of copper dissolution from either Nj-saturated or 02-saturated HCl solutions was the same at a given potential in conformity with the additivity principle. 

The underlying problem in testing the validity of the additivity principle in corrosion, mineral extraction, and electroless plating is that the electrode metal itself forms part of one of the half-reactions involved, e.g., zinc in equation (5) and copper in equations (8) and (12). A much better test system is provided by the interaction of two couples at an inert metal electrode that does not form a chemical part of either couple. A good example is the heterogeneous catalysis by platinum or a similar inert metal of the reaction... 

This approach uses a kinetic sequential principle to carry out multicomponent CL-based determinations. In fact, when the half-lives of the CL reactions involved in the determination of the analytes in mixture are appreciably different, the CL intensity-versus-time curve exhibits two peaks that are separate in time (in the case of a binary mixture) this allows both analytes to be directly determined from their corresponding calibration plots. In general, commercially available chemiluminometers have been used in these determinations, so the CL reaction was initially started by addition of one or two reaction ingredients. Thus, in the analysis of binary mixtures of cysteine and gluthatione, appropriate time-resolved response curves were obtained provided that equal volumes of peroxidase and luminol were mixed and saturated with oxygen and that copper(H) and aminothiol solutions were simultaneously injected [62, 63],... 

With this end in view, phenyldimcthylsilyl tri-n-butylstannane was added under the influence of zero-valent palladium compound with high regioselectivity and in excellent yield to the acetylene 386 to give the metallated olefin 387 (Scheme 56). The vinyl lithium carbanion 388 generated therefrom, was then converted by reaction with cerium(lll) chloride into an equilibrium mixture (1 1) of the cerium salts 389 and 390 respectively. However, the 1,2-addition of 389 to the caibonyl of 391, which in principle would have eventually led to ( )-pretazettine, did not occur due to steric reasons — instead, only deprotonation of 391 was observed. On the other hand, 390 did function as a suitable nucleophile to provide the olefinic product 392. Exposure of 392 to copper(II) triflate induced its transformation via the nine membered enol (Scheme 55) to the requisite C-silyl hydroindole 393. On treatment with tetrafluoroboric acid diethyl ether complex in dichloromethane, compound 393 suffered... 

The reaction is conveniently carried out in a, flask flitted with a drop funnel through which the water is slowly admitted. Some hydrogen peroxide is simultaneously produced. The evolution of oxygen is facilitated by the addition of a, catalyst., such as a salt of nickel, cobalt, or copper. When pressed into small blocks or cubes, the mixture of sodium peroxide and catalyst may be placed in a Kipp or other gasgenerating apparatus based on a similar principle, and a steady supply of oxygen obtained. The commercial commodity known as oxylithc has the following composition ... 

As indicated in Scheme VII/32, cyclononanone (VII/165) is transformed into hydroperoxide hemiacetal, VII/167, which is isolated as a mixture of stereoisomers. The addition of Fe(II)S04 to a solution of VII/167 in methanol saturated with Cu(OAc)2 gave ( )-recifeiolide (VII/171) in quantitative yield. No isomeric olefins were detected. In the first step of the proposed mechanism, an electron from Fe2+ is transferred to the peroxide to form the oxy radical VII/168. The central C,C-bond is weakened by antiperiplanar overlap with the lone pair on the ether oxygen. Cleavage of this bond leads to the secondary carbon radical VII/169, which yields, by an oxidative coupling with Cu(OAc)2, the alkyl copper intermediate VII/170. If we assume that the alkyl copper intermediate, VII/170, exists (a) as a (Z)-ester, stabilized by n (ether O) —> <7 (C=0) overlap (anomeric effect), and (b) is internally coordinated by the ester to form a pseudo-six-membered ring, then only one of the four -hydrogens is available for a syn-//-elimination. [111]. This reaction principle has been used in other macrolide syntheses, too [112] [113]. 

---