Coagulation contacts

Yaroshevskaya, N. V., V. R. Murav ev, and T. Z. Sotskova (1997). Effect of flocculants LT27 and 573C on the quality of water purification by contact coagulation. Khimiya i Tekhnologiya Vody. 19, 3, 308-314. 

When a continuous or interrupted waveform is used while the electrode is in direct contact with the tissue and the output voltage is too low to cause arcing, desiccation of the tissue occurs. Some ESUs have a distinct mode for this purpose called desiccation or contact coagulation. 

It is assumed that irreversible aggregation occurs on contact. The rate of coagulation is expressed as the aggregation flux J of particles towards a central particle. Using a steady-state approximation, the diffusive flux is derived to be... 

Fibers spun by this method may be isotropic or asymmetric, with dense or porous walls, depending on the dope composition. An isotropic porous membrane results from spinning solutions at the point of incipient gelation. The dope mixture comprises a polymer, a solvent, and a nonsolvent, which are spun into an evaporative column. Because of the rapid evaporation of the solvent component, the spinning dope solidifies almost immediately upon emergence from the spinneret in contact with the gas phase. The amount of time between the solution s exit from the spinneret and its entrance into the coagulation bath has been found to be a critical variable. Asymmetric fibers result from an inherently more compatible solvent/nonsolvent composition, ie, a composition containing lower nonsolvent concentrations. The nature of the exterior skin (dense or porous) of the fiber is also controlled by the dope composition. 

Sodium alumiaate is used ia the treatment of iadustrial and municipal water suppHes and the use of sodium alumiaate is approved ia the clarification of drinking water. The FDA approves the use of sodium alumiaate ia steam generation systems where the steam contacts food. One early use of sodium alumiaate was ia lime softening processes, where it iacreases the precipitation of ions contributing to hardness and improves suspended soHds removal from the treated water (17). Sodium alumiaate reacts with siHca to leave very low residual concentrations of siHca ia hot process water softeners. Sodium alumiaate is often used with other chemicals such as alum, ferric salts, clays, and polyelectrolytes, as a coagulant aid (18,19). 

Coagulation, i.e., the process by which discrete particles come in contact with each other in the air and remain joined together by surface forces, represents another way in which aerosol diameter will increase. However, it does not alter the mass of material in the coagulated particle. 

Coagulation The process of particulates sticking together on coming into contact, As the process continues, the particle size distribution becomes coarser and settles out. 

This is a dry sponge of human fibrin prepared by elotting a foam of human fibrinogen solution with human thrombin. It is then freeze-dried, cut into shapes and sterilized by dry heat at 130°C for 3 hours. Before use, it is saturated with thrombin solution. Blood coagulation occurs in contact with the thrombin in the interstices of the foam. 

It is well known that lyophilic sols are coagulated by the removal of a stabilizing hydration region. In this case, conversion of a sol to a gel occurs when bound cations destroy the hydration regions about the polyanion, and solvated ion-pairs are converted into contact ion-pairs. Desolvation depends on the degree of ionization, a, of the polyacid, and the nature of the cation. Ba ions form contact ion-pairs and precipitate PAA when a is low (0-25), whereas the strongly hydrated Mg + ion disrupts the hydration region only when a > 0-60. 

Here we consider aggregation in a physically realizable chaotic flow, the journal bearing flow or the vortex mixing flow described earlier. The computations mimic fast coagulation particles seeded in the flow are convected passively and aggregate upon contact. In this example the clusters retain a spherical structure and the capture radius is independent of the cluster size. 

The fluidity of blood is a result of the inhibition of a complex series of enzymic reactions in the coagulation cascade (see Fig. 10). When triggered either intrinsically (by contact with foreign surfaces ), or extrinsically (by tissue factors from damaged cells), inactive proenzymes (factors XII, XI, IX, and X) are transformed into activated pro-teinases (XHa, XIa, IXa, and Xa, respectively). Each proteinase catalyzes the activation of the following proenzyme in the sequence, up to formation of thrombin (Factor Ha), another proteinase that catalyzes partial... 

---