Construction Factors

The type of buildings and their construction. Factors can include, ventilation nites, resistance to blast effects, tlie ability of overhead fixtures to remain intact, etc. 

Condition C—Some equipment is used under operating conditions which do not reflect the advantage of the selection of sheaves by factors under conditions A or B. In such cases, sheave-diameter factors may be selected from Figure 4-76 and Table 4-34, As smaller factors are selected, the bending life of the wire rope is reduced and it becomes an increasingly important condition of rope service. Some conception of relative rope service with different rope constructions and/or different sheave sizes may be obtained by multiplying the ordinate found in Figure 4-76 by the proper construction factor indicated in Table 4-34. 

Before going further, we give below several examples illustrating how to construct factorized operators (60) for the simplest difference schemes. 

Table 2.4 gives typical materials of construction factors for shell-and-tube heat exchangers. 

Material of Construction Factor for Unit Ouerations Estimate... 

Singh, J., Christen, E. On-Farm and Community-Scale Salt Disposal Basins on the Riverine Plain Minimising the cost of basins siting design and construction factors. CRC for Catchment Hydrology, (2000)... 

The material of construction factor for stainless steel is given by ... 

Ftm is the materials of construction factor as a function of diameter (trays) ... 

Construction factor (ratio device and hydride weights)... 

Construction factor (ratio device and hydride weights) Heat conductance, (W m"2 K 1)... 

As with construction factors, repair materials should be chosen to match the particular needs of the situation. Most repair materials are either cement based or synthetic resin based. 

Constructive factors (e.g. cushions with even or curved middle layer, additional cables, quahty of welding seams and anchoring profiles). 

REVIEW OF ENGINEERING AND CONSTRUCTION FACTORS IN BUILDING A ZINC CELLHOUSE... 

Table 16.21 Materials of Construction Factors, for Centrifugal Pumps...

Table 16.26 Materials-of-Construction Factors, F, for Pressure Vessels...

In order to test the influence of the fabric construction parameters on valve behavior, different types of woven fabrics were then compared (Heim et al, 2005). The following parameters were varied (1) fabric weave construction (plain weave or satin), (2) fabric tightness, and (3) yarn specific surface area. The fabric tightness was calculated using the Russel construction factor (C) and is described in warp and weft directions by... 

---