Complex reactions basic routes

The monosubstituted vinylidene complexes are readily deprotonated with a variety of mild bases (e.g., MeO-, C032 ), and this reaction constitutes the most convenient route to ruthenium acetylide complexes. Experimentally the deprotonation is most easily achieved by passing the vinylidene complex through basic alumina. Addition of a noncomplexing acid (e.g., HPF6) to the acetylide results in the reformation of the vinylidene complex [Eq. (66)]. Reaction of 1 and terminal alkynes such as phenylacetylene in methanol followed by the addition of an excess of... 

Rate differences observed between the same bromophenylcarbene (241) when prepared by two different routes, diazirine photolysis and the reaction of benzylidene dibromide with potassium r-butoxide, vanish when a crown ether is added to the basic solution in the latter experiment. In this case the complexing potassium bromide is taken over by the crown ether, and selectivity towards alkenes reaches the values of the photolytic runs (74JA5632). 

Complexes 79 show several types of chemical reactions (87CCR229). Nucleophilic addition may proceed at the C2 and S atoms. In excess potassium cyanide, 79 (R = R = R" = R = H) forms mainly the allyl sulfide complex 82 (R = H, Nu = CN) (84JA2901). The reaction of sodium methylate, phenyl-, and 2-thienyllithium with 79 (R = R = r" = R = H) follows the same route. The fragment consisting of three coplanar carbon atoms is described as the allyl system over which the Tr-electron density is delocalized. The sulfur atom may participate in delocalization to some extent. Complex 82 (R = H, Nu = CN) may be proto-nated by hydrochloric acid to yield the product where the 2-cyanothiophene has been converted into 2,3-dihydro-2-cyanothiophene. The initial thiophene complex 79 (R = R = r" = R = H) reacts reversibly with tri-n-butylphosphine followed by the formation of 82 [R = H, Nu = P(n-Bu)3]. Less basic phosphines, such as methyldiphenylphosphine, add with much greater difficulty. The reaction of 79 (r2 = r3 = r4 = r5 = h) with the hydride anion [BH4, HFe(CO)4, HW(CO)J] followed by the formation of 82 (R = Nu, H) has also been studied in detail. When the hydride anion originates from HFe(CO)4, the process is complicated by the formation of side products 83 and 84. The 2-methylthiophene complex 79... 

The first reaction pathway for the in situ formation of a metal-carbene complex in an imidazolium ionic liquid is based on the well loiown, relatively high acidity of the H atom in the 2-position of the imidazolium ion [29]. This can be removed (by basic ligands of the metal complex, for example) to form a metal-carbene complex (see Scheme 5.2-2, route a)). Xiao and co-workers demonstrated that a Pd imida-zolylidene complex was formed when Pd(OAc)2 was heated in the presence of [BMIMjBr [30]. The isolated Pd carbene complex was found to be active and stable in Heck coupling reactions (for more details see Section 5.2.4.4). Welton et al. were later able to characterize an isolated Pd-carbene complex obtained in this way by X-ray spectroscopy [31]. The reaction pathway to the complex is displayed in Scheme 5.2-3. 

The most convenient route to organometallic technetium complexes is directly from 3, under reaction conditions which allow working in a normal laboratory. There are basically three essential compounds that fulfil these conditions and can be prepared in a one step synthesis starting from 3, and which are convenient precursors for subsequent chemistry due to their reactivity (Scheme 1). 

Obviously, in such cases the CD is acting as a true catalyst in esterolysis. The basic cleavage of trifluoroethyl p-nitrobenzoate by a-CD occurs by both pathways approximately 20% by nucleophilic attack and approximately 80% by general base catalysis (GBC) (Komiyama and Inoue, 1980c). The two processes are discernible because only the former leads to the observable p-nitrobenzoyl-CD. For the ester, Ks = 3.4 mM and kjka = 4.4 for the GBC route (1.25 for the nucleophilic route), and so KTS = 0.77 mM. For reaction within the ester CD complex [28], it was estimated that the effective molarity of the CD hydroxyl anion was 21-210 m (for Br0nsted /3 = 0.4 to 0.6 for GBC). Such values are quite reasonable for intramolecular general base catalysis (Kirby, 1980). 

None of these difficulties arise when hydrosilylation is promoted by metal catalysts. The mechanism of the addition of silicon-hydrogen bond across carbon-carbon multiple bonds proposed by Chalk and Harrod408,409 includes two basic steps the oxidative addition of hydrosilane to the metal center and the cis insertion of the metal-bound alkene into the metal-hydrogen bond to form an alkylmetal complex (Scheme 6.7). Interaction with another alkene molecule induces the formation of the carbon-silicon bond (route a). This rate-determining reductive elimination completes the catalytic cycle. The addition proceeds with retention of configuration.410 An alternative mechanism, the insertion of alkene into the metal-silicon bond (route b), was later suggested to account for some side reactions (alkene reduction, vinyl substitution).411-414... 

These and other venerable synthetic routes to the tricyclic oxazines and thiazines have been reviewed in detail (B-78MI22701). 2-Hydroxy(or mercapto)-2, 4 -dinitrodiphenylamines readily cyclize to phenoxazines (or phenothiazines) in basic media through elimination of nitrous acid. This is the so-called Turpin reaction, which is complicated by the fact that the intermediate Meisenheimer complexes (251) may undergo a Smiles-type rearrangement so that mixtures of isomeric products are obtained (Scheme 112). 

---