Complex formation analysis

Masking agent — An auxiliary - ligand that is added to a sample in order to avoid unwanted interference of a metal ion in a complex formation analysis. A suitable masking agent has to react selectively and form a sufficiently stable complex with the interfering component so that its reaction with the ligand used as - titrant is prevented [i]. 

The main idea of research is application of accessible, simple and express methods that don t need expensive reagent techniques for analysis of phanuaceutical products based on bischofite. The determination of metal ions such as Mg, Zn, Cu, Fe by complex-formation titrations using a widely applicable chelating agent, EDTA, have been studied as a function of pH, complexing agents and indicators. The analysis consists of four parts ... 

Ethylenediaminetetra-acetic acid, largely as the disodium salt of EDTA, is a very important reagent for complex formation titrations and has become one of the most important reagents used in titrimetric analysis. Equivalence point detection by the use of metal-ion indicators has greatly enhanced its value in titrimetry. 

Complex formation, selective precipitation, and control of the pH of a solution all play important roles in the qualitative analysis of the ions present in aqueous solutions. There are many different schemes of analysis, but they follow the same general principles. Let s think through a simple procedure for the identification of five cations by following the steps that might be used in the laboratory. We shall see how each step makes use of solubility equilibria. 

Qualitative analysis involves the separation and identification of ions by selective precipitation, complex formation, and the control of pH. 

Co (I I) complex formation is the essential part of copper wet analysis. The latter involves several chemical unit operations. In a concrete example, eight such operations were combined - two-phase formation, mixing, chelating reaction, solvent extraction, phase separation, three-phase formation, decomposition of co-existing metal chelates and removal of these chelates and reagents [28]. Accordingly, Co (I I) complex formation serves as a test reaction to perform multiple unit operations on one chip, i.e. as a chemical investigation to validate the Lab-on-a-Chip concept. 

The saturation of the SHG response at high cation concentrations suggests that the process of complex formation at the membrane surface may be treated by a Langmuir-isotherm type analysis [24,27]. At constant temperature, the Langmuir equation is given by... 

The possibility of the existence of short-lived reactive resonances has been discussed often over the years. The early advances in this field were largely theoretical and based on the analysis of quantum reaction dynamics using approximate PESs.5-10 These studies provided much insight into the dynamical origin of complex formation. However, they were speculative... 

The analysis is performed for the calculations with rrot=0 K for the CH3C1 reactant, so that the angular momentum distribution for the complex P(j) is the distribution of orbital angular momentum for complex formation P(i). This latter distribution is given in ref. 37. Jm , the quantum number for j, varies from 282 for Enl = 0.5 kcal/mol to 357 for rel = 3.0 kcal/mol. The term k iEJ) in equation 24 is written as k (.EJ)=k Ejyf E), where k EJ) is the classical RRKM rate constant with the CH3C1 intramolecular modes inactive and / ( ) is treated as a fitting factor. 

Special care has to be taken if the polymer is only soluble in a solvent mixture or if a certain property, e.g., a definite value of the second virial coefficient, needs to be adjusted by adding another solvent. In this case the analysis is complicated due to the different refractive indices of the solvent components [32]. In case of a binary solvent mixture we find, that formally Equation (42) is still valid. The refractive index increment needs to be replaced by an increment accounting for a complex formation of the polymer and the solvent mixture, when one of the solvents adsorbs preferentially on the polymer. Instead of measuring the true molar mass Mw the apparent molar mass Mapp is measured. How large the difference is depends on the difference between the refractive index increments ([dn/dc) — (dn/dc)A>0. (dn/dc)fl is the increment determined in the mixed solvents in osmotic equilibrium, while (dn/dc)A0 is determined for infinite dilution of the polymer in solvent A. For clarity we omitted the fixed parameters such as temperature, T, and pressure, p. 

Hassan et al [65] used a method for the determination of primaquine and other antimalarials, through ternary complex formation. The analytical aspects of the reaction between the widely used antimalarial drugs with cobalt and thiocyanate to form ternary complexes are described. Alternatively, determination of the cobalt content of the nitrobenzene extract using atomic absorption spectroscopy provided an indirect method for the determination of the drugs. Both methods are applied to the analysis of pharmaceutical preparation and the results obtained agreed well with those obtained with official methods. 

In order to co clarify the role of complex formation, the new data on stability constants should be accumulated, being collected at strictly similar conditions. It should be also mentioned that any analysis of equilibrium in solutions involving anions of polybasic hydroxy carboxylic acids requires the data on the deprotonation constants of the acid in question. This information would be crucial for conclusions regarding the presence and stability of mixed complexes in the system. Valuable knowledge about the structure of complex compounds present in solutions (and in precursors as well, see later) may be gained by means of vibrational spectroscopy (IR and Raman spectra) and nuclear magnetic resonance. 

---