Compatibilizer matrix

Strong elongational deformation and use of matrix polymers whose viscosity is higher than that of TLCP phase are better to ensure uniform and fine fibril formation. But application of compatibilizing techniques to in situ composite preparation can be useful to get the most desirable products. These can reduce the high costs of the liquid crystalline polymers and expensive special engineering plastics used for the in situ composite preparation and reduce the processing cost, whereas they can increase the performance of produced in situ composites, hence, their applications, too. 

PBAs are designed explicitly to meet the needs of specific applications on the basis of their property-processing-cost performances. One polymer is incorporated into the matrix of other polymers to impart specific characteristics as per the requirement along with the appropriate compatibilizer to ensure stress transfer in between phases. The polymer blend constituents and composition must, therefore, be selected on the basis of the compensation of properties, considering the advantages and disadvantages associated with each phase. Table 12 indicates some of the components used as modifiers. 

Compatibilizer Solubility with Solubility with matrix B ... 

Since most polymers, including elastomers, are immiscible with each other, their blends undergo phase separation with poor adhesion between the matrix and dispersed phase. The properties of such blends are often poorer than the individual components. At the same time, it is often desired to combine the process and performance characteristics of two or more polymers, to develop industrially useful products. This is accomplished by compatibilizing the blend, either by adding a third component, called compatibilizer, or by chemically or mechanically enhancing the interaction of the two-component polymers. The ultimate objective is to develop a morphology that will allow smooth stress transfer from one phase to the other and allow the product to resist failure under multiple stresses. In case of elastomer blends, compatibilization is especially useful to aid uniform distribution of fillers, curatives, and plasticizers to obtain a morphologically and mechanically sound product. Compatibilization of elastomeric blends is accomplished in two ways, mechanically and chemically. 

In order to obtain a finely sized dispersed phase in the PET matrix, the use of reactive compatibilization has been found to be important. Small dispersed rubber particles and a small interparticle distance are necessary to induce high toughness. For effective rubber toughening of PET, it is important that the rubber domains be less than 3 im in diameter (and preferably less than 1 xm) and that the interparticle distance be between 50-300 nm. 

Well-dispersed and long-term stable carbon nanotubes/polyol dispersions can also be prepared by a mechanochemical approach with the aid of a dispersing agent (Tang and Xu, 1999). Good dispersion of CNTs in polymer matrix can be achieved by means of high-power dispersion, compatibilizer, polymer-assisted blending, and surfactants (Cochet et al., 2001). 

---