Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Classifications of products

Continual check on efficiency of protection treatment in emergencies Classification of product under I.C.C. regulations... [Pg.225]

To develop standards for classification of products, components and elements of construction, appropriate to the fire risks related to their application. [Pg.492]

The classification of products should be achieved by small scale tests which have been validated by large scale tests /8,9/. In special cases, when relevant information cannot be obtained in small scale, a standardized large scale test, i.e. the Room/Corner... [Pg.494]

Solution crystallisers are usually classified according to the method by which supersaturation is achieved, that is by cooling, evaporation, vacuum, reaction and salting out. The term controlled denotes supersaturation control whilst classifying refers to classification of product size. [Pg.853]

Article 8 Classification of products by therapeutic class for inclusion or exclusion... [Pg.533]

In this part of the paper, development of processes is summarized on the following simple classification of products ... [Pg.154]

Tariff rates are set on a product/product category level. The classification of products is in many countries based on a harmonized customs nomenclature and a nominal tariff is set for each product category. Tariff structures however often contain temporary or permanent exceptions, preferential rates for less developed countries, etc. Therefore, one has to distinguish between the nominal tariff and the tariff actually applied. [Pg.203]

Some medicines may have more than one classification in the First Schedule, depending upon the strength, pack size or route of administration of the medicine. The First Schedule also lists group classifications of products (e.g., anorexiants, injectable medicines). [Pg.393]

The classification of product leaving the mill depends on a balance between centrifugal forces and drag forces in the flow field around the mill outlet. Mill types A and C create a free vortex at the outlet, while jet mill D makes use of gravity. Type B has an integrated rotor. The final product quality is largely determined by the success of classification. [Pg.2303]

As a consequence of its recent development the petrochemical industry is relatively much younger than the major inorganic chemicals industry. However, one can easily be misled by the classification of products that are termed petrochemical . Basically a petrochemical is derived directly or indirectly from a petroleum or natural gas fraction. It may be organic, such as ethylene, benzene, or formaldehyde, or it may be inorganic, such as ammonia, nitric acid, and ammonium nitrate (Chap. 11). So a petrochemical is not synonymous with an organic chemical, although most petrochemicals are also organic chemicals. [Pg.637]

The classification of products of Chapter 5 designating products as commodities, pseudo-commodities, fine chemicals, and specialty chemicals provides... [Pg.279]

The book is divided into six volumes, based strictly on the type of formulation science involved in the development of these dosage forms sterile products, compressed solids, uncompressed solids, liquid products, semisolid products, and over-the-counter (OTC) products. The separation of OTC products, though they may easily fall into one of the other five categories, is made to comply with the industry norms of separate research divisions for OTC products. Sterile products require skills related to sterilization of product, and of less importance is the bioavailability issue, which is an inherent problem of compressed dosage forms. These types of considerations have led to the classification of products into these six categories. [Pg.273]

Table I. Classification of Products Processed from Apples. Table I. Classification of Products Processed from Apples.
The types of reactions presented above can be combined with the ordinary classification of production processes in convergent, divergent, and transformation processes. Depending on the number of input and output products this process classification can be enhanced as Table 2.1 shows. [Pg.8]

While the products can perhaps be classified accurately as dogs or runners at the end of the season, the buyers classification of product category is often imperfect at the start of the season. Thus, for example, if a buyer classified a product as a dog at the start of the season, there may be an 80% probability that the item ended up being a dog and a 20% probability that the product ended up being a runner. Similarly, if a buyer classified an item as a runner at the start of the season, there may be a 65% probability that the item ended up as a runner and as a dog, 35%. [Pg.103]

How can the approaches described earlier be improved if there is access to more current data regarding season demands One approach is to use Bayesian updating ([35]) to improve demand forecasts. To understand this approach, consider the classification of products and their associated actual demand distribution as in the example in the previous section. Before discussing details of the approach, consider how collected data can be used to project season demand for a product. [Pg.105]

As regards the classification of products it was proposed that products be classified as regards similar medical need as opposed to functional equivalence. [Pg.528]

Common Causes of Work Injuries and Classifications of Product Hazards... [Pg.33]

The mles of classification of products, especially European products, suffer from a certain degree of interpretation that has allowed, in some cases (more or less in good faith), the classification as an MD a product that actually matches the definition of drug. [Pg.110]

For the plant constructors, the benefit of the population balance is mainly derived from the transparency of the interplay of the kinetic variables of nucleation rate and crystal growth rate, the mean retention time, the fines dissolving, and the classification of product crystals during withdrawal with respect to the resulting mean particle size of the crystallization process. Here, reference is made to the publications, such as that of Toyokura and Sakai [12]. [Pg.225]

The fact that the population balance is clearly able to determine the influences on particle size distribution is shown, for example, by the effects produced by the fines dissolution and the classification of product during withdrawal. [Pg.225]


See other pages where Classifications of products is mentioned: [Pg.20]    [Pg.13]    [Pg.806]    [Pg.615]    [Pg.23]    [Pg.84]    [Pg.817]    [Pg.786]    [Pg.803]    [Pg.37]    [Pg.728]    [Pg.598]    [Pg.802]    [Pg.672]    [Pg.80]    [Pg.240]    [Pg.610]    [Pg.409]    [Pg.409]    [Pg.89]    [Pg.333]    [Pg.63]    [Pg.63]    [Pg.254]   
See also in sourсe #XX -- [ Pg.20 ]




SEARCH



Product classification

Productivity classification

© 2024 chempedia.info