Chromium General

The primary leachable hazardous constituents of EAF emission control dust/sludge are lead, cadmium, and hexavalent chromium. Generally, 20 to 40 lb of EAF dust per ton of steel are generated, depending on the mill s specific operating practices, with an average of about 35 lb/t of steel melted.1 Table 2.11 shows the typical ranges of concentration of each of these elements in EAF dust. 

Cr chromium chromium (general) Cr2+, chromium(2+) Cr3+, chromium(3+) chromide chromido... 

The general population is exposed to chromate by eating food, drinking water and inhaling air that contains the chemical. The average daily intake of chromium, generally in the form of Cr(III), from air, water, and food is estimated to be less than 0.2 to 0.4 micrograms (pg) from air, 2.0 pg from water, and 60 pg from food, respectively. ... 

The sensitivity test on nickel-chromium test blocks show that products which give bad results to over washing tests generally do not give good results to sensitivity tests. 

We shall describe a specific synthetic example for each protective group given above. Regiosdective proteaion is generally only possible if there are hydroxyl groups of different sterical hindrance (prim < sec < tert equatorial < axial). Acetylation has usually been effected with acetic anhydride. The acetylation of less reactive hydroxyl groups is catalyzed by DMAP (see p.l44f.). Acetates are stable toward oxidation with chromium trioxide in pyridine and have been used, for example, for protection of steroids (H.J.E. Loewenthal, 1959), carbohydrates (M.L. Wolfrom, 1963 J.M. Williams, 1967), and nucleosides (A.M. Micbelson, 1963). The most common deacetylation procedures are ammonolysis with NH in CH OH and methanolysis with KjCO, or sodium methoxide. 

Plain Carbon and Low Alloy Steels. For the purposes herein plain carbon and low alloy steels include those containing up to 10% chromium and 1.5% molybdenum, plus small amounts of other alloying elements. These steels are generally cheaper and easier to fabricate than the more highly alloyed steels, and are the most widely used class of alloys within their serviceable temperature range. Figure 7 shows relaxation strengths of these steels and some nickel-base alloys at elevated temperatures (34). 

Coatings, Paints, and Pigments. Various slightly soluble molybdates, such as those of zinc, calcium, and strontium, provide long-term corrosion control as undercoatings on ferrous metals (90—92). The mechanism of action presumably involves the slow release of molybdate ion, which forms an insoluble ferric molybdate protective layer. This layer is insoluble in neutral or basic solution. A primary impetus for the use of molybdenum, generally in place of chromium, is the lower toxicity of the molybdenum compound. 

---