Chloroform temperature

The IR absorption spectra of Fe (T"PrPc)N3 in chloroform. Temperature decreases from 295 to 254, and then to 216 K as indicated by the arrow. (Reproduced from Ref. 75 with permission of Wiley.)... 

Morcom, K. W. Travers, D. N. Heat of mixing of the system acetone + chloroform. Temperature dependence and deiterium isotope effect Trans. Faraday Soc. 1965,61, 230-234... 

Solid carbon dioxide (Dry Ice, Drikold) is employed when very low temperatures are required. If it is suspended in solvents, such as alcohol or a mixture of equal volumes of chloroform and carbon tetrachloride, temperatures down to — 50° can be easily attained. Lower temperatures still are reached if intimate mixtures of solid carbon dioxide and organic solvents are employed with ethyl alcohol, — 72° with... 

Mix 100 g. of maleic acid (Section 111,143) and 100 ml. of tetra chloroethane in a 250 ml. Claisen or distilling flask provided with a thermometer, and attach a Pyrex Liebig condenser. Heat the flask in an air bath (Fig. 11, 5, 3) and collect the distillate in a measuring cylinder. When the temperature reaches 160°, 76 ml. of tetrachloroethane and 15-15-5 ml. of water are present in the receiver. Empty the water in the condenser and continue the distillation change the receiver when the temperature reaches 190°. Collect the maleic anhydride at 195-197°. Recrystallise the crude anhydride from chloroform. The yield of pure maleic anhydride, m.p. 54°, is 70 g. 

A. Maleic acid. Assemble the apparatus shown in Fig. Ill, 28, 1. Place 45 g. of dry mahc acid in the 200-250 ml. distilling flask and cautiously add 63 g. (57 ml.) of pure acetyl chloride. Warm the flask gently on a water bath to start the reaction, which then proceeds exothermically. Hydrogen chloride is evolved and the malic acid passes into solution. When the evolution of gas subsides, heat the flask on a water bath for 1-2 hours. Rearrange the apparatus and distil. A fraction of low boiling point passes over first and the temperature rises rapidly to 190° at this point run out the water from the condenser. Continue the distillation and collect the maleic anhydride at 195-200°. Recrystallise the crude maleic anhydride from chloroform (compare Section 111,93) 22 g. of pure maleic anhydride, m.p. 54°, are obtained. 

Dissolve 1 0 g. of the compound in 5 ml. of dry chloroform in a dry test-tuhe, cool to 0°, and add dropwise 5g. (2-8 ml.) of redistilled chloro-sulphonic acid. When the evolution of hydrogen chloride subsides, allow the reaction mixture to stand at room temperature for 20 minutes. Pour the contents of the test-tube cautiously on to 25 g. of crushed ice contained in a small beaker. Separate the chloroform layer and wash it with a httle cold water. Add the chloroform layer, with stirring, to 10 ml. of concentrated ammonia solution. After 10 minutes, evaporate the chloroform on a water bath, cool the residue and treat it with 5 ml. of 10 per cent, sodium hydroxide solution the sulphonamide dissolves as the sodium derivative, RO.CgH4.SO,NHNa. Filter the solution to remove any insoluble matter (sulphone, etc.), acidify the filtrate with dilute hydrochloric acid, and cool in ice water. Collect the sulphonamide and recrystallise it from dilute alcohol. 

If preferred, the chloroform may be added slowly during 30-40 minutaa whilat the mixture is stirred and the temperature is maintained at 65-70°. 

To obtain crystalline perbenzoic acid, dry the moist chloroform solution with a little anhydrous sodium or magnesium sulphate for an hour, filter, and wash the desiccant with a little dry chloroform. Remove the chloroform under reduced pressure at the ordinary temperature whilst carbon dioxide is introduced through a capillary tube. Dry the white or pale yellow residue for several hours at 30-35° under 10 mm. pressure. The yield of crystalline perbenzoic acid, m.p. about 42°, which is contaminated with a little benzoic acid, is 22 g. It is moderately stable when kept in the dark in a cold place it is very soluble in chloroform, ethyl acetate and ether, but only shghtly soluble in cold water and in cold hght petroleum. 

The number of ethylenic linkages In a given compound can be established with accuracy by quantitative titration with perbenzoic acid. A solution of the substance ajid excess of perbenzoic acid in chloroform is allowed to stand for several hours at a low temperature and the amount of unreacted perbenzoic acid in solution is determined a blank experiment is run simultaneously. 

Dinitroaniline from 3 5-dinItrobenzoic acid. Place a solution of 50 g. of 3 5-dinitrobenzoic acid (Section IV, 168) in 90 ml. of 10 per cent, oleum and 20 ml. of concentrated sulphuric acid in a 1-litre three necked flask equipped with a reflux condenser, mechanical stirrer, adropping funnel, and thermometer (FUME CUPBOARD ). Add 100 ml. of clJoroform and raise the temperature to 45°. Stir rapidly and add 17 -5g. of sodium azide in small portions whilst maintaining the temperature at 35-45°. The reaction is accompanied hy foaming, which usually commences after about 3 g. of sodium azide has been introduced. After all the sodium azide has been added raise the temperature so that the chloroform refluxes vigorously and maintain this temperature for 3 hours. Then cool the reaction mixture, pour it cautiously on to 500 g. of crushed ice, and dilute with 3 litres of water. After 1 hour, separate the yellow solid by filtration at the pump, wash well with water and dry at 100°. The yield of 3 5-dinitroaniline, m.p. 162-163°, is 39 g. The m.p. is unaffected by recrystallisation from dilute alcohol. 

Iodine is a bluish-black, lustrous solid, volatizing at ordinary temperatures into a blue-violet gas with an irritating odor it forms compounds with many elements, but is less active than the other halogens, which displace it from iodides. Iodine exhibits some metallic-like properties. It dissolves readily in chloroform, carbon tetrachloride, or carbon disulfide to form beautiful purple solutions. It is only slightly soluble in water. 

It s obvious when the chloroform has finished coming over. If you re using heat with out vacuum the temperature will start to rise so make sure you stop before it gets too hot. If you are using vacuum it s time to stop anyway. 

A mixture of 100 ml of water and 0.10 mol of methylthioallene (see Chapter IV, Exp. 23) was placed in the flask and 24 g of sodium periodate were added in five portions at intervals of 4 min. The mixture was agitated vigorously and the temperature was kept between 25 and 30°C by occasional cooling. After 1 h twenty extractions with 10-ml portions of chloroform were carried out. The combined extracts were dried (without previous washing) over magnesium sulfate. Removal of the chloroform by evaporation in a water-pump vacuum gave the reasonably pure (> 9i%) le... 

Phenyl-3-oxopropanoic acid (25 mmol) and EtjN (87.5 mmol) were dissolved in THF (150 ml) and cooled to —40°C. Ethyl chloroformate (27.5 mmol) was added dropwise to this solution and then the reaction mixture was stirred for 30 min at —20°C. Di-n-hexylamine (27.5 mmol) was added to the suspension and it was stirred at room temperature for an additional hour. The reaction mixture was diluted with water (100 ml) and extracted with ether (400 ml). The extract was washed with aq. 5% HCl (100 ml) and brine (2 X 100 ml) and dried over NajSO. The crude amide was obtained by removal of the solvent in vacuo and phenylhydrazine (25 mmol) was added. The mixture was heated to 100°C for 30 min. The residue was held in vacuo to remove the water formed and then powdered ZnCl2 (125 mmol) was added. The mixture was heated at 170"C with manual stirring for 5 min. The cooled residue was dissolved in acetone (100 ml) and diluted with ether (500 ml). Water (100 ml) was added. The organic layer was separated and washed successively with 5% aq. HCl (100 ml) and brine (2 x 100 ml) and dried over NajSO. The solvent was removed in vacuo, and the residue was recrystallized from EtOAc-hexane. The yield was 79%. 

The first identified complexes of unsubstituted thiazole were described by Erlenmeyer and Schmid (461) they were obtained by dissolution in absolute alcohol of both thiazole and an anhydrous cobalt(II) salt (Table 1-62). Heating the a-CoCri 2Th complex in chloroform gives the 0 isomer, which on standirtg at room temperature reverses back to the a form. According to Hant2sch (462), these isomers correspond to a cis-trans isomerism. Several complexes of 2,2 -(183) and 4,4 -dithiazolyl (184) were also prepared and found similar to pyridyl analogs (185) (Table 1-63). Zn(II), Fe(II), Co(II), Ni(II) and Cu(II) chelates of 2.4-/>is(2-pyridyl)thiazole (186) and (2-pyridylamino)-4-(2-pyridy])thiazole (187) have been investigated. The formation constants for species MLr, and ML -" (L = 186 or 187) have been calculated from data obtained by potentiometric, spectrophotometric, and partition techniques. 

The products of these reactions are called vicinal dihalides Two substituents m this case the halogens are vicinal if they are attached to adjacent carbons The word is derived from the Latin vicinalis which means neighboring The halogen is either chlorine (CI2) or bromine (Br2) and addition takes place rapidly at room temperature and below m a variety of solvents mcludmg acetic acid carbon tetrachloride chloroform and dichloromethane... 

Ben2onitri1e [100-47-0] C H CN, is a colorless Hquid with a characteristic almondlike odor. Its physical properties are Hsted in Table 10. It is miscible with acetone, ben2ene, chloroform, ethyl acetate, ethylene chloride, and other common organic solvents but is immiscible with water at ambient temperatures and soluble to ca 1 wt% at 100°C. It distills at atmospheric pressure without decomposition, but slowly discolors in the presence of light. 

Hydroquinone can be deterrnined spectrophotometricaHy at 292 nm in methanol after a sample is evaporated to dryness to remove the interference of acrolein. An alternative method is high performance Hquid chromatography on 10-p.m LiChrosorb RP-2 at ambient temperature with 2.0 mL/min of 20%(v/v) 2,2,4-trimethylpentane, 79.20% chloroform, and 0.80 % methanol with uv detection at 292 nm. 

---